Search NASA⌕ Search

Engineering topics

Allen, M.

Publications and source records attributed to Allen, M..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1996

Stratospheric NO and NO2 Abundances from ATMOS Solar-Occultation Measurements

Using results from a time-dependent photochemical model to calculate the diurnal variation of NO and NO2, we have corrected Atmospheric Trace MOlecule Spectroscopy (ATMOS) solar-occultation retrievals of the NO and NO2 abundances at 90' solar zenith angle. Neglecting to adjust for the rapid variation of these gases across the terminator results in potential errors in retrieved profiles of approximately 20% for NO2 and greater than 100% for NC at altitudes below 25 km. Sensitivity analysis indicates that knowledge of the local 03 and temperature profiles, rather than zonal mean or climatological conditions of these quantities, is required to obtain reliable retrievals of NO and NO2 in the lower stratosphere. Extremely inaccurate 03 or temperature values at 20 km can result in 50% errors in retrieved NO or NO2. Mixing ratios of NO in the mid-latitude, lower stratosphere measured by ATMOS during the November 1994 ATLAS-3 mission compare favorably with in situ ER-2 observations, providing strong corroboration of the reliability of the adjusted space-borne measurements.

Newchurch, M. J.↗
NASA NTRS1996

The Atmospheric Trace Molecule Spectroscopy (ATMOS) Experiment: Deployment on the ATLAS Space Shuttle Missions

The ATMOS Fourier transform spectrometer was flown for a fourth time on the Space Shuttle as part of the ATLAS-3 instrument payload in November 1994. More than 190 sunrise and sunset occultation events provided measurements of more than 30 atmospheric trace gases at latitudes 3 - 49 deg N and 65 - 72 deg S, including observations both inside and outside the Antarctic polar vortex. The instrument configuration, data retrieval methodology, and mission background are described to place in context analyses of ATMOS data presented in this issue.

Gunson, M. R.↗
NASA NTRS1996

Hydrocarbon photochemistry in the upper atmosphere of Jupiter

The hydrocarbon photochemistry in the upper atmosphere of Jupiter is investigated using a one-dimensional, photochemical-diffusive, and diurnally averaged model. The important chemical cycles and pathways among the major species are outlined and a standard model for the North Equatorial Belt region is examined in detail. It is found that several traditionally dominant chemical pathways among the C and C2 species are replaced in importance by cycles involving C-C4 species. The pressure and altitude profiles of mixing ratios for several observable hydrocarbon species are compared with available ultraviolet- and infrared-derived abundances. The results of sensitivity studies on the standard model with respect to variations in eddy diffusion profile, solar flux, atomic hydrogen influx, latitude, temperature, and important chemical reaction rates are presented. Measured and calculated airglow emissions of He at 584 angstroms and H at 1216 angstroms are also used to provide some constraints on the range of model parameters. The relevance of the model results to the upcoming Galileo mission is briefly discussed. The model is subject to considerable improvement; there is a great need for laboratory measurements of basic reaction rates and photodissociation quantum yields, even for such simple species as methylacetylene and allene. Until such laboratory measurements exist there will be considerable uncertainty in the understanding of the C3 and higher hydrocarbons in the atmospheres of the jovian planets.

NASA Discipline Number 52-20↗
NASA NTRS1996

Stratospheric NO and NO(sub 2) Abundances from ATMOS Solar-Occultation Measurements

Using results from a time-dependent photochemical model to calculate the diurnal variation of NO and NO(sub 2), we have corrected Atmospheric Trace Molecule Spectroscopy (ATMOS) solar-occultation retrievals of the NO and NO(sub 2) abundances at 90 solar zenith angle. Neglecting to adjust for the rapid variation of these gases across the terminator results in potential errors in retrieved profiles of approx. 20 percent for NO(sub 2) and greater than 100 percent for NO at altitudes below 25 KM.

NO NO2 ATMOS↗
NASA NTRS1994

Balloon profiles of stratospheric NO2 and HNO3 for testing the heterogeneous hydrolysis of N2O5 on sulfate aerosols

Simultaneous in situ measurements of stratospheric NO2, HNO3, HCl, and CH4 from 34 to 24 km were made in August 1992 from Palestine, Texas, using the Balloon-borne Laser In-Situ Sensor (BLISS) tunable diode laser spectrometer. Although the measurements of NO2, HNO3, and NO2/HNO3 agree well with gas-phase model calculations near 34 km where Stratospheric Aerosol and Gas Experiment (SAGE) 2 data show little sulfate aerosol, this is not true at the lower altitudes where SAGE 2 shows high aerosol loadings. At 24 km the BLISS NO2 and HNO3 measurements are 70% lower and 50% higher, respectively, than the gas phase model predictions, with a measured NO2/HNO3 ratio 5 times smaller. When the heterogeneous hydrolysis of N2O5 and ClONO2 on sulfate aerosol of surface area densities matching the SAGE 2 measurements is added to the model, good agreement with the BLISS measurements is found over the whole altitude range.

