Search NASA⌕ Search

Engineering topics

Anderson, G. E.

Publications and source records attributed to Anderson, G. E..

The rebrightening of a ROSAT -selected tidal disruption event: repeated weak partial disruption flares from a quiescent galaxy?

The ROSAT-selected tidal disruption event (TDE) candidate RX J133157.6-324319.7 (J1331) was detected in 1993 as a bright [0.2–2 keV flux of (1.0 ± 0.1) × 10 -12 erg s -1 cm -2 ], ultra-soft (kT = 0.11 ± 0.03 keV) X-ray flare from a quiescent galaxy (z = 0.051 89). During its fifth all-sky survey (eRASS5) in 2022, Spectrum-Roentgen-Gamma (SRG)/ eROSITA detected the repeated flaring of J1331, where it had rebrightened to an observed 0.2–2 keV flux of (6.0 ± 0.7) × 10 -13 erg s -1 cm -2 , with spectral properties (kT = 0.115 ± 0.007 keV) consistent with the ROSAT-observed flare ~30 yr earlier. In this work, we report on X-ray, ultraviolet, optical, and radio observations of this system. During a pointed XMM observation ~17 d after the eRASS5 detection, J1331 was not detected in the 0.2–2 keV band, constraining the 0.2–2 keV flux to have decayed by a factor of ≳40 over this period. Given the extremely low probability (~5 × 10 -6 ) of observing two independent full TDEs from the same galaxy over a 30 yr period, we consider the variability seen in J1331 to be likely caused by two partial TDEs involving a star on an elliptical orbit around a black hole. J1331-like flares show faster rise and decay time-scales [$\mathcal {O}(\mathrm{d})$] compared to standard TDE candidates, with negligible ongoing accretion at late times post-disruption between outbursts.

79 ASTRONOMY AND ASTROPHYSICS↗

Observation of inverse Compton emission from a long γ-ray burst

Long-duration γ-ray bursts (GRBs) originate from ultra-relativistic jets launched from the collapsing cores of dying massive stars. They are characterized by an initial phase of bright and highly variable radiation in the kiloelectronvolt-to-megaelectronvolt band, which is probably produced within the jet and lasts from milliseconds to minutes, known as the prompt emission. Subsequently, the interaction of the jet with the surrounding medium generates shock waves that are responsible for the afterglow emission, which lasts from days to months and occurs over a broad energy range from the radio to the gigaelectronvolt bands. The afterglow emission is generally well explained as synchrotron radiation emitted by electrons accelerated by the external shock. Recently, intense long-lasting emission between 0.2 and 1 teraelectronvolts was observed from GRB 190114C. Here we report multi-frequency observations of GRB 190114C, and study the evolution in time of the GRB emission across 17 orders of magnitude in energy, from 5 × 10 -6 to 10 12 electronvolts. We find that the broadband spectral energy distribution is double-peaked, with the teraelectronvolt emission constituting a distinct spectral component with power comparable to the synchrotron component. This component is associated with the afterglow and is satisfactorily explained by inverse Compton up-scattering of synchrotron photons by high-energy electrons. Finally, we find that the conditions required to account for the observed teraelectronvolt component are typical for GRBs, supporting the possibility that inverse Compton emission is commonly produced in GRBs.

79 ASTRONOMY AND ASTROPHYSICS↗

154 MHz detection of faint, polarized flares from UV Ceti

We have detected four flares from UV Ceti at 154 MHz using the Murchison Widefield Array. The flares have flux densities between 10 and 65 mJy—a factor of 100 fainter than most flares in the literature at these frequencies—and are only detected in polarization. The circular polarized fractions are limited to >27% at 3σ confidence and two of the flares exhibit polarity reversal. We suggest that these flares occur periodically on a timescale consistent with the rotational period of UV Ceti. During the brightest observed flare, we also detect significant linear polarization with a polarization fraction >18%. Averaging the data in 6 minute, 10 MHz frequency bins we find that the flux density of these flares does not vary over the 30 MHz bandwidth of the Murchison Widefield Array; however, we cannot rule out finer time-frequency structure. Using the measured flux densities for the flares, we estimate brightness temperatures between (10{sup 13}--10{sup 14}) K, indicative of a coherent emission mechanism. The brightness temperature and polarization characteristics point to the electron cyclotron maser mechanism. We also calculate the flare rates given our four observed flares and compare them to flare rates for the set of M dwarf stars with known 100–200 MHz flares. Our measurement is the first for flares with intensities <100 mJy at 100–200 MHz.

79 ASTRONOMY AND ASTROPHYSICS↗

Hydraulic-Leak Detector for Hidden Joints

Slow leakage of fluid made obvious. Indicator consists of wick wrapped at one end around joint to be monitored. Wick absorbs hydraulic fluid leaking from joint and transmits to opposite end, located outside cover plate and visible to inspector. Leakage manifested as discoloration of outside end of wick. Indicator reveals leaks in hidden fittings on hydraulic lines. Fast inspection of joints without disassembly. Used in aerospace, petroleum, chemical, nuclear, and other industries where removing covers for inspection impossible, difficult, or time-consuming.

Anderson, G. E.↗

Fluid leak indicator

A fluid leak indicator for detecting and indicating leaks in visually inaccessible fluid tubing joints, such as those obstructed by insulation includes a bag system and a wicking system surrounding or wrapping the joints under the visual obstructing material. Leaking fluid is collected in the bag or on the wicking material where it is conducted along the wicking material to a visily accessible capturing transparent indicator bulb for providing a visual indication of the leak without requiring a chemical change in the capturing indicator bulb.

Anderson, G. E.↗

Flexible pile thermal barrier insulator

A flexible pile thermal barrier insulator included a plurality of upstanding pile yarns. A generally planar backing section supported the upstanding pile yarns. The backing section included a plurality of filler yarns forming a mesh in a first direction. A plurality of warp yarns were looped around said filler yarns and pile yarns in the backing section and formed a mesh in a second direction. A binder prevented separation of the yarns in the backing section.

Anderson, G. E.↗

Flexible-pile thermal sealant

Brushlike material insulates variable-width gaps where severe thermal stress is present. Weave-and-tuft strip has low thermal conductivity, working temperature range from -454 to 2,000 F, low load compressibility, and good inhibition of plasma flow.

Anderson, G. E.↗

Portable detector set discloses helium leak rates

Portable helium detector measuring helium leak rates makes possible the use of the inert gas helium as a tracer. This helps solve safety and contamination problems in detecting leaks in closed fluid systems.

Anderson, G. E.↗