Search NASA⌕ Search

Engineering topics

Altenkirch, Robert A.

Publications and source records attributed to Altenkirch, Robert A..

12 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1999

DARTFire Sees Microgravity Fires in a New Light--Large Data Base of Images Obtained

The recently completed DARTFire sounding rocket microgravity combustion experiment launched a new era in the imaging of flames in microgravity. DARTFire stands for "Diffusive and Radiative Transport in Fires," which perfectly describes the two primary variables--diffusive flow and radiation effects--that were studied in the four launches of this program (June 1996 to September 1997). During each launch, two experiments, which were conducted simultaneously during the 6 min of microgravity, obtained results as the rocket briefly exited the Earth s atmosphere.

Olson, Sandra L.↗
NASA NTRS1997

Solid Surface Combustion Experiment: Thick Fuel Results

The results of experiments for spread over polymethylmethacrylate, PMMA, samples in the microgravity environment of the Space Shuttle are described. The results are coupled with modelling in an effort to describe the physics of the spread process for thick fuels in a quiescent, microgravity environment and uncover differences between thin and thick fuels. A quenching phenomenon not present for thin fuels is delineated, namely the fact that for thick fuels the possibility exists that, absent an opposing flow of sufficient strength to press the flame close enough to the fuel surface to allow the heated layer in the solid to develop, the heated layer fails to become 'fully developed.' The result is that the flame slows, which in turn causes an increase in the relative radiative loss from the flame, leading eventually to extinction. This potential inability of a thick fuel to develop a steady spread rate is not present for a thin fuel because the heated layer is the fuel thickness, which reaches a uniform temperature across the thickness relatively rapidly.

Altenkirch, Robert A.↗
NASA NTRS1997

Diffusive and Radiative Transport in Fires Experiment: DARTFire

A low velocity, opposed-flow, flame spread experiment designed for execution on a sounding rocket is described. Early results of infrared and ultraviolet-visible imaging using video cameras and narrow band filters are described along with planned digital image data reduction. Measured and computed spread rates show that the classical thermal regime for flame spread over thick PMMA persists, for 50% O2, down to about 5 cm/s, at which point a transition to a microgravity regime in which radiation eventually leads to extinction in at least a quiescent environment. The microgravity regime of flame spread is then distinct from the thermal and kinetic regimes previously identified.

Olson, Sandra L.↗
NASA NTRS1995

Solid surface combustion experiment flame spread in a quiescent, microgravity environment implications of spread rate and flame structure

A unique environment in which flame spreading, a phenomenon of fundamental, scientific interest, has importance to fire safety is that of spacecraft in which the gravitational acceleration is low compared with that of the Earth, i.e., microgravity. Experiments aboard eight Space Shuttle missions between October 1990 and February 1995 were conducted using the Solid Surface Combustion Experiment (SSCE) payload apparatus in an effort to determine the mechanisms of gas-phase flame spread over solid fuel surfaces in the absence of any buoyancy induced or externally imposed oxidizer flow. The overall SSCE effort began in December of 1984. The SSCE apparatus consists of a sealed container, approximately 0.039 cu m, that is filled with a specified O2/N2 mixture at a prescribed pressure. Five of the experiments used a thin cellulosic fuel, ashless filter paper, 3 cm wide x 10 cm long, 0.00825 cm half-thickness, ignited in five different ambient conditions. Three of the experiments, the most recent, used thick polymethylmethacrylate (PMMA) samples 0.635 cm wide x 2 cm long, 0.32 cm half-thickness. Three experiments, STS 41, 40 and 43, were designed to evaluate the effect of ambient pressure on flame spread over the thin cellulosic fuel while flights STS 50 and 47 were at the same pressure as two of the earlier flights but at a lower oxygen concentration in order to evaluate the effect of ambient oxygen level on the flame spread process at microgravity. For the PMMA flights, two experiments, STS 54 and 63, were at the same pressure but different oxygen concentrations while STS 64 was at the same oxygen concentration as STS 63 but at a higher pressure. Two orthogonal views of the experiments were recorded on 16 mm cine-cameras operating at 24 frames/s. In addition to filmed images of the side view of the flames and surface view of the burning samples, solid- and gas-phase temperatures were recorded using thermocouples. The experiment is battery powered and follows an automated sequence upon activation by the Shuttle Crew. In this study we separate the SSCE data into two groups according to the fuel type: (1) thin cellulose; and (2) thick PMMA. The experimental spread rates are compared with prediction from a number of models in an effort to uncover the important physics that characterize microgravity flame spread. Both steady and unsteady solutions are employed to explore the flame evolution, especially for thick fuels. Finally, the flame structure in downward spread is compared with the microgravity flame structure and modeling results to delineate the difference between the two configurations and the influence of normal gravity.

Bundy, Matthew↗
NASA NTRS1995

Low velocity opposed-flow frame spread in a transport-controlled environment DARTFire

The overall objectives of the DARTFire project are to uncover the underlying physics and increase understanding of the mechanisms that cause flames to propagate over solid fuels against a low velocity of oxidizer flow in a low-gravity environment. Specific objectives are (1) to analyze experimentally observed flame shapes, measured gas-phase field variables, spread rates, radiative characteristics, and solid-phase regression rates for comparison with previously developed model prediction capability that will be continually extended, and (2) to investigate the transition from ignition to either flame propagation or extinction in order to determine the characteristics of those environments that lead to flame evolution. To meet the objectives, a series of sounding rocket experiments has been designed to exercise several of the dimensional, controllable variables that affect the flame spread process over PMMA in microgravity, i.e., the opposing flow velocity (1-20 cm/s), the external radiant flux directed to the fuel surface (0-2 W/cm(exp 2)), and the oxygen concentration of the environment (35-70%). Because radiative heat transfer is critical to these microgravity flame spread experiments, radiant heating is imposed, and radiant heat loss will be measured. These are the first attempts at such an experimental control and measurement in microgravity. Other firsts associated with the experiment are (1) the control of the low velocity, opposed flow, which is of the same order as diffusive velocities and Stefan flows; (2) state-of-the-art quantitative flame imaging for species-specific emissions (both infrared and ultraviolet) in addition to novel intensified array imaging to obtain a color image of the very dim, low-gravity flames.

