Search NASA⌕ Search

Engineering topics

Abdol-Hamid, Khaled S.

Publications and source records attributed to Abdol-Hamid, Khaled S..

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1995

Aerodynamic Performance Predictions of Single and Twin Jet Afterbodies

The multiblock three-dimensional Navier-Stokes method PAB3D was utilized by the Component Integration Branch (formerly Propulsion Aerodynamics Branch) at the NASA-Langley Research Center in an international study sponsored by AGARD Working Group #17 for the assessment of the state-of-the-art of propulsion-airframe integration testing techniques and CFD prediction technologies. Three test geometries from ONERA involving fundamental flow physics and four geometries from NASA-LaRC involving realistic flow interactions of wing, body, tail, and jet plumes were chosen by the Working Group. An overview of results on four (1 ONERA and 3 LaRC) of the seven test cases is presented. External static pressures, integrated pressure drag and total drag were calculated for the Langley test cases and jet plume velocity profiles and turbulent viscous stresses were calculated for the ONERA test case. Only selected data from these calculations are presented in this paper. The complete data sets calculated by the participants will be presented in an AGARD summary report. Predicted surface static pressures compared favorably with experimental data for the Langley geometries. Predicted afterbody drag compared well with experiment. Predicted nozzle drag was typically low due to over-compression of the flow near the trailing edge. Total drag was typically high. Predicted jet plume quantities on the ONERA case compared generally well with data.

Carlson, John R.↗
NASA NTRS1994

Investigation of supersonic jet plumes using an improved two-equation turbulence model

Supersonic jet plumes were studied using a two-equation turbulence model employing corrections for compressible dissipation and pressure-dilatation. A space-marching procedure based on an upwind numerical scheme was used to solve the governing equations and turbulence transport equations. The computed results indicate that two-equation models employing corrections for compressible dissipation and pressure-dilatation yield improved agreement with the experimental data. In addition, the numerical study demonstrates that the computed results are sensitive to the effect of grid refinement and insensitive to the type of velocity profiles used at the inflow boundary for the cases considered in the present study.

Lakshmanan, B.↗
NASA NTRS1993

Prediction of static performance for single expansion ramp nozzles

A multiblock three-dimensional Navier-Stokes method was utilized in a two-dimensional fully implicit mode to calculate the flowfield of a single expansion ramp nozzle configuration. The code has been shown previously to be fairly accurate in predicting three-dimensional nozzle flowfields and internal performance for several axisymmetric and nonaxisymmetric geometries. A two-dimensional implementation of the method was used to reduce the resources required to obtain preliminary performance parameters of nozzle concepts. A two-dimensional description of a single-expansion ramp nozzle configuration was analyzed to verify the applicability of the Navier-Stokes code and nozzle performance package to this class of nozzles. Internal static pressure distributions, discharge coefficient and thrust ratio quantities were calculated for a range of operating conditions. Comparisons of predicted performance parameters with experimental data were within 0.5 percent for mass flow, and typically within l.5 percent for thrust ratio.

Carlson, John R.↗
NASA NTRS1992

Comparison of algebraic turbulence models for afterbody flows with jet exhaust

Three-dimensional Navier-Stokes simulations have been done for transonic and low supersonic flow past a nonaxisymmetric nozzle typical of those advocated for advanced fighter airplanes. The jet exhaust is included in the calculations. The investigation compares the performance of the unmodified Baldwin-Lomax turbulence model with its performance when enhanced by the Degani-Schiff and the Goldberg modifications. Solutions are presented for Mach numbers of 0.80, 0.94, and 1.20 at 0-deg angle of attack and a Reynolds number of 20 x 10 to the 6th. The numerical results, which are compared to the wind-tunnel data, show that the three turbulence models predict considerably different shock locations, separated-flow regions, and flowfields.

Compton, William B., III↗
NASA NTRS1992

A comparative study of two codes with an improved two-equation turbulence model for predicting jet plumes

Compressible jet plumes were studied using a two-equation turbulence model. A space marching procedure based on an upwind numerical scheme was used to solve the governing equations and turbulence transport equations. The computed results indicate that extending the space marching procedure for solving supersonic/subsonic mixing problems can be stable, efficient and accurate. Moreover, a newly developed correction for compressible dissipation has been verified in fully expanded and underexpanded jet plumes. For a sonic jet plume, no improvement in results over the standard two-equation model was seen. However for a supersonic jet plume, the correction due to compressible dissipation successfully predicted the reduced spreading rate of the jet compared to the sonic case. The computed results were generally in good agreement with the experimental data.

Balakrishnan, L.↗
NASA NTRS1992

Commercial turbofan engine exhaust nozzle flow analyses using PAB3D

Recent developments of a three-dimensional (PAB3D) code have paved the way for a computational investigation of complex aircraft aerodynamic components. The PAB3D code was developed for solving the simplified Reynolds Averaged Navier-Stokes equations in a three-dimensional multiblock/multizone structured mesh domain. The present analysis was applied to commercial turbofan exhaust flow systems. Solution sensitivity to grid density is presented. Laminar flow solutions were developed for all grids and two-equation k-epsilon solutions were developed for selected grids. Static pressure distributions, mass flow and thrust quantities were calculated for on-design engine operating conditions. Good agreement between predicted surface static pressures and experimental data was observed at different locations. Mass flow was predicted within 0.2 percent of experimental data. Thrust forces were typically within 0.4 percent of experimental data.

