Search NASA⌕ Search

Engineering topics

Armstrong, Timothy R.

Publications and source records attributed to Armstrong, Timothy R..

A technique for monitoring SO2 in combustion exhausts: Use of a non-Nernstian sensing element in combination with an upstream catalytic filter

Detection of sulfur dioxide (SO2) at high temperature (600 750 oC) in the presence of some interferents found in typical combustion exhausts (oxides of nitrogen (NO2 and NO, "NOx"), CO2, CO, and hydrocarbon (C3H6)) is described. The detection scheme involves use of a catalytic filter in front of a non-Nernstian sensing element. The catalytic filter was a Ni:Cr powder bed operating at 850 oC and the sensing elements were pairs of platinum (Pt) and oxide (Ba-promoted copper chromite ((Ba,Cu)xCryOz) and Sr-modified lanthanum ferrite (LSF)) electrodes on yttria-stabilized zirconia. The Ni:Cr powder bed was capable of reducing the sensing element response to NOx, CO, and C3H6, but the presence of NOx (100 ppm by volume) still interfered with the SO2 response of the Pt-(Ba,Cu)xCryOz sensing element at 600 oC, causing approximately a 7 mV (20%) reduction in the response to 120 ppm SO2 and a response equivalent to about 20 ppm SO2 in the in the absence of SO2. The Pt-LSF sensing element, operated at 750 oC, did not suffer from this NOx interference but at the cost of a reduced SO2 response magnitude (120 ppm SO2 yielded ~10 mV, in contrast to ~30 mV for the Pt-(Ba,Cu)xCryOz sensing element). The powder bed and Pt-LSF sensing element were operated continuously over approximately 350 hours, and the response to SO2 drifted downward by about 7%, with most of this change occurring during the initial 100 hours of operation.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Selective Catalytic Oxidation of Hydrogen Sulfide on Activated Carbons Impregnated with Sodium Hydroxide

Two activated carbons of different origin were impregnated with the solution of sodium hydroxide (NaOH) of various concentrations up to 10 wt %, and the effect of impregnation on the catalytic performance of the carbons was evaluated. The catalytic activity was analyzed in terms of the capacity of carbons for hydrogen sulfide (H2S) conversion and removal from hydrogen-rich fuel streams and the emission times of H2S and the products of its oxidation [e.g., sulfur dioxide (SO2) and carbonyl sulfide (COS)]. The results of impregnation showed a significant improvement in the catalytic activity of both carbons proportional to the amount of NaOH introduced. NaOH introduces hydroxyl groups (OH-) on the surface of the activated carbon that increase its surface reactivity and its interaction with sulfur-containing compounds.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DETECTION OF SO2 AT HIGH TEMPERATURE WITH ELECTRICALLY BIASED, SOLID-ELECTROLYTE SENSING ELEMENTS

Design and operation of sensing elements for the detection of sulfur dioxide (SO2) at high temperature (800 900 oC) is described. The sensing elements consisted of three (two oxide and one Pt) electrodes on yttria-stabilized zirconia substrates. To operate the elements, a constant current (usually on the order of 0.1 mA) was driven between two of the electrodes and the voltage between one of these electrodes and the third electrode was monitored and used as the sensing signal. In one example, 31 ppm SO2 caused an approximately 40% change in the element output, and 2 ppm of SO2 could be easily detected. The cross-sensitivity to several interferents such as NOx was evaluated and found to be relatively small in comparison to the SO2 response.

01 COAL, LIGNITE, AND PEAT↗