Search NASA⌕ Search

Engineering topics

Adelman, Henry G.

Publications and source records attributed to Adelman, Henry G..

23 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

Entry aeromaneuvering capabilities of transatmospheric vehicles

The landing footprint of a conceptual high-lift transatmospheric vehicle is defined for aeromaneuvering entry from a typical low-earth orbit. The flight strategy for trajectory construction to maximize the landing area by extending downrange and crossrange as far as possible is developed in four phases by optimal programming of the vehicle's roll angle. Trajectories that reach any given landing site were calculated with the corresponding heating rates at three critical vehicle locations (stagnation point, wing leading edge, and body centerline). An optimization methodology was developed that demonstrates the trades between crossrange, peak heating and total heat loads as a function of three key flight parameters (altitude, flight-path angle, and vehicle roll angle). The maximum extent of the landing footprint was found to be 29,690 km downrange and 6560 km crossrange. Large variations in the ballistic coefficient had negligible effect on the extent of the footprint but could significantly affect heating. However, the footprint's longitude was displaced downstream or upstream with increasing or decreasing ballistic coefficient, respectively.

Menees, Gene P.↗
NASA NTRS1987

The thermal environment of transatmospheric vehicles

A transatmospheric vehicle using primarily air-breathing propulsion must fly in the denser part of the atmosphere to achieve adequate acceleration to reach orbital speed. The potentially long ascent times, combined with the need for a low-drag configuration, result in a severe aerothermodynamics environment. To achieve low drag, the vehicle must have a relatively sharp nose and wing leading edges. The ascent peak stagnation point and equilibrium wall temperatures for the wing leading edge can reach values of 4000 K and 3000 K, respectively, for high dynamic pressure trajectories, making some form of mass addition cooling mandatory. The corresponding temperatures during entry are about 1500 K lower. The vehicle windward centerline temperatures are more moderate, however, with values peaking around 1500 K. Therefore, radiative cooling should be effective over large areas of the vehicle. The windward, centerline heat loads are relatively insensitive to the dynamic pressure of the ascent trajectory, in contrast to the stagnation point and wing leading edge. The windward surface entry heat loads are much lower, but depend strongly on the flightpath.

Tauber, Michael E.↗
NASA NTRS1987

Ascent aeromaneuvering capabilities of transatmospheric vehicles

The low-earth orbit rendezvous capability of a conceptual transatmospheric vehicle is analyzed for two endo-/exo-atmospheric ascent missions. Both cases involve coasting aerodynamic maneuvers starting from the burn-out conditions corresponding to air-breathing propulsion systems that achieve orbital velocity within the atmosphere. The powered phase of the ascent trajectories approximate constant dynamic pressure, fuel-efficient flightpaths typically flown by supersonic aircraft. The aeromaneuvering coast phases of the ascent include both coplanar (to determine altitude capability without plane-inclination changes) and aeroturning to LEO rendezvous at 400 km altitude (to assess plane-change capability). The coast-phase ascent maneuvers are correlated with G-load requirements and aerothermodynamic heating characteristics at two critical locations on the vehicle surface (i.e., the nose stagnation point and the body centerline). The results are correlated and recommendations are made concerning thermal protection and structural requirements.

Menees, Gene P.↗
NASA NTRS1987

Synergetic plane-change capability of a conceptual aeromaneuvering-orbital-transfer vehicle

The flight strategy for a general low-earth orbit plane-change is analyzed for a conceptual, high-lift, aeromaneuvering-orbital-transfer vehicle, and applied to the important case of the 45 deg plane-inclination change. The study focuses on two principal methods: (1) the procedure to obtain a change in the inclination of the vehicle's orbital plane, and (2) the full rendezvous procedure. Optimal trajectories for minimal propellant use during the synergetic aerotransit are developed, which incorporate best estimates of constraints imposed by reusable thermal-protection requirements and human tolerance to g-load levels. The performance capability for one-way payload delivery to the target orbit is analyzed in detail and the capability for return to the base orbit demonstrated.

Menees, Gene P.↗