Webster, C. R.↗
NASA NTRS1994

H2O-Rich Interstellar Grain Mantles: An Equilibrium Picture

Experiments simulating the codeposition of molecular hydrogen and water ice on interstellar grains demonstrate that amorphous water ice at 12 K can incorporate a substantial amount of H2, up to a molar ratio of H2/H2O=0.53.

molecular hydrogen↗
NASA NTRS1993

Photodissociation in the atmosphere of Mars - Impact of high resolution, temperature-dependent CO2 cross-section measurements

We have investigated the impact of high resolution, temperature-dependent CO2 cross-section measurements, reported by Lewis and Carver (1983), on calculations of photodissociation rate coefficients in the Martian atmosphere. We find that the adoption of 50 A intervals for the purpose of computational efficiency results in errors in the calculated values for photodissociation of CO2, H2O, and O2 which are generally not above 10 percent, but as large as 20 percent in some instances. These are acceptably small errors, especially considering the uncertainties introduced by the large temperature dependence of the CO2 cross section. The inclusion of temperature-dependent CO2 cross sections is shown to lead to a decrease in the diurnally averaged rate of CO2 photodissociation as large as 33 percent at some altitudes, and increases of as much as 950 percent and 80 percent in the photodissociation rate coefficients of H2O and O2, respectively. The actual magnitude of the changes depends on the assumptions used to model the CO2 absorption spectrum at temperatures lower than the available measurements, and at wavelengths longward of 1970 A.

Anbar, A. D.↗
NASA NTRS1993

Micro-opto-mechanical devices and systems using epitaxial lift off

The integration of high quality, single crystal thin film gallium arsenide (GaAs) and indium phosphide (InP) based photonic and electronic materials and devices with host microstructures fabricated from materials such as silicon (Si), glass, and polymers will enable the fabrication of the next generation of micro-opto-mechanical systems (MOMS) and optoelectronic integrated circuits. Thin film semiconductor devices deposited onto arbitrary host substrates and structures create hybrid (more than one material) near-monolithic integrated systems which can be interconnected electrically using standard inexpensive microfabrication techniques such as vacuum metallization and photolithography. These integrated systems take advantage of the optical and electronic properties of compound semiconductor devices while still using host substrate materials such as silicon, polysilicon, glass and polymers in the microstructures. This type of materials optimization for specific tasks creates higher performance systems than those systems which must use trade-offs in device performance to integrate all of the function in a single material system. The low weight of these thin film devices also makes them attractive for integration with micromechanical devices which may have difficulty supporting and translating the full weight of a standard device. These thin film devices and integrated systems will be attractive for applications, however, only when the development of low cost, high yield fabrication and integration techniques makes their use economically feasible. In this paper, we discuss methods for alignment, selective deposition, and interconnection of thin film epitaxial GaAs and InP based devices onto host substrates and host microstructures.

Camperi-Ginestet, C.↗
NASA NTRS1993

Nonintrusive, multipoint velocity measurements in high-pressure combustion flows

A combined experimental and analytical effort was conducted to demonstrate the applicability of OH Doppler-shifted fluorescence imaging of velocity distributions in supersonic combustion gases. The experiments were conducted in the underexpanded exhaust flow from a 6.8 atm, 2400 K, H2-O2-N2 burner exhausting into the atmosphere. In order to quantify the effects of in-plane variations of the gas thermodynamic properties on the measurement accuracy, a set of detailed measurements of the OH (1,0) band collisional broadening and shifting in H2-air gases was produced. The effect of pulse-to-pulse variations in the dye laser bandshape was also examined in detail and a modification was developed which increased in the single pulse bandwidth, thereby increasing the intraimage velocity dynamic range as well as reducing the sensitivity of the velocity measurement to the gas property variations. Single point and imaging measurements of the velocity field in the exhaust flowfield were compared with 2D, finite-rate kinetics simulations of the flowfield. Relative velocity accuracies of +/- 50 m/s out of 1600 m/s were achieved in time-averaged imaging measurements of the flow over an order of magnitude variation in pressure and a factor of two variation in temperature.

Allen, M.↗
NASA NTRS1993

Molecular Hydrogen-Rich Interstellar Ice

While molecular hydrogen is by far the most abundant gas phase molecule in interstellar dark clouds, the extreme volatility of H(sub 2) suggests that it has a relatively low abundance in grain volatile mantles, thought to be composed largely of amorphous water ice.

interstellar chemistry temperature programmed deso↗