Search NASA⌕ Search

Engineering topics

Auciello, Orlando

Publications and source records attributed to Auciello, Orlando.

Dielectric behavior related to TiOx phase change to TiO2 in TiOx/Al2O3 nanolaminate thin films

We previously demonstrated that TiOx/Al2O3 nanolaminates (TAO NL) exhibit abnormally high-dielectric constant k (800-1000), due to Maxwell-Wagner polarization, via charge accumulation at insulating Al2O3/semiconducting TiOx interfaces. Here, we report TAO NL dielectric properties related to TiOx phase change in TiOx (0.9 nm)/Al2O3 (0.1 nm) NL. High-resolution transmission electron microscopy shows amorphous TiOx phase change to crystalline anatase TiO2 due to free-energy minimization. The phase change induce reduction in leakage current and dielectric loss (J = 10(-2) to 10(-4) A/cm(2), tan delta = 10 to 10(-1)), still with k similar to 600 up to MHz, compared to amorphous TAO NLs.

Lee, Geunhee↗

Microwave plasma enhanced chemical vapor deposition of nanocrystalline diamond films by bias-enhanced nucleation and bias-enhanced growth

Effects of biasing voltage-current relationship on microwave plasma enhanced chemical vapor deposition of ultrananocrystalline diamond (UNCD) films on (100) silicon in hydrogen diluted methane by bias-enhanced nucleation and bias-enhanced growth processes are reported. Three biasing methods are applied to study their effects on nucleation, growth, and microstructures of deposited UNCD films. Method A employs 320 mA constant biasing current and a negative biasing voltage decreasing from −490 V to −375 V for silicon substrates pre-heated to 800 °C. Method B employs 400 mA constant biasing current and a decreasing negative biasing voltage from −375 V to −390 V for silicon pre-heated to 900 °C. Method C employs −350 V constant biasing voltage and an increasing biasing current up to 400 mA for silicon pre-heated to 800 °C. UNCD nanopillars, merged clusters, and dense films with smooth surface morphology are deposited by the biasing methods A, B, and C, respectively. Effects of ion energy and flux controlled by the biasing voltage and current, respectively, on nucleation, growth, microstructures, surface morphologies, and UNCD contents are confirmed by scanning electron microscopy, high-resolution transmission-electron-microscopy, and UV Raman scattering.

36 MATERIALS SCIENCE↗

Tailoring dielectric relaxation in ultra-thin high-dielectric constant nanolaminates for nanoelectronics

The work reported here demonstrates the feasibility of controlling the dielectric properties-high dielectric constant (k) and substantially extended relaxation frequency-of thin film nanolaminates (NLs) consisting of alternating TiOx and Al2O3 sublayers with various sublayer thicknesses grown by atomic layer deposition. For 150 nm thick TiOx/Al2O3 NLs with sub-nanometer thick sublayers, few Angstrom change in sublayer thickness dramatically increases relaxation cut-off frequency by more than 3 orders of magnitude with high dielectric constant (k > 800). This unusual phenomenon is discussed in the framework of two-phase Maxwell-Wagner relaxation.

Lee, Geunhee↗

Cell Growth on Different Types of Ultrananocrystalline Diamond Thin Films

Unique functional materials provide a platform as scaffolds for cell/tissue regeneration. Investigation of cell-materials’ chemical and biological interactions will enable the application of more functional materials in the area of bioengineering, which provides a pathway to the novel treatment for patients who suffer from tissue/organ damage and face the limitation of donation sources. Many studies have been made into tissue/organ regeneration. Development of new substrate materials as platforms for cell/tissue regeneration is a key research area. Studies discussed in this paper focus on the investigation of novel ultrananocrystalline diamond (UNCD) films as substrate/scaffold materials for developmental biology. Specially designed quartz dishes have been coated with different types of UNCD films and cells were subsequently seeded on those films. Results showed the cells’ growth on UNCD-coated culture dishes are similar to cell culture dishes with little retardation, indicating that UNCD films have no or little inhibition on cell proliferation and are potentially appealing as substrate/scaffold materials. The mechanisms of cell adhesion on UNCD surfaces are proposed based on the experimental results. The comparisons of cell cultures on diamond-powder-seeded culture dishes and on UNCD-coated dishes with matrix-assisted laser desorption/ionization—time-of-flight mass spectroscopy (MALDI-TOF MS) and X-ray photoelectron spectroscopy (XPS) analyses provided valuable data to support the mechanisms proposed to explain the adhesion and proliferation of cells on the surface of the UNCD platform.

59 BASIC BIOLOGICAL SCIENCES↗

Development of a Robust, High Current, Low Power Field Emission Electron Gun for a Spaceflight Reflectron Time-of-Flight Mass Spectrometer

Carbon materials, including carbon nanotubes (CNTs) and nitrogen-incorporated ultrananocrystalline diamond (N-UNCD), have been of considerable interest for field emission applications for over a decade. In particular, robust field emission materials are compelling for space applications due to the low power consumption and potential for miniaturization. A reflectron time-of-flight mass spectrometer (TOF-MS) under development for in situ measurements on the Moon and other Solar System bodies uses a field emitter to generate ions from gaseous samples, using electron ionization. For these unusual environments, robustness, reliability, and long life are of paramount importance, and to this end, we have explored the field emission properties and lifetime of carbon nanotubes and nitrogen-incorporated ultrananocrystalline diamond (N-UNCD) thin films, the latter developed and patented by Argonne National Laboratory. We will present recent investigations of N-UNCD as a robust field emitter, revealing that this material offers stable performance in high vacuum for up to 1000 hours with threshold voltage for emission of about 3-4 V/lJm and current densities in the range of tens of microA. Optimizing the mass resolution and sensitivity of such a mass spectrometer has also been enabled by a parallel effort to scale up a CNT emitter to an array measuring 2 mm x 40 mm. Through simulation and experiment of the new extended format emitter, we have determined that focusing the electron beam is limited due to the angular spread of the emitted electrons. This dispersion effect can be reduced through modification of the electron gun geometry, but this reduces the current reaching the ionization region. By increasing the transmission efficiency of the electron beam to the anode, we have increased the anode current by two orders of magnitude to realize a corresponding enhancement in instrument sensitivity, at a moderate cost to mass resolution. We will report recent experimental and modeling results to describe the performance of a field emission electron gun as employed in the Volatile Analysis by Pyrolysis of Regolith (VAPoR) TOF-MS prototype.

