Engineering topics

Assefi, T.

Publications and source records attributed to Assefi, T..

10 records

NASA NTRS1980

Viking Orbiter 75 in-flight pointing calibration of the high-gain antenna

An in-flight pointing calibration technique developed for the Viking Orbiter high-gain antenna has been validated through actual flight usage. The desired telecommunications performance dictated that the high-gain antenna pointing error be held at 0.7 deg, which would have been exceeded without calibration. The in-flight calibration methodology required the development of a stochastic model of the spacecraft rotational biases and earth-received signal strength measurements. The signal strength measurements, which were performed at X-band frequency, were used as observations to estimate the rotational biases and their corresponding uncertainties. Reducing the uncertainties of these parameters resulted in increased antenna pointing accuracy. The initial pointing offset was estimated to be in excess of 1 deg, and after in-flight calibration it was reduced to about 0.66 deg. About 50% of the original offset could not be calibrated, thus the improvement on the remaining offset is better than 50%.

Assefi, T.↗

NASA NTRS1979

Automated vehicle guidance using discrete reference markers

Techniques for providing steering control for an automated vehicle using discrete reference markers fixed to the road surface are investigated analytically. Either optical or magnetic approaches can be used for the sensor, which generates a measurement of the lateral offset of the vehicle path at each marker to form the basic data for steering control. Possible mechanizations of sensor and controller are outlined. Techniques for handling certain anomalous conditions, such as a missing marker, or loss of acquisition, and special maneuvers, such as u-turns and switching, are briefly discussed. A general analysis of the vehicle dynamics and the discrete control system is presented using the state variable formulation. Noise in both the sensor measurement and in the steering servo are accounted for. An optimal controller is simulated on a general purpose computer, and the resulting plots of vehicle path are presented. Parameters representing a small multipassenger tram were selected, and the simulation runs show response to an erroneous sensor measurement and acquisition following large initial path errors.

Johnston, A. R.↗

NASA NTRS1978

Stochastic processes, estimation theory and image enhancement

An introductory account of stochastic processes, estimation theory, and image enhancement is presented. The book is primarily intended for first-year graduate students and practicing engineers and scientists whose work requires an acquaintance with the theory. Fundamental concepts of probability were reviewed that are required to support the main topics. The appendices discuss the remaining mathematical background.

Assefi, T.↗

NASA NTRS1978

Correlation tracking for a Planetary Pointing and Tracking System

The Planetary Pointing and Tracking System (PPTS) is being developed to provide precision pointing for science platforms on future autonomous planetary spacecraft. The PPTS design approach using a CCD optical sensor for closed-loop control with respect to the target body, a gyro for inertial stabilization, and brushless dc torque motors for smooth and continuous platform articulation is essential for high resolution planetary imaging and automated science execution. An integral part of PPTS is the correlation tracker which has the potential to revolutionize autonomous guidance.

Assefi, T.↗

NASA NTRS1976

Shuttle Experiment Pointing Mount /EPM/ Systems

Shuttle Experiment Pointing Mount System concepts and technology have been investigated and assessed with regard to payload requirements having a wide range of stability, accuracy, and control functions. Pointing systems were analyzed with end-mounted and center of gravity-mounted payloads viewing stellar and solar targets. Major error sources are identified with dynamical, stochastic, and nonlinear characteristics of structures, isolators, sensors, bearings, actuators, and controller. Results are presented which place a perspective on the potential of advanced technology to satisfy the most stringent sub-arc second pointing requirements.

Mettler, E.↗

NASA NTRS1976

Some existence and sufficient conditions of optimality

The role of the existence and sufficiency conditions in the field of optimal control was briefly described. The existence theorems are discussed for general nonlinear systems. However, the sufficiency conditions pertain to "nearly" linear systems with integral convex costs. Moreover, a brief discussion of linear systems with multiple-cost functions is presented.

Assefi, T.↗

NASA NTRS1974

Two-dimensional signal processing with application to image restoration

A recursive technique for modeling and estimating a two-dimensional signal contaminated by noise is presented. A two-dimensional signal is assumed to be an undistorted picture, where the noise introduces the distortion. Both the signal and the noise are assumed to be wide-sense stationary processes with known statistics. Thus, to estimate the two-dimensional signal is to enhance the picture. The picture representing the two-dimensional signal is converted to one dimension by scanning the image horizontally one line at a time. The scanner output becomes a nonstationary random process due to the periodic nature of the scanner operation. Procedures to obtain a dynamical model corresponding to the autocorrelation function of the scanner output are derived. Utilizing the model, a discrete Kalman estimator is designed to enhance the image.

Assefi, T.↗

NASA NTRS1972

Bayesian recursive image estimation.

The enhancement of images that are characterized only by statistical data where the picture contains additive noise is considered. The random process representing the output of the scanner is characterized by the output of a dynamic system with white noise input. The dynamic system describes a first-order vector-Markov process. The procedure of Kalman filtering is then utilized to recursively determine the minimum mean-square error estimate of the image. The result is then extended to obtain the smoothing of the data.

Nahi, N. E.↗

NASA NTRS1972

Baysian recursive image estimation.

Discussion of a statistical procedure for treatment of noise-affected images to recover unaffected images by recursive processing with noise background elimination. The feasibility of the application of a recursive linear Kalman filtering technique to image processing is demonstrated. The procedure is applicable to images which are characterized statistically by mean and correlation functions. A time invariant dynamic model is proposed to provide stationary statistics for the scanner output.

Nahi, N. E.↗

NASA NTRS1971

Bayesian recursive image estimation.

A procedure for recursively estimating images that are characterized statistically by the mean and correlation functions associated with the random process representing the brightness level is proposed for the case where the images are corrupted by additive noise. First, a dynamic model is developed with a response characteristic which matches that of the scanner output (the input of the estimator is the output of a horizontal line scanner) in a statistical sense. Such models have the form of an ordinary differential or difference equation with white noise input. An insignificant approximation is introduced by using a constant-coefficient model. The appropriate model is a vector valued difference equation with the solution representing a vector Markov process. The next step is to obtain the minimum mean square estimate of the image by using a Kalman filter. Since the image estimation is an interpolation problem, two successive runs over the observation are performed in opposite directions and the resultant estimates are averaged. Examples are included for illustration.

Nahi, N. E.↗