Engineering topics

Andrews, D. M.

Publications and source records attributed to Andrews, D. M..

10 records

NASA NTRS1985

A methodology for testing fault-tolerant software

A methodology for testing fault tolerant software is presented. There are problems associated with testing fault tolerant software because many errors are masked or corrected by voters, limiter, or automatic channel synchronization. This methodology illustrates how the same strategies used for testing fault tolerant hardware can be applied to testing fault tolerant software. For example, one strategy used in testing fault tolerant hardware is to disable the redundancy during testing. A similar testing strategy is proposed for software, namely, to move the major emphasis on testing earlier in the development cycle (before the redundancy is in place) thus reducing the possibility that undetected errors will be masked when limiters and voters are added.

Andrews, D. M.↗

NASA NTRS1985

Development of a flight software testing methodology

The research to develop a testing methodology for flight software is described. An experiment was conducted in using assertions to dynamically test digital flight control software. The experiment showed that 87% of typical errors introduced into the program would be detected by assertions. Detailed analysis of the test data showed that the number of assertions needed to detect those errors could be reduced to a minimal set. The analysis also revealed that the most effective assertions tested program parameters that provided greater indirect (collateral) testing of other parameters. In addition, a prototype watchdog task system was built to evaluate the effectiveness of executing assertions in parallel by using the multitasking features of Ada.

Mccluskey, E. J.↗

NASA NTRS1985

Dynamic assertion testing of flight control software

An experiment in using assertions to dynamically test fault tolerant flight software is described. The experiment showed that 87% of typical errors introduced into the program would be detected by assertions. Detailed analysis of the test data showed that the number of assertions needed to detect those errors could be reduced to a minimal set. The analysis also revealed that the most effective assertions tested program parameters that provided greater indirect (collateral) testing of other parameters.

Andrews, D. M.↗

NASA NTRS1985

Dynamic assertion testing of flight control software

Digital Flight Control System (DFCS) software was used as a test case for assertion testing. The assertions were written and embedded in the code, then errors were inserted (seeded) one at a time and the code executed. Results indicate that assertion testing is an effective and efficient method of detecting errors in flight software. Most errors are eliminate at an earlier stage in the development than before.

Andrews, D. M.↗

NASA NTRS1985

Dynamic assertion testing of flight control software

Assertions are used to dynamically test fault tolerant flight software. The experiment showed that 87% of typical errors introduced into the program would be detected by assertions. Detailed analysis of the test data showed that the number of assertions needed to detect those errors could be reduced to a minimal set. The analysis also revealed that the most effective assertions tested program parameters that provided greater indirect (collateral) testing of other parameters.

Andrews, D. M.↗

NASA NTRS1985

The Watchdog Task: Concurrent error detection using assertions

The Watchdog Task, a software abstraction of the Watchdog-processor, is shown to be a powerful error detection tool with a great deal of flexibility and the advantages of watchdog techniques. A Watchdog Task system in Ada is presented; issues of recovery, latency, efficiency (communication) and preprocessing are discussed. Different applications, one of which is error detection on a single processor, are examined.

Ersoz, A.↗

NASA NTRS1985

Automation of assertion testing - Grid and adaptive techniques

Assertions can be used to automate the process of testing software. Two methods for automating the generation of input test data are described in this paper. One method selects the input values of variables at regular intervals in a 'grid'. The other, adaptive testing, uses assertion violations as a measure of errors detected and generates new test cases based on test results. The important features of assertion testing are that: it can be used throughout the entire testing cycle; it provides automatic notification of error conditions; and it can be used with automatic input generation techniques which eliminate the subjectivity in choosing test data.

Andrews, D. M.↗

NASA NTRS1984

Writing executable assertions to test flight software

An executable assertion is a logical statement about the variables or a block of code. If there is no error during execution, the assertion statement results in a true value. Executable assertions can be used for dynamic testing of software. They can be employed for validation during the design phase, and exception and error detection during the operation phase. The present investigation is concerned with the problem of writing executable assertions, taking into account the use of assertions for testing flight software. They can be employed for validation during the design phase, and for exception handling and error detection during the operation phase The digital flight control system and the flight control software are discussed. The considered system provides autopilot and flight director modes of operation for automatic and manual control of the aircraft during all phases of flight. Attention is given to techniques for writing and using assertions to test flight software, an experimental setup to test flight software, and language features to support efficient use of assertions.

Mahmood, A.↗

NASA NTRS1984

Executable assertions and flight software

Executable assertions are used to test flight control software. The techniques used for testing flight software; however, are different from the techniques used to test other kinds of software. This is because of the redundant nature of flight software. An experimental setup for testing flight software using executable assertions is described. Techniques for writing and using executable assertions to test flight software are presented. The error detection capability of assertions is studied and many examples of assertions are given. The issues of placement and complexity of assertions and the language features to support efficient use of assertions are discussed.

Mahmood, A.↗

NASA NTRS1984

Executable assertions and flight software

It is pointed out that executable assertions can be used for dynamic testing of software. An executable assertion is a logical statement about the variables or a block of code. If there is no error during execution then the assertion statement results in a true value. Assertions are useful for testing purposes throughout the lifecycle of software. They can be used for validation during the design phase, and for exception handling and error detection during the operation phase. The present investigation has the objective to study the use of executable assertions for testing flight software. Attention is given to details regarding executable assertions, the digital flight control system, testing flight software, and preliminary experimental results.

Mahmood, A.↗