Engineering topics
Publications and source records attributed to Ackeret, J.
Some of the problems considered in this report include: thermodynamics of surface friction, application of thick wing sections, special applications of controllable propellers, and gas turbines for aircraft.
Wind tunnel construction and design is discussed especially in relation to subsonic and supersonic speeds. Reynolds Numbers and the theory of compressible flows are also taken into consideration in designing new tunnels.
Progress in the scientific and practical fields of aviation has caused the Swiss Institute of Technology to organize lectures and practical training courses in all three branches of aeronautics and to found centers of scientific research, laboratories, etc., in order to supply the government and industries with scientifically and technically trained engineers.
Airfoils with their trailing edge cut away are often found on aircraft, as the fins on the hulls of flying boats and the central section of the wings for affording better visibility. It was therefore of some interest to discover the effect of such cutaways on the lift and drag and on the position of the center of pressure. For this purpose, systematic experiments were performed on two different airfoils, a symmetrical airfoil and an airfoil of medium thickness, with successive shortenings of their chords.
It is stated that the index value 6000, as found in normal tests of wing sections with a 20 cm chord, falls in the same region where the transition of laminar to turbulent flow takes place on thin flat plates. It is to be expected that slightly cambered, thin wing sections will behave similarly. The following test of two such wing sections were made for the purpose of verifying this supposition.
Through the utilization of the "Magnus effect" on the Flettner rotor ship, the attention of the public has been directed to the underlying physical principle. It has been found that the Prandtl boundary-layer theory furnishes a satisfactory explanation of the observed phenomena. The present article deals with the prevention of this separation or detachment of the flow by drawing the boundary layer into the inside of a body through a slot or slots in its surface.
Our attempts to improve the properties of airfoils by removing the boundary layer by suction, go back to 1922. The object of the suction is chiefly to prevent the detachment of the boundary layer from the surface of the airfoil. At large angles of attack, such detachment prevents the attainment of the great lift promised by the theory, besides greatly increasing the drag, especially of thick airfoils. This report gives results of those experiments.
This report presents the results of various experiments carried out at the Gottingen Aerodynamic Institute. These include: experiments with Joukowski wing profiles; experiments on an airplane model with a built-in motor and functioning propeller; and the rotating cylinder (Magnus Effect).
We are undertaking the task of computing the air forces on a slightly cambered airfoil in the absence of friction and with an infinite aspect ratio. We also assume in advance that the leading edge is very sharp and that its tangent lies in the direction of motion.