Engineering topics
Atkinson, D.
Publications and source records attributed to Atkinson, D..
Saturn PRobe Interior and aTmosphere Explorer (SPRITE)
The Vision and Voyages Planetary Decadal Survey identified a Saturn Probe mission as one of the high priority New Frontiers mission targets[1]. Many aspects of the Saturn system will not have been fully investigated at the end of the Cassini mission, because of limitations in its implementation and science instrumentation. Fundamental measurements of the interior structure and noble gas abundances of Saturn are needed to better constrain models of Solar System formation, as well as to provide an improved context for exoplanet systems. The SPRITE mission will fulfill the scientific goals of the Decadal Survey Saturn probe mission. It will also provide ground truth for quantities constrained by Cassini and conduct new investigations that improve our understanding of Saturn's interior structure and composition, and by proxy, those of extrasolar giant planets.
The TechEdSat Series - A Platform for Rapidly Advancing Nano-Satellite Technologies and Capabilities
No abstract available
Parameter Estimation for Compact Binary Coalescence Signals with the First Generation Gravitational-Wave Detector Network
Compact binary systems with neutron stars or black holes are one of the most promising sources for ground-based gravitational-wave detectors. Gravitational radiation encodes rich information about source physics; thus parameter estimation and model selection are crucial analysis steps for any detection candidate events. Detailed models of the anticipated waveforms enable inference on several parameters, such as component masses, spins, sky location and distance, that are essential for new astrophysical studies of these sources. However, accurate measurements of these parameters and discrimination of models describing the underlying physics are complicated by artifacts in the data, uncertainties in the waveform models and in the calibration of the detectors. Here we report such measurements on a selection of simulated signals added either in hardware or software to the data collected by the two LIGO instruments and the Virgo detector during their most recent joint science run, including a blind injection where the signal was not initially revealed to the collaboration. We exemplify the ability to extract information about the source physics on signals that cover the neutron-star and black-hole binary parameter space over the component mass range 1M25M and the full range of spin parameters. The cases reported in this study provide a snapshot of the status of parameter estimation in preparation for the operation of advanced detectors.
Implementation and Testing of the First Prompt Search for Gravitational Wave Transients with Electromagnetic Counterparts
Aims. A transient astrophysical event observed in both gravitational wave (GW) and electromagnetic (EM) channels would yield rich scientific rewards. A first program initiating EM follow-ups to possible transient GW events has been developed and exercised by the LIGO and Virgo community in association with several partners. In this paper, we describe and evaluate the methods used to promptly identify and localize GW event candidates and to request images of targeted sky locations. Methods. During two observing periods (Dec. 17, 2009 to Jan. 8, 2010 and Sep. 2 to Oct. 20, 2010), a low-latency analysis pipeline was used to identify GW event candidates and to reconstruct maps of possible sky locations. A catalog of nearby galaxies and MilkyWay globular clusters was used to select the most promising sky positions to be imaged, and this directional information was delivered to EM observatories with time lags of about thirty minutes. A Monte Carlo simulation has been used to evaluate the low-latency GW pipeline's ability to reconstruct source positions correctly. Results. For signals near the detection threshold, our low-latency algorithms often localized simulated GW burst signals to tens of square degrees, while neutron star/neutron star inspirals and neutron star/black hole inspirals were localized to a few hundred square degrees. Localization precision improves for moderately stronger signals. The correct sky location of signals well above threshold and originating from nearby galaxies may be observed with ∼50% or better probability with a few pointings of wide-field telescopes.
Ultra-stable oscillators for radio science investigations on planetary entry probes
Explore the source record for details and available documents.
Overview of Technology Work
Explore the source record for details and available documents.
Autonomy Technology Challenges by Titan and Europa Exploration Missions
Explore the source record for details and available documents.