West, Jeff↗
NASA NTRS1994

The solid surface combustion experiment aboard the USML-1 mission

AA Experimental results from the five experiments indicate that flame spread rate increases with increasing ambient oxygen content and pressure. An experiment was conducted aboard STS-50/USML-1 in the solid Surface Combustion Experiment (SSCE) hardware for flame spread over a thin cellulosic fuel in a quiescent oxidizer of 35% oxygen/65% nitrogen at 1.0 atm. pressure in microgravity. The USML-1 test was the fourth of five planned experiments for thin fuels, one performed during each of five Space Shuttle Orbiter flights. Data that were gathered include gas- and solid-phase temperatures and motion picture flame images. Observations of the flame are described and compared to theoretical predictions from steady and unsteady models that include flame radiation from CO2 and H2O. Experimental results from the five esperiments indicate that flame spread rate increases with increasing ambient oxygen content and pressure. The brightness of the flame and the visible soot radiation also increase with increasing spread rate. Steady-state numerical predictions of temperature and spread rate and flame structure trends compare well with experimental results near the flame's leading edge while gradual flame evolution is captured through the unsteady model.

Altenkirch, Robert A.↗
NASA NTRS1993

Opposed-Flow Flame Spreading in Reduced Gravity

Experimental results obtained in drop towers and in Space Shuttle based experiments coupled with modelling efforts are beginning to provide information that is allowing an understanding to be developed of the physics of opposed-flow flame spread at reduced gravity where the spread rate and flow velocity are comparable and of the role played by radiative and diffusive processes in flame spreading in microgravity. Here we describe one Space Shuttle based experiment on flame spreading in a quiescent environment, the Solid Surface Combustion Experiment, SSCE, one planned microgravity experiment on flame spreading in a radiatively-controlled, forced opposing flow environment, the Diffusive and Radiative Transport in Fires Experiment, DARTFire, modelling efforts to support these experiments, and some results obtained to date.

Altenkirch, Robert A.↗
NASA NTRS1991

Opposed Flow Flame Spread in Normal, Enhanced and Reduced Gravity

Experimental and theoretical aspects of opposed-flow flame spread over solid fuels are presented with emphasis on the microgravity environments of spacecraft. For high opposing flow velocities, spread rate decreases with increasing velocity eventually leading to flame blowoff due to kinetic effects. At low opposing flow velocities, where diffusional effects are slowed and radiation becomes important, flame spread rate increases with increasing flow velocity. Extinction at low velocities is due to radiative effects. Modeling efforts that include radiation, both solid surface radiation and gas-phase radiation, predict qualitatively the experimental trends observed. Computationally, gas-phase radiation is conveniently included in solution of the conservation equations by employing a Plank mean absorption coefficient, a fraction of radiation that is fed back to the surface, and a shape function that describes the radiative flux distribution along the surface.

Altenkirch, Robert A.↗
NASA NTRS1991

Radiation-Controlled, Opposed-Flow Flame Spread in a Microgravity Environment

The effects of surface and gas-phase radiation on the rate and the structure of laminar flame spread over thin fuels are investigated using a flame-spread model which consists of the continuity, momentum, species, and energy equations in the gas and the continuity and energy equations in the solid. Numerical calculations, complemented by scaling arguments, show that, at high velocities of the oxidizer flow, radiation effects are unimportant; the spread rate decreases with increasing opposing velocity due to finite-rate gas-phase kinetics. However, radiation becomes progressively important when the opposing velocity is below a certain value: the flame cools, shrinks in size, and its spread rate falls sharply with decreasing opposing velocity.

Bhattacharjee, Subrata↗
NASA NTRS1990

Opposed-flow flame spread with implications for combustion at microgravity

Various regimes of the flame spread phenomenon in an opposing flow environment are classified here depending on the mechanism of flame spread. Simple analyses of energy balances at the tip of the flame are used to complement more sophisticated numerical analysis of the field problem associated with flame spreading in microgravity. The microgravity flames are shown to constitute a separate regime or class by themselves and are discussed in some detail.

Altenkirch, Robert A.↗
NASA NTRS1988

Scientific support for an orbiter middeck experiment on solid surface combustion

The objective is to determine the mechanism of gas-phase flame spread over solid fuel surfaces in the absence of any buoyancy or externally imposed gas-phase flow. Such understanding can be used to improve the fire safety aspects of space travel by providing information that will allow judicious selections of spacecraft materials and environments to be made. The planned experiment consists of measuring the flame spread rate over thermally thin and thermally thick fuels in a closed container in the low-gravity environment of the Space Shuttle. Measurements consist of flame spread rate and shape obtained from two views of the process as recorded on movie film and surface and gas-phase temperatures obtained from fine-wire thermocouples. The temperature measurements along with appropriate modeling provide information about the gas-to-solid heat flux. Environmental parameters to be varied are the oxygen concentration and pressure.

Altenkirch, Robert A.↗