Engineering topics

Adkins, D. W.

Publications and source records attributed to Adkins, D. W..

3 records

NASA NTRS1985

End effects in scarf joints

Scarf joints with small scarf angles are especially sensitive to stiffness mismatch between adherends and to adherend tip bluntness. Pre-assembly breakage of an adherend tip where it is only a few microns thick can cause significant reduction in joint strength. Mathematically, the reason for such sensitivity is that the solutions to the governing differential equation develop boundary layer character when the scarf angles are small. The boundary layers are regions with large adhesive stresses. Experimental strength data for laminated composite adherends agree with the results of this analysis.

Adkins, D. W.↗

NASA NTRS1982

Strength and Mechanics of Bonded Scarf Joints for Repair of Composite Materials

Experimental and analytical investigations of scarf joints indicate that slight bluntness of adherend tips induces adhesive stress concentrations which significantly reduce joint strength, and the stress distribution through the adhesive thickness is non-uniform and has significant stress concentrations at the ends of the joint. The laminate stacking sequence can have important effects on the adhesive stress distribution. A significant improvement in joint strength is possible by increasing overlap at the expense of raising the repair slightly above the original surface. Although a surface grinder was used to make most experimental specimens, a hand held rotary bur can make a surprisingly good scarf. Scarf joints wit doublers on one side, such as might be used for repair, bend under tensile loads and may actually be weaker than joints without doublers.

Pipes, R. B.↗

NASA NTRS1978

Planar scarf joints in composite repair

This study examined the effects of varying certain important geometric parameters on the stresses in an adhesive repair of a thin composite laminate. The repair, a planar scarf joint with a doubler, was studied using finite element methods at scarf angles of 6 deg and 12 deg, damage lengths between 2.5 mm and 25 mm and doubler overlaps between 10 mm and 40 mm. Finite element models also showed that significant stress peaks occur at the ends of the scarf joint adhesive, similar to shear lag phenomena in lap joints. A bending model of the planar scarf joint with a doubler, based on mechanics of materials theory, was also developed.

Adkins, D. W.↗