Engineering topics

Ajo, Henry

Publications and source records attributed to Ajo, Henry.

3 records

DOE OSTI2024

Magnetic properties of Lutetium and Yttrium doped Ce 2 Fe 14 B magnets

The increasing demand for Nd-Dy and Sm-Co based permanent magnets is exacerbating the current critical materials shortage, therefore improving and optimizing current candidate critical element free permanent magnets is necessary to develop future clean energy technologies. In this work, we aim to increase the thermal stability and magnetic performance of Ce 2 Fe 14 B based permanent magnets through the substitution of Ce ions with noncritical rare earth elements Lu and Y. The substitution of Lu (x=0; 0.05; 0.1; 0.15) for Ce ions in (LuxCe 2-x )Fe 14 B was unsuccessful, likely due to disparities in ionic size and valencies, and failed to exhibit improved thermal stability or magnetic performance. In contrast, Y substitution for Ce ions in (Y x Ce 2-x )Fe14B (x= 0.1; 0.2; 0.3; 0.4; 0.5) alloys was successful. Notably, these alloys demonstrated enhanced thermal stability, as evidenced by an increase in the Curie temperature, reaching a peak of 443 K at x= 0.5. Y substitution also helped to suppress the CeFe2 Laves phase. Without loss of the anisotropy field Y substitution increased the saturation magnetization, MS, peaking at MS = 125 emu/g for a Y concentration of x= 0:4, demonstrating (Y 0.4 Ce 1.6 )Fe 14 B as a potential critical element free permanent magnet with an energy product as high as 29 MGOe. This work is advantageous in developing low cost high performance permanent magnets with reduced or little to no critical rare earth elements.

Rai, Binod K.↗

DOE OSTI2023

Structure and properties of NdCuGa 3 single crystals

Here this manuscript reports on the structural and magnetic properties of NdCuGa 3 using powder and single crystal X-ray diffraction (XRD), zero-field single crystal neutron diffraction, magnetization, and specific heat measurements. Our XRD on a single crystal specimen of NdCuGa3 confirmed that it crystallizes in the tetragonal BaNiSi 3 -type structure. A magnetic phase transition at T N = 3.3 K is assessed using specific heat and ac magnetic susceptibility measurements. No additional anomaly below T N down to 50 mK was detected by performing specific heat measurements. Neutron single crystal diffraction data collected at T = 300 mK confirm the antiferromagnetic phase below T N = 3.3 K with the propagation vector $\vec{\tau}$ = (0.2, 0, 0). Possible magnetic structure solutions of NdCuGa 3 are discussed

36 MATERIALS SCIENCE↗

DOE OSTI2021

Growth and Development of Quantum Materials

Topological insulators (TIs) display a new state of quantum matter, which is broadly known as quantum materials. The TIs have a unique property of being an insulator as a bulk property and having conducting surface states, which are symmetry-protected Dirac Fermions and well isolated from the bulk valence and conduction bands. Ideally, these topological surface states and bulk electronic states should act independently. The degree to which they intermix depends on the crystalline quality, composition and defects present in the material. These materials thus demand very high-quality crystals to observe the desired quantum properties. We proposed growth of high-quality single crystals and thin films to enhance the ability to fabricate devices with unique performance attributes. Two separate approaches will be made to make the thin films, one is exfoliation of 2D monolayer from the grown single crystals and the second is thin films grown by pulsed laser deposition. Both techniques will subsequently allow for fabrication of meso structures using a Focused Ion Beam technique.

36 MATERIALS SCIENCE↗