Southard, Adrian E.↗

Systematic studies of the nucleation and growth of ultrananocrystalline diamond films on silicon substrates coated with a tungsten layer

We report on effects of a tungsten layer deposited on silicon surface on the effectiveness for diamond nanoparticles to be seeded for the deposition of ultrananocrystalline diamond (UNCD). Rough tungsten surface and electrostatic forces between nanodiamond seeds and the tungsten surface layer help to improve the adhesion of nanodiamond seeds on the tungsten surface. The seeding density on tungsten coated silicon thus increases. Tungsten carbide is formed by reactions of the tungsten layer with carbon containing plasma species. It provides favorable (001) crystal planes for the nucleation of (111) crystal planes by Microwave Plasma Enhanced Chemical Vapor Deposition (MPECVD) in argon diluted methane plasma and further improves the density of diamond seeds/nuclei. UNCD films grown at different gas pressures on tungsten coated silicon which is pre-seeded by nanodiamond along with heteroepitaxially nucleated diamond nuclei were characterized by Raman scattering, field emission-scanning electron microscopy, and high resolution-transmission electron microscopy.

36 MATERIALS SCIENCE↗

Integration of dissimilar materials for advanced multifunctional devices

A device including a layered heterostructure with an oxygen-containing material, with a carbon layer and an amorphous oxygen diffusion barrier protecting the carbon layer from etching by oxygen. One or more of a metal, a carbide or an oxide may be in contact with the amorphous oxygen diffusion barrier that has the lowest free energy of oxide formation in the device. Various devices are disclosed as are varieties of carbon allotropes. Methods of protecting carbon, such as diamond from the oxygen etching in processes such as device manufacture are also disclosed.

36 MATERIALS SCIENCE↗

Layered CU-based electrode for high-dielectric constant oxide thin film-based devices

A layered device including a substrate; an adhering layer thereon. An electrical conducting layer such as copper is deposited on the adhering layer and then a barrier layer of an amorphous oxide of TiAl followed by a high dielectric layer are deposited to form one or more of an electrical device such as a capacitor or a transistor or MEMS and/or a magnetic device.

36 MATERIALS SCIENCE↗

Method to grow pure nanocrystalline diamond films at low temperatures and high deposition rates

A method of depositing nanocrystalline diamond film on a substrate at a rate of not less than about 0.2 microns/hour at a substrate temperature less than about 500.degree. C. The method includes seeding the substrate surface with nanocrystalline diamond powder to an areal density of not less than about 10.sup.10sites/cm.sup.2, and contacting the seeded substrate surface with a gas of about 99% by volume of an inert gas other than helium and about 1% by volume of methane or hydrogen and one or more of acetylene, fullerene and anthracene in the presence of a microwave induced plasma while maintaining the substrate temperature less than about 500.degree. C. to deposit nanocrystalline diamond on the seeded substrate surface at a rate not less than about 0.2 microns/hour. Coatings of nanocrystalline diamond with average particle diameters of less than about 20 nanometers can be deposited with thermal budgets of 500.degree. C.-4 hours or less onto a variety of substrates such as MEMS devices.

36 MATERIALS SCIENCE↗

Nanoscale piezoresponse studies of ferroelectric domains in epitaxial BiFeO{sub 3} nanostructures.

We report the dependence of the ferroelectric domain configuration and switching behavior on the shape (square versus round) of epitaxial BiFeO{sub 3} (BFO) nanostructures. We fabricated (001) oriented BFO(120 nm)/SrRuO{sub 3}(SRO,125 nm) film layers on (001) SrTiO{sub 3} single crystals by rf magnetron sputter deposition, and patterned them to square (500 x 500 nm{sup 2}) and round (502 nm in diameter) shaped nanostructures by focused ion-beam lithography. The surface morphology and the crystalline structure of the nanostructures were characterized by scanning electron microscopy and x-ray diffraction, respectively, while the domain configuration was investigated using piezoelectric force microscopy. We found that the square-shaped nanostructures exhibit a single variant domain configuration aligned along the [{bar 1}1{bar 1}] direction, whereas the round-shaped nanostructures exhibit seven variants of domain configuration along the [{bar 1}1{bar 1}], [1{bar 1}{bar 1}], [11{bar 1}], [111], [{bar 1}11], [1{bar 1}1], and [{bar 1}{bar 1}1] directions. Moreover, local d{sub 33} piezoelectric coefficient measurements showed hysteresis loops with a strong displacement in the voltage axis (strong imprint) for the square-shaped nanostructures, while the round-shaped ones exhibited more symmetric loops. These findings have critical implications for the development of nanocapacitors for gigabyte to terabyte nonvolatile ferroelectric memories.

36 MATERIALS SCIENCE↗

Orlando Auciello

Orlando Auciello talks about receiving AAAS fellowship and Argonne National Laboratory.

AAAS↗