Engineering topics

Abreu, Vincent J.

Publications and source records attributed to Abreu, Vincent J..

14 records

NASA NTRS1994

Incorporation of multiple cloud layers for ultraviolet radiation modeling studies

Cloud data sets compiled from surface observations were used to develop an algorithm for incorporating multiple cloud layers into a multiple-scattering radiative transfer model. Aerosol extinction and ozone data sets were also incorporated to estimate the seasonally averaged ultraviolet (UV) flux reaching the surface of the Earth in the Detroit, Michigan, region for the years 1979-1991, corresponding to Total Ozone Mapping Spectrometer (TOMS) version 6 ozone observations. The calculated UV spectrum was convolved with an erythema action spectrum to estimate the effective biological exposure for erythema. Calculations show that decreasing the total column density of ozone by 1% leads to an increase in erythemal exposure by approximately 1.1-1.3%, in good agreement with previous studies. A comparison of the UV radiation budget at the surface between a single cloud layer method and a multiple cloud layer method presented here is discussed, along with limitations of each technique. With improved parameterization of cloud properties, and as knowledge of biological effects of UV exposure increase, inclusion of multiple cloud layers may be important in accurately determining the biologically effective UV budget at the surface of the Earth.

Charache, Darryl H.↗

NASA NTRS1993

The high-resolution Doppler imager on the Upper Atmosphere Research Satellite

The high-resolution Doppler imager (HRDI) on the Upper Atmosphere Research Satellite is a triple-etalon Fabry-Perot interferometer designed to measure winds in the stratosphere, mesosphere, and lower thermosphere. Winds are determined by measuring the Doppler shifts of rotational lines of the O2 atmospheric band, which are observed in emission in the mesosphere and lower thermosphere and in absorption in the stratosphere. The interferometer has high resolution (0.05/cm), good offhand rejection, aud excellent stability. This paper provides details of the design and capabilities of the HRDI instrument.

Hays, Paul B.↗

NASA NTRS1992

Observations of winds with an incoherent lidar detector

A Fabry-Perot interferometer and image-plane detector system to be used as a receiver for a Doppler lidar have been developed. This system incorporates the latest technology in multichannel detectors, and it is an important step toward the development of operational wind profiler systems for the atmosphere. The instrumentation includes a stable high-resolution optically contacted plane etalon and a multiring anode detector to scan the image plane of the Fabry-Perot interferometer spatially. The high wavelength resolution provided by the interferometer permits the aerosol and molecular components of the backscattered signal to be distinguished, and the Doppler shift of either component can then be used to determine the wind altitude profile. The receiver performance has been tested by measuring the wind profile in the boundary layer. The Fabry-Perot interferometer and image-plane detector characteristics are described and sample measurements are presented. The potential of the system as a wind profiler in the troposphere, the stratosphere, and the mesosphere is also considered.

Abreu, Vincent J.↗

NASA NTRS1992

Extraction of Aerosol and Rayleigh Components from Doppler Lidar Return Signal

One of the most significant problems which limits the applicability of lidar systems for pressure and density profile measurements below 30 km altitude is the presence of atmospheric aerosols which contaminate the molecular or Rayleigh return signal. A new technique is described which allows for the separation of the return signal into aerosol and molecular scattered components. The technique was applied to data from the University of Michigan's High Resolution Doppler Lidar (HRDL).

Barnes, John E.↗

NASA NTRS1992

Tropospheric and stratospheric wind profiling with a direct detection Doppler lidar

The Space Physics Research Laboratory at the University of Michigan has been operating a direct detection, high resolution Doppler Lidar (HRDL) to measure winds in the boundary layer, free troposphere and lower stratosphere. A direct detection Doppler lidar measures the Doppler shift of the aerosol or Rayleigh backscattered signal, from which the wind velocity vector can be retrieved (Benedetti-Michelangeli et al, 1972, 1974; Chanin et al., 1989; Abreu et al., 1992). The system components are shown. The transmitting system is a Continuum NY-60 Nd:YAG laser frequency doubled to a wavelength of 532 nm. The laser is injection seeded for single line mode operation yielding a linewidth of 0.0045 cm(exp -1) (135 MHz) with excellent shot-to-shot frequency stability. The laser produces 60 mJ pulses and operates at a 50 Hz repetition rate for an effective output power of 3.0 W. A description of the University of Michigan's Doppler lidar is given with examples of wind profiles for the boundary layer, free troposphere, and for the lower stratosphere. The system provides a reliable method of remotely measuring the wind. The wind error is smallest in regions of high aerosols. The system also produces aerosol extinction profiles versus altitude which can be determined by the shape of the spectra. The system has been installed in a trailor so that measurements can be made for field campaigns. Winds and aerosol data are available immediately at the site for use in forecasting.

Abreu, Vincent J.↗

NASA NTRS1990

Visible Airglow Experiment data analysis

The Visible Airglow Experiment (VAE) was designed to provide detailed profiles of the distribution of excited states of atoms and molecules in the upper atmosphere. The studies supported during the funding period (1983 - 1989) have made significant contributions in the area of thermospheric aeronomy, and the progress during the first four years of this period has been reviewed by Hays et al. (1988). The investigations carried out have resulted in more than 20 publications, and these are summarized.

