Engineering topics

Atwal, M.

Publications and source records attributed to Atwal, M..

5 records

NASA NTRS1984

Noise path identification using face-to-face and side-by-side microphone arrangements

In large complex structures, with several major sound transmission paths and high levels of background noise, it can be a complex task to locate and rank the contribution of an individual sound transmission path. The two microphone acoustic intensity techniques are investigated as a tool for path identification. Laboratory tests indicate that, if the intensity transmitted through a particular section of the fuselage is measured in the presence and absence of flanking paths using the face to face and side by side microphone arrangements, then no significant difference exists between the two measured intensities if the face to face microphone arrangement is used. However, if the side by side arrangement is used, then considerable difference exists between the two measured intensities.

Atwal, M.↗

NASA NTRS1984

Measurement of the absorption coefficient using the sound-intensity technique

The possibility of using the sound intensity technique to measure the absorption coefficient of a material is investigated. This technique measures the absorption coefficient by measuring the intensity incident on the sample and the net intensity reflected by the sample. Results obtained by this technique are compared with the standard techniques of measuring the change in the reverberation time and the standing wave ratio in a tube, thereby, calculating the random incident and the normal incident adsorption coefficient.

Atwal, M.↗

NASA NTRS1984

Study of double wall panels for use in propeller driven aircraft

Propeller driven aircraft have exhibited high levels of interior noise. Most absorption materials are not effective at low frequencies where maximum noise levels occur. Two panels separated by an air gap are suggested as an alternative means of noise attenuation. This design produces an impedance mismatch where a sound wave travels backwards to the source. The higher the impedance, the higher the reflected soundwave intensity. Two aluminum panels with helium in between and two panels with one being perforated were investigated. Helium increases the transmission loss because of a greater impedance mismatch than air. The transmission loss of the unperforated panel is higher throughout the frequency range tested.

Atwal, M.↗

NASA NTRS1984

Prediction of light aircraft interior sound pressure level using the room equation

The room equation is investigated for predicting interior sound level. The method makes use of an acoustic power balance, by equating net power flow into the cabin volume to power dissipated within the cabin using the room equation. The sound power level transmitted through the panels was calculated by multiplying the measured space averaged transmitted intensity for each panel by its surface area. The sound pressure level was obtained by summing the mean square sound pressures radiated from each panel. The data obtained supported the room equation model in predicting the cabin interior sound pressure level.

Atwal, M.↗

NASA NTRS1983

Light aircraft sound transmission study

The revived interest in the design of propeller driven aircraft is based on increasing fuel prices as well as on the need for bigger short haul and commuter aircraft. A major problem encountered with propeller driven aircraft is propeller and exhaust noise that is transmitted through the fuselage sidewall structure. Part of the work which was conducted during the period April 1 to August 31, 1983, on the studies of sound transmission through light aircraft walls is presented.

Atwal, M.↗