Spatially resolved measurements of load current delivery on a 14 MA, 100 ns pulsed power experiment using a line-imaging velocity interferometer
Not Available
43 PARTICLE ACCELERATORS↗
Engineering topics
Austin, Kevin N.
Publications and source records attributed to Austin, Kevin N..
A compact x-ray diffraction system for dynamic compression experiments on pulsed-power generators
Pulsed-power generators can produce well-controlled continuous ramp compression of condensed matter for high-pressure equation-of-state studies using the magnetic loading technique. X-ray diffraction (XRD) data from dynamically compressed samples provide direct measurements of the elastic compression of the crystal lattice, onset of plastic flow, strength–strain rate dependence, structural phase transitions, and density of crystal defects, such as dislocations. Here, we present a cost-effective, compact, pulsed x-ray source for XRD measurements on pulsed-power-driven ramp-loaded samples. This combination of magnetically driven ramp compression of materials with a single, short-pulse XRD diagnostic will be a powerful capability for the dynamic materials’ community to investigate in situ dynamic phase transitions critical to equation of states. Finally, we present results using this new diagnostic to evaluate lattice compression in Zr and Al and to capture signatures of phase transitions in CdS.
47 OTHER INSTRUMENTATION↗
Current-adder pulsed power generators for high-pressure dynamic material studies.
Abstract not provided.
Reisman, David↗
Fielding and analyzing performance of a prototype high voltage output gas switch for Saturn
Timing spread between the thirty-six Saturn modules affects peak electrical power delivered to the Bremsstrahlung diode and can affect vacuum power flow and impedance behavior of the load. To reduce the module spread, a new megavolt gas-insulated closing switch was developed employing design techniques developed for the Z-machine laser triggered switches while retaining Saturn’s simpler electrical triggering. Two modules were temporarily outfitted with the new switches and used separately into local resistive loads (instead of the usual Saturn electron beam load). A reliable operating point and switch time jitter at that point were the goals of the experiments. The target switch reliability is less than one pre-fire in one thousand switch-shots, and a timing standard deviation of 4 nanoseconds. The switches were able to meet both requirements but the number of tests at the chosen point are limited.
43 PARTICLE ACCELERATORS↗