Preconceptual Design of Multifunctional Gas-Cooled Cartridge Loop for the Versatile Test Reactor—Part I
Not Available
Engineering topics
Publications and source records attributed to Anand, N. K..
Not Available
Here, this study aims at investigating the inlet flow conditions of flow through an axisymmetric sudden expansion with an expansion ratio of 2.0. A series of large eddy simulations with the WALE model were conducted for different inlet Reynolds numbers ( Re) and turbulence intensities ($u_{rms}/\bar{U}_m$). The reattachment length, defined as the length measured downstream of the expansion where the flow direction is reversed adjacent to the wall ( Lr), was measured for each case. For widely studied inlet turbulence intensity values (TI), the simulation results are in good agreement with the experimental and numerical results reported in the literature. Parametric studies revealed that turbulence intensity affects the critical Reynolds number, marking the transition between the laminar and transition regions and the reattachment length. The critical Reynolds number was found to decrease with increasing turbulence intensity. A correlation expression is proposed. Additional analysis with proper orthogonal decomposition was performed to enhance the understanding of complex flow structures downstream of the expansion. Finally, an overall correlation expression for the reattachment length was obtained for 500 ≤ Re ≤15 000 and 0.2 ≤ TI (%) ≤ 20. For a given turbulence intensity, the reattachment length can be expressed for laminar and turbulent regions as a function of the Reynolds number. The reattachment length in the transition region can be expressed as a fractional average of reattachment lengths for laminar and turbulent flows.
Numerical simulation of isothermal multi-component gas flow was conducted to study fluid flow and mixing in a scaled low-pressure, low-temperature test facility for the fission product venting system (FPVS) of a gas cooled fast reactor (GFR). The geometry of FPVS test facility was an open loop including gradual expansion coupling and two 90°pipe elbows. First, the validation of large eddy simulation (LES) wall-adapting local eddy-viscosity (WALE) turbulent model was performed for transitional flow in a circular pipe with gradual expansion. The reactingFOAM solver in OpenFOAM v8 was employed. By introducing appropriate turbulence disturbance at the flow inlet, such as turbulence intensity, the numerical results showed good agreement in (1) the velocity profile downstream of the pipe expansion measured by particle image velocimetry (PIV) in this study, and (2) the reattachment length reported in the literature. Using this validated model, the numerical simulation of flow and component mixing was performed for the FPVS with an inlet flowrate corresponding to a Reynolds number of 2,400 to investigate the flow behavior and component mixing. Standard deviation of the mass fraction of component, referred to as absolute mixing index (AMI), was calculated to quantify the mixing of components, showing that the component mixing length determined by AMI is related to the reattachment length downstream of the expansion. Additionally, this study was able to identify the best location in the FPVS test facility to measure the velocity and concentration profies where multicomponent flow is well mixed.
This research work seeks to investigate the influence of spacing and heat transfer on the wake behavior of a triangular arrangement of spheres. Four experimental configurations have been investigated at three Reynolds numbers, Re 1 = 350, Re 2 = 700, and Re 3 = 1050. Two isothermal cases were investigated with spacing between the spheres of zero and one sphere diameter, and two cases were investigated with an applied heat flux at the same spacing conditions. The time resolved particle image velocimetry results revealed various flow phenomena including flow separations, von Karman vortex shedding, and Kelvin–Helmholtz instabilities. The turbulent statistics reveal the effect of proximity and heat transfer on the time averaged values of the wake size, turbulent strengths, and Reynolds shear stress in the wake of each sphere, namely, the laminarization effects from the addition of heat and the suppression of the lead sphere wake from the proximity of the trailing spheres. These results are complemented by the application of proper orthogonal decomposition (POD) to the flow fields, which extracts the coherent structures from the flow. Here the modes that describe the coherent structures are extracted and described in detail, which provide further insight into effects of the experimental conditions on the temporal behavior of the flow. Many of the low order modes are found to be associated in pairs, corresponding to asymmetric structures or advection of a given structure downstream. The capability of POD to produce reduced order models of the flow is then utilized to facilitate vortex identification analysis. A turbulent kinetic energy based mode truncation criteria, which has been found to enhance vortex identification capability, is applied to select the POD modes and temporal coefficients to be used in the reduced order modeling. The reconstructed velocity fields are then analyzed with vortex identification algorithms to extract the vortex cores and boundaries. The combination of these approaches allows the study of the effect of proximity and heat transfer on the vortex characteristics, such as size, strength, and distribution.
