Search NASA⌕ Search

Engineering topics

Ahtye, W. F.

Publications and source records attributed to Ahtye, W. F..

15 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Large scale model measurements of airframe noise using cross-correlation techniques

Cross-correlation techniques are used to measure the sound radiated by wing/flap airfoil configurations in the NASA-Ames 40 x 80 ft wind tunnel using a 6.7-m semispan model with three deployed flaps. The dominant source of flap noise is identified as the flap side edges, which exceeds that radiated by the midspan region by more than 10 dB. The turbulent surface eddies at the flap side edge have scales on the order of one-half the flap chord. The installation of flap actuator fairings at the flap side edge reduces the noise radiated from that location by 10 to 15 dB. The cross-correlation technique extracts airframe noise radiated by specific surface locations from the tunnel background noise, even when the noise is 25 dB higher than the measured airframe noise level.

Miller, W. R.↗
NASA NTRS1980

A measurement of forward-flight effects on the noise from a JT15D-1 turbofan engine in the NASA-Ames 40- by 80-Foot Wind Tunnel

A Pratt and Whitney JT15D-1 turbofan engine was tested in two facilities at Ames Research Center: the outdoor Static Test Facility and the 40- by 80-Foot Wind Tunnel. The primary purposes of the test were to determine the effects of forward velocity on the turbofan spectra in the forward quadrant for the cruise inlet and to compare these wind-tunnel spectra with outdoor spectra to determine the possibility of simulating forward-velocity effects from purely outdoor measurements. The wind-tunnel data show a reduction in the blade-passage frequency tones of the order of 10 dB with increasing forward velocity at subsonic fan-tip speeds. No forward-velocity variation was observed at supersonic tip speeds. Comparison of in-duct spectra for the cruise inlet at forward velocity, with spectra from outdoor tests with a distortion-control inlet shows excellent agreement for the in-duct data when allowance is made for different in-duct volumes. This is also reflected in good agreement for the far-field spectra at small forward angles. The comparisons of wind-tunnel and outdoor data also indicate that at least for the JT15D-1, it may be possible to approximate the shape of the far-field spectra at large directivity angles from an outdoor measurement with the cruise inlet, providing an effective inflow control device is used.

Ahtye, W. F.↗
NASA NTRS1980

Evaluation of approximate methods for the prediction of noise shielding by airframe components

An evaluation of some approximate methods for the prediction of shielding of monochromatic sound and broadband noise by aircraft components is reported. Anechoic-chamber measurements of the shielding of a point source by various simple geometric shapes were made and the measured values compared with those calculated by the superposition of asymptotic closed-form solutions for the shielding by a semi-infinite plane barrier. The shields used in the measurements consisted of rectangular plates, a circular cylinder, and a rectangular plate attached to the cylinder to simulate a wing-body combination. The normalized frequency, defined as a product of the acoustic wave number and either the plate width or cylinder diameter, ranged from 4.6 to 114. Microphone traverses in front of the rectangular plates and cylinders generally showed a series of diffraction bands that matched those predicted by the approximate methods, except for differences in the magnitudes of the attenuation minima which can be attributed to experimental inaccuracies. The shielding of wing-body combinations was predicted by modifications of the approximations used for rectangular and cylindrical shielding. Although the approximations failed to predict diffraction patterns in certain regions, they did predict the average level of wing-body shielding with an average deviation of less than 3 dB.

Ahtye, W. F.↗
NASA NTRS1980

Noise generation by a lifting wing/flap combination at Reynolds numbers to 2.8 x 10 to the 6th

Measurements relating to the noise source location and intensity within various frequency bands were made for an 0.75 m-chord wing/flap model installed in the Ames 7 x 10-foot wind tunnel. A directional microphone system, located outside the open-wall tunnel was scanned in a two-dimensional array of aiming points about the positive-pressure side of the model to determine the principal locations of noise production, and the intensity of each of these. It was found for the case of the flaps being differentially deflected (0 deg, 35 deg) at the half-span station that noise production was concentrated in the immediate region of the resultant surface discontinuity. For equal deflection of the halves (0 deg, 0 deg or 35 deg, 35 deg), noise was produced uniformly along the length of the gap between the wing and the flap. Simulated flap-mounting brackets generated considerable noise in certain cases, but reduced the noise in others. Trailing edge noise did not appear to be important in comparison with other sources.

