Engineering topics
Andrew H Lind
Publications and source records attributed to Andrew H Lind.
Forces of Flight for a Lift+Cruise VTOL Aircraft
Explore the source record for details and available documents.
Acoustic Flight Test of the Joby Aviation Advanced Air Mobility Prototype Vehicle
An extensive acoustic flight test was performed on the Joby Aviation pre-production all-electric vertical takeoff and landing prototype. With the design intent of carrying a pilot and four passengers a maximum range of 150 miles, this vehicle utilizes distributed propulsion and vectored thrust via six tilting propellers. As part of the Advanced Air Mobility (AAM) National Campaign, this is the first full-scale AAM aircraft tested by NASA over representative conditions for all phases of a typical mission profile. A 58- channel distributed microphone array was used to acquire acoustic measurements on more than 100 test points (31 unique conditions). The measurements were postprocessed with synchronously sampled vehicle position and state data to form ground noise contours of departures and approaches at various flight path angles and accelerations. Comparing ground areas of 75 dBA isolines, approaches consistently exhibit higher noise levels rela- tive to departures. Directivity maps were generated for constant airspeed level flyovers. Examples comparing the differences in a semi-thrust borne and full wing-borne mode are given, with full wing-borne mode representing the quietest phase of the flight envelope tested. Measurements for hover in and out of ground effect are given and found to have 2 to 5 dB variation over a single run, and more significant variation between back-to-back runs. Finally, initial analysis of acoustic symmetry about the longitudinal vehicle axis and repeatability over several test days are presented.
Reflectivity characterization of in-flow acoustic floor treatment for the NASA Langley 14- by 22-Foot Subsonic Tunnel
An experimental campaign was performed to assess acoustic modifications to the NASA Langley Research Center 14- by 22-Foot Subsonic Tunnel. Recent acoustic test campaigns in this facility have emphasized the reduction of aerodynamic noise due to flow scrubbing across acoustically treated floor baskets. However, the measures implemented to address this noise contaminant have resulted in the installation of floor basket coverings of high acoustic reflectivity. Therefore, a controlled test campaign was performed to identify a suitable acoustic basket configuration in terms of both acoustic absorptivity and reduced flow scrubbing noise. This test campaign was conducted in two phases: the first in an anechoic chamber facility on a single acoustic basket panel to identify a notional configuration of acceptable absorptivity, and the second in a complete floor basket installation checkout test in the NASA Langley 14- by 22-Foot Subsonic Tunnel. Results show that the newly implemented floor treatment exhibits suitable performance in both desired categories of acoustic absorptivity and reduced flow scrubbing noise. This campaign has also validated the effectiveness and usefulness of the anechoic chamber test configuration as a means of assessing acoustic reflections at oblique angles of incidence.