Search NASASearch

Engineering topics

Anderson, D.

Publications and source records attributed to Anderson, D..

34 records · Page 2

Numerical solutions for supersonic corner flow

Analytical solutions for inviscid supersonic corner flows are virtually nonexistent due to the complexity of the interference geometry. In view of this, numerical solutions for swept-compressive and swept-expansive corner flows are obtained. The governing equations are written in strong conservation-law form and are solved iteratively in nonorthogonal conical coordinates by use of a second-order, shock-capturing, finite-difference technique. The computed wave structure and surface pressure distributions are compared with high Reynolds number experimental data and show very good agreement. The results clearly show that supersonic corner flow at reasonably high Reynolds numbers including the effect of sweep is dominated by the inviscid field.

Shankar, V.

A comparison of numerical solutions of the advective equation

Second- and third-order finite-difference methods recently applied to problems in high-speed fluid flow are applied to the model advection equation cast in conservative form. The differencing methods considered use forward time differencing with both centered and preferential space differences employed in the predictor-corrector sequences. The free parameter required for stability in the third-order method is adjusted to cause the solution to be either minimum dispersive or minimum dissipative in nature. Results indicate that the third-order method using minimum dispersion is the most accurate method tested. Computer time requirements are approximately twice those needed for second-order techniques.

Anderson, D.

Effects of equivalence ratio and dwell time on exhaust emissions from an experimental premixing prevaporizing burner

A flame-tube study was performed to determine the effects of equivalence ratio and residence time on exhaust emissions with premixed, prevaporized propane fuel. Nitrogen oxides emissions as low as .3 g NO2/kg fuel were measured with greater than 99% combustion efficiency at 800 K inlet temperature and an equivalence ratio of .4. For a constant combustion efficiency, lower nitrogen oxides emissions were obtained by burning very lean with relatively long residence times than by using somewhat higher equivalence ratios with shorter times.

Anderson, D.

Turbojet emissions - Hydrogen versus JP.

Preliminary data from an experimental combustor show that the NO sub x emission index, g (NO2)/kg fuel, is about three times greater for hydrogen than for JP at simulated cruise conditions. However, if these results are applied to aircraft designed for a given mission, hydrogen's higher heating value enables the aircraft to have a lower gross weight and a lower fuel flow rate so that the NO sub x emission rate, kg(NO2)/hr may be reduced about 30% compared to JP. Theoretical kinetics calculations indicate that combustors may be designed for hydrogen that could further decrease NO sub x emissions by taking advantage of hydrogen's wide flammable limits and high burning velocity.

Grobman, J.

Numerical calculations of flow fields

Numerical calculations were made of flow fields generated by various aerodynamic configurations. Data cover flow fields generated by a finitely thick lifting three dimensional wing with subsonic tips moving at supersonic speeds, cross flow instability associated with lifting delta wing configurations such as space shuttles, and flow fields produced by a lifting elliptic cone. Finite difference techniques were used to determine elliptic cone flow.

Anderson, D.

Turbojet emissions, hydrogen versus JP

Preliminary data from an experimental combustor show that the NOx emission index, g(NO2)/Kg fuel, is about three times greater for hydrogen than for JP at simulated cruise conditions. However, if these results are applied to aircraft designed for a given mission, hydrogen's higher heating value enables the aircraft to have a lower gross weight and a lower fuel flow rate so that the NOx emission rate, Kg (NO2)/hr may be reduced about 30 percent compared to JP. Theoretical kinetics calculations indicate that combustors may be designed for hydrogen that could further decrease NOx emissions by taking advantage of hydrogen's wide flammable limits and high burning velocity.

Grobman, J.

Numerical solution of flowfields behind rectangular wings

The numerical solution of flow fields behind rectangular wings is described. Subjects discussed are: (1) evaluation of various differencing methods applied to the hyperbolic partial differential equations encountered in gas dynamics, (2) application of the numerical differencing techniques to the wedge flow, two dimensional shock reflection for the three dimensional finite thickness wing at zero degrees angle of attack, and (3) calculation of preliminary results for wedge flows using optimum differencing methods.

Anderson, D.