Engineering topics

Ablow, C. M.

Publications and source records attributed to Ablow, C. M..

3 records

NASA NTRS1980

Generation of boundary and boundary-layer fitting grids

The details of extended physical processes, such as the gas dynamic flow over an airfoil, the reactive flow through a combustor, or the electric field in a multi-contact transistor, are understood by solving the differential equations of a mathematical model of the process. The accuracy of finite difference methods for the numerical solution of the equations is increased if the underlying mesh fits the region boundaries and is closely spaced in regions where the solution is rapidly varying. Automatic methods for producing a satisfactorily adjusted mesh were developed for one dimensional problems. In one simple, effective scheme of this kind the unknown function and the distribution of mesh modes are found simultaneously, the nodes being placed so that they correspond to points uniformly spaced on the solution curve. In a two dimensional generalization, the nodes correspond to points equally spaced on the solution surface in two directions that are as nearly orthogonal as possible. Examples of such meshes are shown.

Ablow, C. M.↗

NASA NTRS1973

Investigation of atomic oxygen-surface interactions related to measurements with dual air density explorer satellites

For a number of candidate materials of construction for the dual air density explorer satellites the rate of oxygen atom loss by adsorption, surface reaction, and recombination was determined as a function of surface and temperature. Plain aluminum and anodized aluminum surfaces exhibit a collisional atom loss probability alpha .01 in the temperature range 140 - 360 K, and an initial sticking probability. For SiO coated aluminum in the same temperature range, alpha .001 and So .001. Atom-loss on gold is relatively rapid alpha .01. The So for gold varies between 0.25 and unity in the temperature range 360 - 140 K.

Wood, B. J.↗

NASA NTRS1971

Avalanche-diode oscillator circuit with tuning at multiple frequencies

Detailed theoretical analysis of three different modes or types of high efficiency oscillation in a PIN diode are presented. For the TRAPATT mode in a PIN diode, it is shown that a traveling avalanche zone is not necessary to generate a dense trapped plasma. An economical computer program for TRAPATT oscillations in a PIN diode is described. Typical results of diode power, dc-to-RF conversion efficiency, and required circuit impedances are presented for several different current waveforms. A semianalytical solution for a second type of high efficiency mode in a PIN diode is derived assuming a rectangular current waveform. A quasi-static approximation is employed to derive a semianalytical solution for the voltage across a PIN diode in a third mode, where avalanching occurs during a major portion of a half cycle. Calculations for this mode indicate that the power increases proportionally to the magnitude of the drive current with a small decrease in efficiency relative to the ordinary TRAPATT mode. An analytical solution is also given for a PIN diode, where it is assumed that the ionization coefficient is a step function. It is shown that the step-ionization approximation permits one to draw possible patterns of avalanche region in the depletion layer as a function of time. A rule governing admissible patterns is derived and an example solution given for one admissible pattern. Preliminary experimental results on the high-efficiency oscillations are presented and discussed. Two different experimental circuits, which used channel-dropping filters to provide independent harmonic tuning, are described. Simpler circuits used to produce high-efficiency oscillations are discussed. Results of experiments using inexpensive Fairchild FD300 diodes are given.

Parker, D.↗