Assessment of Neutron Irradiation Damage in Aggregates
Explore the source record for details and available documents.
Tajuelo Rodriguez, Elena↗
Engineering topics
Anovitz, Lawrence {Larry} M.
Publications and source records attributed to Anovitz, Lawrence {Larry} M..
Water Migration and Swelling in Engineered Barrier Materials for Radioactive Waste Disposal
Deep, underground repositories are needed to isolate radioactive waste from the biosphere. Because bentonite is an integral component of many multibarrier repository systems, information on the hydraulic behavior of bentonite is crucial for modeling the long-term viability of such systems. In this paper the hydraulic behavior of bentonite samples was analyzed as a function of aggregate size, and samples were subjected to hydrothermal treatments involving contact with NaCl, KCl, and deionized water. Neutron and X-ray imaging were used to quantify water sorption into packed bentonite samples and bentonite swelling into the water column. The distance between the original clay-water interface and the wetting front was determined as a function of time. Average water uptake exhibited a square-root-of-time dependence in freshly prepared samples, but more variable rates were observed for samples previously in contact with water. The radiography was supported by small-angle neutron scattering analysis and ultra-small-angle neutron scattering analysis of aggregate size distributions and by inelastic neutron scattering to understand the physicochemical environment of the sorbed water. Results showed that hydrothermal treatment with KCl had the greatest effect of increased water transport in the bentonite, possibly as a result of the interaction of K + with smectite layers in the clay.
12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗
A high-pressure flow through test vessel for neutron imaging and neutron diffraction-based strain measurement of geological materials
Neutron scattering and neutron imaging have emerged as powerful methods for experimentally investigating material deformation and fluid flow in the interior of otherwise inaccessible or opaque structures. This paper describes the design and provides example uses of a pressure cell developed for investigating such behaviors within geological materials. The cell can accommodate cylindrical samples with diameters up to 38.1 mm and lengths up to 154 mm. Additionally, ports in the cell and a pressure isolating sleeve around the sample allow the independent application of confining pressure up to 69 MPa and axial pressure up to 34.5 MPa. Furthermore, two material versions of the cell have been manufactured and used to date. An aluminum version is typically used for temperatures below 40 °C, because of its relative transparency to neutrons, while a titanium version, which is comparatively more neutron attenuating, is used for experiments requiring triaxial pressurization under conditions up to 350 °C. The pressure cells were commissioned at the VULCAN engineering diffractometer at the Oak Ridge National Laboratory (ORNL), Spallation Neutron Source, and have since been used at the ORNL high flux isotope reactor CG1-D imaging beamline, National Institute of Standard and Technology (NIST) BT-2, and NIST NG6 imaging beamlines.
47 OTHER INSTRUMENTATION↗
Connecting particle interactions to agglomerate morphology and rheology of boehmite nanocrystal suspensions
Rheology imposes significant challenges on processing of complex suspensions such as nuclear waste slurries at the Hanford and Savannah River sites. Understanding rheology connecting to microstructures and underlying particle interactions in complex slurries is therefore important for both fundamental knowledge and practical applications. Here, we use suspensions of aluminum oxyhydroxide minerals in the form of boehmite as an analog of the radioactive waste slurry to gain physical insights on the correlation between particle interactions, microstructures, and slurry rheology. Specifically, we use a combination of Couette rheometry and small-angle scattering techniques (independently and simultaneously) to understand how the slurry microstructure changes under flow and how these structural changes manifest themselves in the bulk rheology of the suspensions. Our experiments show that the boehmite slurries are thixotropic, with the rheology and structure of the suspensions changing with increasing exposure to flow. In the slurries, particle aggregates begin as loose, system-spanning clusters, but exposure to moderate shear rates causes the aggregates to irreversibly consolidate into denser clusters of finite size. The microstructural changes directly influence the rheological properties of the slurries such as viscosity and viscoelasticity. More importantly, our study shows that solution pH affects the amount of structural rearrangement and the kinetics of the rearrangement process, with an increase in pH leading to faster and more dramatic changes in the bulk rheology. Such dynamic microstructural changes and resultant rheology are understood via correlations between particle interactions and strength of particle network, coupled with surface chemistry and anisotropic nature of particle interactions. Nearly identical structural changes are also observed in Poiseuille flow geometries, implying that the observed changes are relevant in the pipe flow conditions present during waste processing.
Weston, Javen S.↗
First Experiments: New Science Opportunities at the Spallation Neutron Source Second Target Station (abridged)
This brochure is an abridged version of a more comprehensive companion report. DOE proposes to build a Second Target Station (STS) at SNS to produce beams of cold neutrons with world-leading peak brightness at a repetition rate of 15 Hz, providing broad energy/wavelength ranges that can be used simultaneously. Construction of the STS will provide transformative capabilities that allow thousands of users from national laboratories, universities, and industry to address grand scientific challenges [Hemminger 2015], advance energy research, and accelerate industrial innovations through the combination of cold (long-wavelength) neutrons of unprecedented peak brightness and short neutron pulses with broad ranges of usable wavelengths or energy. The STS Project, now in progress at ORNL, will design, construct, install, and commission the facilities and equipment needed to create a world-leading source of cold neutrons of unprecedented peak brightness at SNS. Key aspects of the STS design, including preliminary descriptions of an illustrative suite of eight instruments, are presented in the section “The STS at SNS.” The capabilities offered by the STS instruments (22 when fully built out) will complement those of the FTS and HFIR, providing the United States with unparalleled resources for neutron scattering at the world’s leading high–peak brightness cold neutron source.
43 PARTICLE ACCELERATORS↗