Search NASA⌕ Search

Engineering topics

A M Brandis

Publications and source records attributed to A M Brandis.

5 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2020

Updated Stagnation-Point Aeroheating Correlations for Mars Entry

The objective of this work was to develop new stagnation-point aeroheating engineering correlations for Mars entry vehicles. New convective and radiative heating relations were formulated over a wide range of entry conditions. These relations were based on computational fluid dynamics simulations informed by recent experimental testing and modeling enhancements. For convective heating, a relation similar to the Sutton-Graves relation was developed that is accurate to within ±25% across the domain of relevant Mars entry conditions. For radiative heating, two different functional forms were developed: exponential and polynomial relations. Each of these relation, which represents two different levels of complexity for implementation, were able to predict the radiative heating within about ±25%. The correlations were tested by applying them to the Mars Pathfinder entry trajectory to demonstrate their applicability. These new correlations are significant improvement over existing relations in terms of the accuracy, domain of applicability, and the captured physics, including CO2 inferred radiation and thermochemical nonequilibrium.

Thomas K West, IV↗
NASA NTRSDate not supplied

Instrumentation for Measuring Entry Radiative Heating - Past, Present, and Future

Radiative heating can be a significant contributor to the total heat load during atmospheric entry, especially for large vehicles with high entry velocties. For example, the stagnation region heat load derived from thermocouples embedded in the thermal protection system (TPS)of the Mars Science Laboratory (MSL) heatshield did not match the unmargined pre-flight predictions. This was at least partially attributed to the fact that radiative heating was not accounted for in the unmargined pre-flight predictions [2].Since MSL, significant work has been done to update radiative heating models and test how the models perform compared to ground-based test facilities such as shock tubes. The models and ground-based tests have shown that radiative heating can be significant for entry into the atmospheres of Venus, Earth, Mars, and Titan, among other planetary bodies. However, there are still discrepancies between the models and the test data, which is where the desire for flight data comes in to play. Missions that have had or are currently planned to have instrumentation to measure radiative heating during atmospheric entry are listed in Table 1.

R A Miller↗
NASA NTRSDate not supplied

Characterization of Titan Entry Radiative Heating in the Low Density Electric Arc Shock Tube

Prediction of aftbody radiative heating for Dragonfly’s entry at Titan requires accurate models to inform the design of its thermal protection systems. Previously reported investigations of shock layer aftbody radiation in the Electric Arc Shock Tube (EAST) at NASA Ames Research Center focused on the lower altitude/higher density part of the trajectory. This paper presents the first optical emission spectroscopy measurements of an ongoing test series in the new aluminum Low Density Shock Tube (LDST), recently installed at EAST, focusing on the radiative heating characterization through the higher altitude portion of Dragonfly’s entry path. Experimental data collected at a fill pressure of 0.1 Torr and shock velocities between 5.2 and 6.2 km/s show favorable agreement to similar conditions previously tested in the 4" High-Velocity Shock Tube, as well as improvements in the signal to noise ratio and available test time. Simulations employing DPLR and NEQAIR underpredict the experimental radiance, with increasing discrepancy from the NIR towards the UV wavelength range, thus motivating further efforts in improving the current non-Boltzmann model for the CN molecule.

A Fagnani↗