Abdol-Hamid, Khaled S.↗
NASA NTRS1991

Computational investigation of circular-to-rectangular transition ducts

A study demonstrating that flows inside transition ducts with unusual geometry can be analyzed by employing proper selections of a Navier-Stokes code, grid topology, and turbulence modeling is presented. Based on comparison between existing experimental data and the computed results for the same configurations, reasonable agreements were obtained for wall static pressure in the transition duct. Static pressure comparisons in the supersonic nozzle section were excellent, as well as agreement between computed and measured mass flow and thrust performance.

Pao, S. P.↗
NASA NTRS1991

Prediction of internal performance for two-dimensional convergent-divergent nozzles

A three-dimensional code (PAB3D) has been under development to simulate underexpanded and overexpanded supersonic jet exhaust effects on a nonaxisymmetric nozzle/afterbody. The code is a multiblock/multizone technique solving the simplified Navier-Stokes equations. This method was applied to the solution of two nozzle configurations to verify the recent implementation of a nozzle performance calculation package. Static pressure distributions, discharge coefficient and thrust ratio quantities were calculated for on-design and off-design operating conditions for rectangular convergent-divergent nozzles with different throat designs. Approaches involved in computing the flows for these nozzles are presented. Computation of performance parameters were typically within 1 percent of experimental on-design and off-design data.

Carlson, John R.↗
NASA NTRS1991

Computational analysis of vented supersonic exhaust nozzles using a multiblock/multizone strategy

NASA-Langley's PAB3D-v3 multiblock/multizone Navier Stokes code is presently used to study the behavior of the longitudinally-slotted nozzle configuration for fixed-geometry operation in supersonic cruise on the bases of high nozzle pressure ratios. The range of flow conditions encompassed nozzle pressure ratio values from 5 to 20, and freestream Mach numbers from 0 to 2.5. A large recirculation region was detected near the concave base of the nozzle, while smaller regions were located near and around the slots. In general, the discharge coefficient was predicted within 0.5 percent, and the thrust ratio within 1.5 percent, of measured values.

Abdol-Hamid, Khaled S.↗
NASA NTRS1991

Navier-Stokes simulation of nozzle-afterbody flows with jets at off-design conditions

Three-dimensional Navier-Stokes simulations are made for the external flow, the jet-exhaust plume, and the internal nozzle flow of a nonaxisymmetric nozzle typical of those advocated for advanced fighter airplanes. Solutions are presented for free-stream Mach numbers of 0.80, 0.94, and 1.20 at an angle of attack of 0 deg and a Reynolds number of 20 x 10 to the 6th. Jet-total-pressure ratios ranging from 1.5 to 9.8, i.e., from below to above the design pressure ratio of 4.25, are investigated. The results are compared to wind-tunnel data. The calculations successfully predict many trends and features of the external and internal flow.

Compton, William B., III↗
NASA NTRS1991

Grid adaptation to multiple functions for applied aerodynamic analysis

A fast and robust method of grid adaptation to multiple functions has been developed for flow analysis in 3D space. It is based on the equidistribution principle and the alternate direction adaptation method. The grid adaptation algorithm has been fully integrated with a space marching flow solver as contained within a 3D Navier-Stokes code and PAB3D-v2. The grid adaptation strategy, details of numerical implementation, examples of application, and potential extensions of the current method are presented in this paper.

Pao, S. P.↗
NASA NTRS1990

A multiblock/multizone code (PAB 3D-v2) for the three-dimensional Navier-Stokes equations: Preliminary applications

The development and applications of multiblock/multizone and adaptive grid methodologies for solving the three-dimensional simplified Navier-Stokes equations are described. Adaptive grid and multiblock/multizone approaches are introduced and applied to external and internal flow problems. These new implementations increase the capabilities and flexibility of the PAB3D code in solving flow problems associated with complex geometry.

Abdol-Hamid, Khaled S.↗
NASA NTRS1990

Application of a new adaptive grid for aerodynamic analysis of shock containing single jets

A fast and robust solution-adaptive grid generation method has been developed for the three-dimensional numerical analysis of shock containing supersonic jets. The adaptive grid algorithm, which is based on the equidistribution principle and the alternate direction method, has been fully integrated with the space marching scheme developed by Abdol-Hamid (1989). The capability of the approach proposed here is illustrated by numerical solutions for circular, square, and elliptic jet plumes.

Pao, S. Paul↗
NASA NTRS1990

Navier-Stokes simulation of transonic afterbody flows with jet exhaust

Three-dimensional Navier-Stokes simulations have been made for the transonic flow past a nonaxisymmetric nozzle typical of those advocated for advanced fighter airplanes. Jet exhaust simulation is evaluated as are the Baldwin-Lomax (1978) and Goldberg (1986) turbulence models. Solutions are presented for Mach numbers of 0.80 and 0.94 at 0-deg angle of attack and a Reynolds number of 20 x 10 to the 6th. The numerical results are compared to wind-tunnel data. They show that including the jet exhaust in the calculations gives the most accurate solution near the nozzle exit. Also, the two turbulence models predict considerably different flow fields.

Compton, William B., III↗
NASA NTRS1989

The application of 3D marching scheme for the prediction of supersonic free jets

A modified version of the upwind flux-difference scheme of Roe for supersonic flow solution is described. This efficient iterative Space Marching Scheme (SMS) is used to solve the three-dimensional, Reynolds-averaged Navier-Stokes equations, for underexpanded and overexpanded supersonic free jet with a single time sweep. Comparisons with experimental data and the Parabolized Navier-Stokes (PNS) solutions are presented. These results show that the present scheme gives good agreement with experimental data in less computer time and the convergence history of the SMS is much faster than the PNS solution.

Abdol-Hamid, Khaled S.↗