Search NASA⌕ Search

Engineering topics

Ahmad, Suraiya P.

Publications and source records attributed to Ahmad, Suraiya P..

11 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2003

Atmospheric products from the Upper Atmosphere Research Satellite (UARS)

This paper provides information on the products available at the NASA Goddard Earth Sciences (GES) Distributed Active Archive Center (DAAC) from the Upper Atmosphere Research Satellite (UARS) mission. The GES DAAC provides measurements from the primary UARS mission, which extended from launch in September 1991 through September 2001. The ten instruments aboard UARS provide measurements of atmospheric trace gas species, dynamical variables, solar irradiance input, and particle energy flux. All standard Level 3 UARS products from all ten instruments are offered free to the public and science user community. The Level 3 data are geophysical parameters, which have been transformed into a common format and equally spaced along the measurement trajectory. The UARS data have been reprocessed several times over the years following improvements to the processing algorithms. The UARS data offered from the GES DAAC are the latest versions of each instrument. The UARS data may be accessed through the GES DAAC website at

Ahmad, Suraiya P.↗
NASA NTRS1992

Radiometric calibration of a polarization-sensitive sensor

The radiometric accuracy of a sensor is adversely affected by scene polarization if its optical system is sensitive to polarization. Tests performed on the reflective bands of the NS001 Thematic Mapper simulator, an aircraft multispectral scanner, show that it is very sensitive to the polarization state of the incoming radiations. For 100 percent linearly polarized light, errors in the measured intensity vary from -40 to +40 percent, depending on the scan angle and spectral band. To estimate polarization-induced errors in the intensity measured at aircraft level, the intensity and polarization of the atmospheric radiances were simulated using a realistic earth-atmosphere radiative transfer model. For the polarization of atmospheric radiances in the solar meridian plane over a vegetated target, intensity errors may range from -10 to + 10 percent. The polarization-induced errors are highest in the shortest NS001 spectral band (0.450-0.525 microns) because of large atmospheric polarizations contributed by Rayleigh particles and small diluting effects caused by the small contributions of weakly polarized radiations coming from aerosols and the surface. Depending on the illumination and view angles, the errors in derived surface reflectance due to the radiance errors can be very large. In particular, for large off-nadir view angles in the forward scattered direction when the sun is low, the relative errors in the derived surface reflectance can be as large as 4 to 5 times the relative error in the radiances. Polarization sensitivity errors cannot be neglected for the shorter wavelengths when the surface reflectance contribution to atmospheric radiances is very small.

Ahmad, Suraiya P.↗
NASA NTRS1992

A simple analytical function for bidirectional reflectance

A simple bidirectional reflectance model based on physical scattering laws is developed to calculate the bidirectional reflectance of a wide variety of surfaces. Chandrasekhar's radiative transfer solution, obtained for the anisotropically scattering semi-infinite medium, is used to compute the multiple-scattered radiances. However, since the radiative transfer solution does not take architectural effects into consideration, we adopt Hapke's (1986) approach and add an empirical term to explain the hot-spot phenomenon and use Cox and Munk's (1954) formulation to take into account the specular reflection. The physical parameters of the model are retrieved from bidirectional reflectance measurements. For each surface, only one set of model parameters is needed for application to all illumination and viewing geometries. The validity of the model is established by comparing the computed and measured reflectances for sets of viewing and illumination angles that were not included in the inversion algorithm. Good agreement is shown between the model-computed and the observed reflectances for dense prairie vegetation canopies, a sparse desert scrub community, a plowed agricultural field, and an alkali flat.

Ahmad, Suraiya P.↗
NASA NTRS1992

The role of specular reflectance in surface anisotropy

For smooth surfaces, specular reflection constitutes a major source of anisotropy in the surface bidirectional reflectance and introduces a strong illumination angle dependence in diurnal albedo. A prior formulation has been employed by the authors to account for the surface anisotropy of other natural surfaces. It is shown that this formulation is appropriate to successfully explain the specular characteristics of other rough surfaces as well as that of the ocean. The angular dependence of the diffuse component of the reflected radiance is explained using the Ahmad-Deering formulation, which is based on Chandrasekhar's radiative transfer solution. Results for a smooth silt-playa lake bed in a volcanic region of Nevada are presented. It is shown that this formulation is capable of explaining the specular features measured in the field and can be effectively used in any surface bidirectional reflectance model.

Ahmad, Suraiya P.↗
NASA NTRS1992

In-flight radiometry of an airborne multispectral sensor

The in-flight radiometric behavior of the NS001 Landsat Thematic Mapper simulator is being reexamined. The absolute radiometric calibration and polarization sensitivity are being analyzed based on data collected in 1990 and 1991. The NS001 has continuously variable gain settings controlled by the aircraft operator. As such, the of in-flight calibration source, an integrating sphere in the solar reflective spectrum, is the only means for calibrating this instrument. Upgrades to the power supply and monitoring circuitry in 1990 improved the in-flight stability. Preliminary results in-flight calibrations of the NS001 indicate no improvement in radiometric accuracy. Laboratory tests have also shown that the NS001 shows strong sensitivity to the degree of polarization and state of the incoming radiations. Simulation studies for typical in-flight conditions have shown that for the NS001 scanning in the principal plane of the sun over a vegetated target, radiance errors reached +/-10 percent in the 0.45-0.52-micron channel and varied with scan angle.