Effects of standing on cerebrovascular resistance in patients with idiopathic orthostatic intolerance
PURPOSE: Patients with idiopathic orthostatic intolerance often have debilitating symptoms on standing that are suggestive of cerebral hypoperfusion despite the absence of orthostatic hypotension. SUBJECTS AND METHODS: We evaluated the effects of graded head-up tilt on cerebral blood flow as determined by transcranial Doppler measurements in 10 patients with idiopathic orthostatic intolerance (nine women, one man, 22 to 47 years) and nine age- and sex-matched control subjects. RESULTS: In patients, mean (+/- SD) arterial pressure at 0 degrees head-up tilt was 90 +/- 11 mm Hg and was well maintained at all tilt angles (90 +/- 11 mm Hg at 75 degrees). In controls, mean arterial pressure was 85 +/- 7 mm Hg at 0 degrees and 82 +/- 11 mm Hg at 75 degrees head-up tilt. There was a substantial decrease in peak velocity with increasing tilt angle in patients (28% +/- 10%) but not in controls (10% +/- 10% at 75 degrees, P <0.001). Similarly, mean velocity decreased 26% +/- 13% in patients and 12% +/- 11% in controls (P = 0.01). With increasing head-up tilt, patients had a significantly greater increase in regional cerebrovascular resistance than controls. CONCLUSIONS: In patients with idiopathic orthostatic intolerance, peak and mean middle cerebral artery blood flow velocity decreased in response to head-up tilt despite well sustained arterial blood pressure. These observations indicate that in this group of patients, regulation of cerebrovascular tone may be impaired and might therefore be a target for therapeutic interventions.
A New Generation of Intelligent Trainable Tools for Analyzing Large Scientific Image Databases
In a variety of scientific disciplines two-dimensional digital image data is now relied on as a basic component of routine scientific investigation. The proliferation of image acquisition hardware such as multi-spectral remote-sensing platforms, medical imaging sensors, and high-resolution cameras have led to the widespread use of image data in fields such as atmospheric studies, planetary geology, ecology, agriculture, glacielogy, forestry, astronomy, diagnostic medicine, to name but a few.
M and D SIG progress report: Laboratory simulations of LDEF impact features
Laboratory impact experiments are needed to understand the relationship between a measured penetration hole diameter and associated projectile dimension in the thermal blankets of experiment A0178, which occupied some 16 sq. m. These blankets are composed of 125 micron thick Teflon that has an Ag/enconel second mirror surface, backed by organic binder and Chemglaze paint for a total thickness of some 170 microns. While dedicated experiments are required to understand the penetration behavior of this compound target in detail, we report here on impact simulations sponsored by other projects into pure Teflon and aluminum targets. These experiments will allow first order interpretations of impact features on the Long Duration Exposure Facility (LDEF), and they will serve as guides for dedicated experiments that employ the real LDEF blankets, both exposed and unexposed, for a refined understanding of the LDEF's collisional environment. We employed a light gas gun to launch soda-lime glass spheres from 50 to 3200 microns in diameter that impacted targets of variable thickness. Penetration measurements are given.
Meteoroid and Debris Impact Features Documented on the Long Duration Exposure Facility: A Preliminary Report
The Long Duration Exposure Facility (LDEF) was host to several individual experiments designed to characterize aspects of the meteoroid and space-debris environment in low-Earth orbit. It was realized from the very start, however, that the most complete way to accomplish this goal was to exploit the meteoroid and debris record of the entire LDEF. The Meteoroid and Debris Special Investigation Group (M&D SIG) was organized to achieve this end. Two dominant goals of the M&D SIG are the documentation of the impact record of the entire LDEF, and the dissemination of this information to all interested workers. As a major step towards the accomplishment of these goals, we have prepared this publication describing the M&D SIG observations of impact features made during LDEF deintegration activities at KSC in the spring of 1990. It is hoped that this report will serve as a useful guide for spacecraft designers as well as for meteoroid and space-debris workers, and that it will spur further work on the LDEF impact-laden surfaces collected by the M&D SIG and now available for allocation to qualified investigators. An important aim is to present all data and descriptions of impact features in a form which, though terse, remains comprehensible to the wider community. There is a deliberate minimum of interpretations. Thus, this catalog is intended to serve as a guide to the impact features found on LDEF and is not intended to stand as a definitive interpretive work.