This work experimentally investigated the flow phenomena and vortex structures in the wake of a sphere located in a water loop at Reynolds numbers of Re = 850, 1,250, and 1,700. Velocity fields in the wake region were obtained by applying the time-resolved stereoscopic particle image velocimetry (TR-SPIV) technique. From the acquired TR-SPIV velocity vector fields, the statistical values of mean and fluctuating velocities were computed. Spectral analysis, two-point velocity–velocity cross-correlation, proper orthogonal decomposition (POD) and vortex identification analyses were also performed. The velocity fields show a recirculation region that decreases in length with an increase of Reynolds numbers. The power spectra from the spectral analysis had peaks corresponding to a Strouhal number of St = 0.2, which is a value commonly found in the literature studies of flow over a sphere. The two-point cross-correlation analysis revealed elliptical structures in the wake, with estimated integral length scales ranging between 12% and 63% of the sphere diameter. The POD analysis revealed the statistically dominant flow structures that captured the most flow kinetic energy. It is seen that the flow kinetic energy captured in the smaller scale flow structures increased as Reynolds number increased. The POD modes contained smaller structure as the Reynolds number increased and as mode order increased. In addition, spectral analysis performed on the POD temporal coefficients revealed peaks corresponding to St = 0.2, similar to the spectral analysis on the fluctuating velocity. The ability of POD to produce low-order reconstructions of the flow was also utilized to facilitate vortex identification analysis, which identified average vortex sizes of 0.41D for Re1, 0.33D for Re2, and 0.32D for Re3.
This document provides the progress of a research project at Texas A&M University (TAMU), led by Idaho National Laboratory (INL), in support of the Versatile Test Reactor (VTR) program and work scope area of gas-cooled fast reactors. The VTR TAMU INL project started in October 2018. The document includes the main objectives of the project, scaling analysis applied to the experimental facilities, experimental methodology including instrumentation and techniques applied, and up-to-date results from the experimental and numerical studies.
Not Available
The study of flow and heat transfer through porous media or randomly packed beds is important as these configurations are widely used in many engineering applications, for example, heat energy storage, chemical catalytic reactors, and nuclear reactors. The flow mixing characteristics in a cross-flow plane of a facility with randomly packed spheres at an aspect ratio of 6.3 were experimentally investigated. The velocity fields at several regions of the cross-flow plane located in the vicinity of the wall and in the pores between spheres were obtained by applying the matched-index-of-refraction and time-resolved particle image velocimetry (TR-PIV) techniques for Reynolds numbers ranging from 700 to 1700. The TR-PIV results revealed various flow patterns in the transverse plane of the packed spheres, including swirling flow structures aligned with the axial flow direction, a strong bypass flow near the enclosure wall, and a circulation region created when the bypass flow ejected into a large spatial gap. When the Reynolds number was increased, the peaks of root-mean-square fluctuating velocities, $u'_{rms}$ and $v'_{rms}$, were found to increase approximately at the same ratio as the increase in Reynolds number, and the magnitude of the Reynolds stress increased considerably. In addition, the characteristics of flow mixing in different flow regions were investigated via the two-point cross-correlation of fluctuating velocities. Using Taylor’s hypothesis, the vorticity iso-surfaces were constructed. Thus, constructed iso-surfaces showed that shear layers generated from the bypass flow gaps were stretched, broken into smaller flow structures, and then evolved as vortex pairs when entering the neighboring gaps. The results obtained by applying proper orthogonal decomposition (POD) analysis to the velocity fields showed that the statistically dominant flow structures had approximately the same size and shape as those depicted by Taylor’s hypothesis. Vortex characteristics, such as populations, spatial distributions, and strengths, for various spatial regions and Reynolds numbers were obtained by a combination of POD analysis and vortex identification.
Not Available