Markham, Brian L.↗
NASA NTRS1991

Radiometric calibration of an airborne multispectral scanner

The absolute radiometric calibration of the NS001 Thematic Mapper Simulator reflective channels was examined based on laboratory tests and in-flight comparisons to ground measurements. The NS001 data are calibrated in-flight by reference to the NS001 internal integrating sphere source. This source's power supply or monitoring circuitry exhibited greater instability in-flight during 1988-1989 than in the laboratory. Extrapolating laboratory behavior to in-flight data resulted in 7-20 percent radiance errors relative to ground measurements and atmospheric modeling. Assuming constancy in the source's output between laboraotry and in-flight resulted in generally smaller errors. Upgrades to the source's power supply and monitoring circuitry in 1990 improved its in-flight stability, though in-flight ground reflectance based calibration tests have not yet been performed.

Markham, Brian L.↗
NASA NTRS1990

Radiometric properties of the NS001 Thematic Mapper Simulator aircraft multispectral scanner

Laboratory tests of the NS001 TM are described emphasizing absolute calibration to determine the radiometry of the simulator's reflective channels. In-flight calibration of the data is accomplished with the NS001 internal integrating-sphere source because instabilities in the source can limit the absolute calibration. The data from 1987-89 indicate uncertainties of up to 25 percent with an apparent average uncertainty of about 15 percent. Also identified are dark current drift and sensitivity changes along the scan line, random noise, and nonlinearity which contribute errors of 1-2 percent. Uncertainties similar to hysteresis are also noted especially in the 2.08-2.35-micron range which can reduce sensitivity and cause errors. The NS001 TM Simulator demonstrates a polarization sensitivity that can generate errors of up to about 10 percent depending on the wavelength.

Markham, Brian L.↗
NASA NTRS1990

Diurnal patterns of the bi-directional reflectance of fresh-water ice

To improve the interpretation of surface cryospheric albedo from satellite sensor data, diurnal measurements of the spectral bidirectional reflectance of a commonly found fresh water ice type were made, from which hemispherical reflectance can be derived. The purpose of this study is to document its clear-sky, bidirectional reflectance characteristics in the visible (650-670 nm) and near-infrared (810-840 nm) region, assess the diurnal nature of the reflectance, and quantify the surface anisotropy. Bidirectional reflectances of the refrozen slush ice measured show a spectral dependence and change significantly with solar zenith angle. Considerable variation occurs at each view angle and among view angles throughout the day. Although diurnal reflectance patterns were similar in both bands, magnitudes varied greatly, being highest in the visible and lowest in the near-infrared region. With the exception of peak saturated (specular) values in the forward scatter direction, bidirectional reflectance was generally highest in the morning when the surface and the illumination were most diffuse in character.

Leshkevich, George A.↗
NASA NTRS1988

Radiometric calibration of the reflective bands of NS001-Thematic Mapper Simulator (TMS) and modular multispectral radiometers (MMR)

The NS001 Thematic Mapper Simulator scanner (TMS) and several modular multispectral radiometers (MMRs) are among the primary instruments used in the First ISLSCP (International Satellite Land Surface Climatology Project) Field Experiment (FIFE). The NS001 has a continuously variable gain setting. Calibration of the NS001 data is influenced by drift in the dark current level of up to six counts during a mirror scan at typical gain settings. The MMR instruments are being used in their 1 deg FOV configuration on the helicopter and 15 deg FOV on the ground.

Markham, Brian L.↗
NASA NTRS1987

Computation of diffuse sky irradiance from multidirectional radiance measurements

Accurate determination of the diffuse solar spectral irradiance directly above the land surface is important in characterizing the reflectance properties of these surfaces, especially vegetation canopies. This determination is also needed to infer the net radiation budget of the earth-atmosphere system above these surfaces. An algorithm is developed here for the computation of hemispheric diffuse irradiance using the measurements from an instrument called PARABOLA, which rapidly measures upwelling and downwelling radiances in three selected wavelength bands. The validity of the algorithm is established from simulations. The standard reference data set of diffuse radiances of Dave (1978), obtained by solving the radiative transfer equation numerically for realistic atmospheric models, is used to simulate PARABOLA radiances. Hemispheric diffuse irradiance is estimated from a subset of simulated radiances by using the algorithm described. The algorithm is validated by comparing the estimated diffuse irradiance with the true diffuse irradiance of the standard data set. The validations include sensitivity studies for two wavelength bands (visible, 0.65-0.67 micron; near infrared, 0.81-0.84 micron), different atmospheric conditions, solar elevations, and surface reflectances. In most cases the hemispheric diffuse irradiance computed from simulated PARABOLA radiances and the true irradiance obtained from radiative transfer calculations agree within 1-2 percent. This technique can be applied to other sampling instruments designed to estimate hemispheric diffuse sky irradiance.

Ahmad, Suraiya P.↗