Tensile and compressive tests of magnesium alloy J-1 sheet
Explore the source record for details and available documents.
Aitchison, C S↗
Engineering topics
Aitchison, C S
Publications and source records attributed to Aitchison, C S.
A Subpress for Compressive Tests
A subpress for compressive tests is described. The subpress was designed primarily for use in developing and investigating methods for testing thin sheet metal in compression. Provision was made for testing fixed-end and flat-end specimens with or without various types of lateral support against buckling. Compressive stress-strain data for a sheet of 0.032-inch 24S-RT aluminum alloy were obtained with the subpress by the pack method and by the single-thickness method. The data showed small scatter and the stress-strain curves obtained by the two methods were in close agreement.
Aitchison, C S↗
Extension of Pack Method for Compressive Tests
The pack method for determining compressive stress-strain graphs described in NACA Report No. 649 has been modified to extend it's application to thinner gages and stronger materials. The principal modifications consisted in the provision of additional support against instability cementing the specimens of the pack together with fused shellac and the provision of special clamps to hold the specimens together while the test is in progress. The shellac was found to increase the buckling load of the pack without any appreciable effect on the compressive stress-strain graph of the material. The extended pack method described in this note has made possible the application of stresses in excess of 220 kips per square inch to sheet material having a thickness of only 0.02 inch.
Aitchison, C S↗
The Pack Method for Compressive Tests of Thin Specimens of Materials Used in Thin-Wall Structures
The strength of modern lightweight thin-wall structures is generally limited by the strength of the compression members. An adequate design of these members requires a knowledge of the compressive stress-strain graph of the thin-wall material. The "pack" method was developed at the National Bureau of Standards with the support of the National Advisory Committee for Aeronautics to make possible a determination of compressive stress-strain graphs for such material. In the pack test an odd number of specimens are assembled into a relatively stable pack, like a "pack of cards." Additional lateral stability is obtained from lateral supports between the external sheet faces of the pack and outside reactions. The tests seems adequate for many problems in structural research.
Aitchison, C S↗