Engineering topics

Allbrooks, Martha K.

Publications and source records attributed to Allbrooks, Martha K..

9 records

NASA NTRS1993

Damage areas on selected LDEF aluminum surfaces

With the U.S. about to embark on a new space age, the effects of the space environment on a spacecraft during its mission lifetime become more relevant. Included among these potential effects are degradation and erosion due to micrometeoroid and debris impacts, atomic oxygen and ultraviolet light exposure as well as material alteration from thermal cycling, and electron and proton exposure. This paper focuses on the effects caused by micrometeoroid and debris impacts on several LDEF aluminum plates from four different bay locations: C-12, C-10, C-01, and E-09. Each plate was coated with either a white, black, or gray thermal paint. Since the plates were located at different orientations on the satellite, their responses to the hypervelocity impacts varied. Crater morphologies range from a series of craters, spall zones, domes, spaces, and rings to simple craters with little or no spall zones. In addition, each of these crater morphologies is associated with varying damage areas, which appear to be related to their respective bay locations and thus exposure angles. More than 5% of the exposed surface area examined was damaged by impact cratering and its coincident effects (i.e., spallation, delamination and blow-off). Thus, results from this analysis may be significant for mission and spacecraft planners and designers.

Coombs, Cassandra R.↗

NASA NTRS1992

Meteoroid and debris special investigation group data acquisition procedures

The entire LDEF spacecraft was examined by M&D SIG for impact (i.e., craters greater than or = 0.5 mm and penetrations greater than or = 0.3 mm in diameter) and related features (e.g., debris, secondaries). During the various detailed surveys conducted at NASA Kennedy, approx. 5,000 impact related features were photodocumented, and their locations measured and recorded; an additional approx. 30,000 smaller features were counted. The equipment and techniques used by the M&D SIG permitted the determination and recording of the locations and diameters of the 5,000 imaged features. A variety of experimental and LDEF structural hardware was acquired by the M&D SIG and is presently being examined and curated at NASA Johnson.

See, Thomas H.↗

NASA NTRS1992

Meteoroid, and debris special investigation group preliminary results: Size-frequency distribution and spatial density of large impact features on LDEF

All craters greater than or equal to 500 microns and penetration holes greater than or equal to 300 microns in diameter on the entire Long Duration Exposure Facility (LDEF) were documented. Summarized here are the observations on the LDEF frame, which exposed aluminum 6061-T6 in 26 specific directions relative to LDEF's velocity vector. In addition, the opportunity arose to characterize the penetration holes in the A0178 thermal blankets, which pointed in nine directions. For each of the 26 directions, LDEF provided time-area products that approach those afforded by all previous space-retrieved materials combined. The objective here is to provide a factual database pertaining to the largest collisional events on the entire LDEF spacecraft with a minimum of interpretation. This database may serve to encourage and guide more interpretative efforts and modeling attempts.

See, Thomas H.↗

NASA NTRS1992

LDEF data correlation to existing NASA debris environment models

The Long Duration Exposure Facility (LDEF) was recovered in January 1990, following 5.75 years exposure of about 130 sq. m to low-Earth orbit. About 25 sq. m of this surface area was aluminum 6061 T-6 exposed in every direction. In addition, about 17 sq. m of Scheldahl G411500 silver-Teflon thermal control blankets were exposed in 9 of the 12 directions. Since the LDEF was gravity gradient stabilized and did not rotate, the directional dependence of the flux can be easily distinguished. During the disintegration of the LDEF, all impact features larger than 0.5 mm into aluminum were documented for diameters and locations. In addition, the diameters and locations of all impact features larger than 0.3 mm into Scheldahl G411500 thermal control blankets were also documented. This data, along with additional information collected from LDEF materials will be compared with current meteoroid and debris models. This comparison will provide a validation of the models and will identify discrepancies between the models and the data.

Atkinson, Dale R.↗

NASA NTRS1992

Preliminary micrometeoroid and debris effects on LDEF thermal control surfaces

Thermal control surfaces returned from space exhibited synergistic effects of simultaneous exposure to various natural environments. The thermal control surfaces of the Long Duration Exposure Facility (LDEF) were exposed to 5.75 years of low Earth orbit environments. Since LDEF was gravity-gradient stabilized and directionally stable (i.e., no rotation), the effects of each of the environments (meteoroid and space debris impacts, thermal cycling, atomic oxygen, and ultraviolet light exposure) can be distinguished via changes in material responses to hypervelocity impacts. The extent of these impacts are being visually and microscopically characterized using thermal control surfaces archived at NASA Johnson Space Center (JSC) in order to determine the relationship between environment exposure and resulting ring sizes, delamination areas, and penetration diameters. The characterization of these affected areas will provide spacecraft system designers with the information they require to determine degradation of thermal control systems during satellite lifetimes.

Allbrooks, Martha K.↗

NASA NTRS1991

Meteoroid and orbital debris record of the Long Duration Exposure Facility

The Long Duration Exposure Facility (LDEF) was recovered in January 1990 following 5.7 years exposure of approx. 130 square meters of surface area in low-Earth orbit (250-179 miles). Kennedy Space Center acquired data are currently being reduced to yield accurate impact crater depths and diameters. Presented here is a preliminary accounting of the impact record based on the approx. 15.4 square meter surface area of LDEF's 6061-T6 aluminum frame, which was exposed in 26 different directions.

Zolensky, Mike↗

NASA NTRS1991

LDEF data correlation to existing NASA debris environment models

Since the Long Duration Exposure Facility was gravity gradient stabilized and did not rotate, the directional dependence of the flux can be easily distinguished. During the deintegration of LDEF, all impact features larger than 0.5 mm into aluminum were documented for diameters and locations. In addition, all diameters and locations of all impact features larger than 0.3 mm into Scheldahl G411500 thermal control blankets were also documented. This data, along with additional information collected from LDEF materials archived at NASA Johnson Space Center (JSC) on smaller features, will be compared with current meteoroid and debris models. This comparison will provide a validation of the models and will identify discrepancies between the models and the data.

Atkinson, Dale R.↗

NASA NTRS1991

M and D SIG progress report: Laboratory simulations of LDEF impact features

Reported here are impact simulations into pure Teflon and aluminum targets. These experiments will allow first order interpretations of impact features on the Long Duration Exposure Facility (LDEF), and they will serve as guides for dedicated experiments that employ the real LDEF blankets, both unexposed and exposed, for a refined understanding of the Long Duration Exposure Facility's collisional environment.

Horz, Friedrich↗

NASA NTRS1991

Preliminary micrometeoroid and debris effects on LDEF thermal control surfaces

Thermal control surfaces on the Long Duration Exposure Facility (LDEF) were exposed to 5.75 years of low-Earth orbit environments. Since LDEF was gravity gradient stabilized and directionally stable, the effects of each of the environments can be distinguished via changes in material responses to hypervelocity impacts. The extent of these effects are being visually and microscopically characterized using thermal control surfaces archived at Johnson Space Center in order to determine the the relationship between environment exposure and resulting ring sizes, delamination areas, and penetration diameters. The characterization of these affected areas will provide spacecraft system designers with the information they require to determine degradation of thermal control systems during satellite lifetimes.

Allbrooks, Martha K.↗