Kendall, J. M.↗
NASA NTRS1976

Correlation microphone for measuring airframe noise in large-scale wind tunnels

A correlation microphone arrangement was used in the test section of the Ames 7- by 10-Foot and 40- by 80-Foot Wind Tunnels in an attempt to reject the reverberant and wind noise. The tests in the 7- by 10-foot wind tunnel covered a frequency range from 400 Hz to 8 kHz while the tests in the 40- by 80-foot tunnel covered the range from 31.5 to 800 Hz. Examination of the experimental data plus calculations of cross-correlations due to reflective noise indicate that the correlation microphone is effective in rejecting microphone wind noise and reverberant noise even at low frequencies, and that the low-frequency background noise monitored by the correlation microphone is reflected noise with a preferred direction from the tunnel drive system. Design studies indicate that this tunnel drive noise can be reduced substantially through suitable modification of the drive fans and acoustical treatment of the nacelles that house these fans.

Ahtye, W. F.↗
NASA NTRS1975

The accuracy of far-field noise obtained by the mathematical extrapolation of near-field noise data

Results are described of an analytical study of the accuracy and limitations of a technique that permits the mathematical extrapolation of near-field noise data to far-field conditions. The effects of the following variables on predictive accuracy of the far-field pressure were examined: (1) number of near-field microphones; (2) length of source distribution; (3) complexity of near-field and far-field distributions; (4) source-to-microphone distance; and (5) uncertainties in microphone data and imprecision in the location of the near-field microphones. It is shown that the most important parameters describing predictive accuracy are the number of microphones, the ratio of source length to acoustic wavelength, (L/wavelength), and the error in location of near-field microphones. If microphone measurement and location errors are not included, then far-field pressures can be accurately predicted up to L/wavelength values of 15 using approximately 50 microphones. For maximum microphone location errors of + or - 1 cm, only an accuracy of + or - 2-1/2 db can be attained with approximately 40 microphones for the highest L/wavelength of 10.

Ahtye, W. F.↗
NASA NTRS1975

The accuracy of far-field noise obtained by the mathematical extrapolation of near-field noise data

Results are presented for an analytical study of the accuracy and limitations of a technique that permits the mathematical extrapolation of near-field noise data to far-field conditions. The effects of the following variables on predictive accuracy of the far-field pressure were examined: (1) number of near-field microphones; (2) length of source distribution; (3) complexity of near-field and far-field distributions; (4) source-to-microphone distance; and (5) uncertainties in microphone data and imprecision in the location of the near-field microphones. It is shown that the most important parameters describing predictive accuracy are the number of microphones, the ratio of source length to acoustic wavelength (L/lambda), and the error in location of near-field microphones. For maximum microphone location errors of plus or minus 1 cm, only an accuracy of plus or minus 2.5 dB can be attained with approximately 40 microphones for the highest L/lambda of 10.

Ahtye, W. F.↗
NASA NTRS1972

Thermal conductivity in vibrationally excited gases.

Comparisons between experimental and theoretical values of the thermal conductivity for a series of nonpolar polyatomic gases show large discrepancies at higher temperatures where the vibrational contribution becomes increasingly important. Examination of various theoretical approaches indicates that the discrepancies can be attributed to approximating the coefficient characterizing the diffusion of vibrational energy, D sub vib, by the self-diffusion coefficient. The present theories cannot accurately predict D sub vib, and its measurement is extremely difficult. Consequently, the approach adopted by the author is to obtain D sub vib by using experimental values of the thermal conductivity. An attempt is made to correlate these values of D sub vib with vibrational relaxation time, so that values of D sub vib can be obtained for all nonpolar polyatomic gases.

Ahtye, W. F.↗