Search NASA⌕ Search

Engineering topics

Adams, D. W.

Publications and source records attributed to Adams, D. W..

6 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Vibration behavior of fuel-element vibration suppressors for the advanced power reactor

Preliminary shock and vibration tests were performed on vibration suppressors for the advanced power reactor for space application. These suppressors position the fuel pellets in a pin type fuel element. The test determined the effect of varying axial clearance on the behavior of the suppressors when subjected to shock and vibratory loading. The full-size suppressor was tested in a mockup model of fuel and clad which required scaling of test conditions. The test data were correlated with theoretical predictions for suppressor failure. Good agreement was obtained. The maximum difference with damping neglected was about 30 percent. Neglecting damping would result in a conservative design.

Adams, D. W.↗
NASA NTRS1972

High torque bellows seal rotary drive

Bellows seal rotary drive device was developed which allows high torque transmission through sealed compartments. Bearing friction which would normally be carried by sealing bellows in comparable devices is absorbed by universal-gimbal joint. It can be used to transmit high torque, low speed, rotary motion through sealed barriers to prevent contamination or escape of fluids.

Diaguila, A. J.↗
NASA NTRS1972

Shock and vibration tests of uranium mononitride fuel pellets for a space power nuclear reactor

Shock and vibration tests were conducted on cylindrically shaped, depleted, uranium mononitride (UN) fuel pellets. The structural capabilities of the pellets were determined under exposure to shock and vibration loading which a nuclear reactor may encounter during launching into space. Various combinations of diametral and axial clearances between the pellets and their enclosing structures were tested. The results of these tests indicate that for present fabrication of UN pellets, a diametral clearance of 0.254 millimeter and an axial clearance of 0.025 millimeter are tolerable when subjected to launch-induced loads.

Adams, D. W.↗