Abreu, Vincent J.↗

NASA NTRS1989

High resolution Doppler lidar

A high resolution lidar system was implemented to measure winds in the lower atmosphere. The wind speed along the line of sight was determined by measuring the Doppler shift of the aerosol backscattered laser signal. The system in its present configuration is stable, and behaves as indicated by theoretical simulations. This system was built to demonstrate the capabilities of the detector system as a prototype for a spaceborne lidar. The detector system investigated consisted of a plane Fabry-Perot etalon, and a 12-ring anode detector. This system is generically similar to the Fabry-Perot interferometer developed for passive wind measurements on board the Dynamics Explorer satellite. That this detector system performs well in a lidar configuration was demonstrated.

Abreu, Vincent J.↗

NASA NTRS1989

Diurnal and seasonal variation of the nighttime OH (8-3) emission at low latitudes

Nighttime morphological maps of the hydroxyl emission (8-3 band) measured by the Visible Airglow Experiment on board the Atmosphere Explorer E satellite are presented for solstice and equinox conditions. The volume emission rate profile of the emission was determined by inverting satellite perigee observations. This profile was later used to convert limb measurements into zenith intensities of the emission. A theoretical model has been used to correct twilight observations for the presence of the thermospheric O(+)(2P) emission at 7320-7330 A. The derived morphology agrees well with ground based measurements and theoretical simulations.

Abreu, Vincent J.↗

NASA NTRS1989

Absorption and emission line shapes in the O2 atmospheric bands - Theoretical model and limb viewing simulations

A multiple scattering radiative transfer model has been developed to carry out a line-by-line calculation of the absorption and emission limb measurements that will be made by the High Resolution Doppler Imager to be flown on the Upper Atmosphere Research Satellite. The multiple scattering model uses the doubling and adding methods to solve the radiative transfer equation, modified to take into account a spherical inhomogeneous atmosphere. Representative absorption and emission line shapes in the O2 1Sigma(+)g - 3Sigma(-)g atmospheric bands (A,B, and gamma) and their variation with altitude are presented. The effects of solar zenith angle, aerosol loading, surface albedo, and cloud height on the line shapes are also discussed.

Abreu, Vincent J.↗

NASA NTRS1989

The 630 nm dayglow

The daytime thermospheric emission at 630 nm from the (3P-1D) transition of atomic oxygen is examined using data from the Atmosphere Explorer C and E spacecraft. Observed altitude distributions of the emission rate measured using the Visible Airglow Experiment are compared with those calculated from in situ measurements of ion and neutral densities and temperatures, and from a model of the photon and photoelectron flux. Good agreement is obtained for most orbits with photoelectron impact on O, photodissociation of O2, and dissociative recombination of O2(+) providing most of the production. Implications for some of the controversial points of O(1D) chemistry, such as the solar EUV and Schumann-Runge continuum flux, the yield of O(1D) from the reaction of N(2D) with O2, the value of spontaneous transition coefficients, and the rate of quenching by O(3P) are discussed.

Solomon, Stanley C.↗

NASA NTRS1989

Aeronomical determinations of the quantum yields of O (1S) and O (1D) from dissociative recombination of O2(+)

Data from the visible-airglow experiment on the Atmosphere Explorer-E satellite have been used to determine the quantum yields of O (1S) and O (1D) from the dissociative recombination of O2(+) based on a constant total recombination rate from each vibrational level. A range of values between 0.05 and 0.18 has been obtained for the quantum yield of O (1S) and shows a positive correlation with the extent of the vibrational excitation of O2(+). The quantum yield of O (1D) has been measured to be 0.9 + or - 0.2, with no apparent dependence on the vibrational distribution of O2(+).

Yee, Jeng-Hwa↗

NASA NTRS1988

The auroral 6300 A emission - Observations and modeling

A tomographic inversion is used to analyze measurements of the auroral atomic oxygen emission line at 6300 A made by the atmosphere explorer visible airglow experiment. A comparison is made between emission altitude profiles and the results from an electron transport and chemical reaction model. Measurements of the energetic electron flux, neutral composition, ion composition, and electron density are incorporated in the model.

Solomon, Stanley C.↗

NASA NTRS1988

The Visible Airglow Experiment - A review

Contributions of the Visible Airglow Experiment (VAE) to the understanding of various airglow and auroral processes are reviewed. The impact of instrumental design and operation on the observations is discussed, and emphasis is placed on the relationship between observations and inversion for optical measurements of light emissions from a diffuse medium. VAE data are used to explain the physical mechanisms responsible for the production and destruction of excited species including O(+)(1P), O(1D), O(1S), N(2D), and Mg(+)2P1/2.

Hays, Paul B.↗

NASA NTRS1987

Optimization of a triple etalon interferometer

The High Resolution Doppler Image (HRDI) is a triple etalon Fabry-Perot interferometer designed to measure Doppler shifts of rotational lines in the O2 atmospheric system from the Upper Atmosphere Research Satellite. These shifts are used to determine wind vectors in the stratosphere and mesosphere. This paper presents the techniques used to determine the gap thicknesses and reflectivities of the three etalons of the HRDI instrument. The spacings are found to be 1.000, 0.186, and 0.025 cm. These spacings are independent of the reflectivity of the etalons. The reflectivities of the three etalons should be nearly equal to minimize the errors in the wind measurement caused by mistuning of the etalons. The choice of the reflectivity does not strongly influence the statistical error in the wind error when the values are less than about 0.90.

Skinner, Wilbert R.↗