Search NASA⌕ Search

Engineering topics

Austin, M E

Publications and source records attributed to Austin, M E.

Verification and validation of linear gyrokinetic simulation of Alfven eigenmodes in the DIII-D tokamak

A verification and validation study is carried out for a sequence of reversed shear Alfven instability time slices. The mode frequency increases in time as the minimum (q{sub min}) in the safety factor profile decreases. Profiles and equilibria are based upon reconstructions of DIII-D discharge (no. 142111) in which many such frequency up-sweeping modes were observed. Calculations of the frequency and mode structure evolution from two gyrokinetic codes, GTC and GYRO, and a gyro-Landau fluid code TAEFL are compared. The experimental mode structure of the instability was measured using time-resolved two-dimensional electron cyclotron emission imaging. The three models reproduce the frequency upsweep event within {+-}10% of each other, and the average of the code predictions is within {+-}8% of the measurements; growth rates are predicted that are consistent with the observed spectral line widths. The mode structures qualitatively agree with respect to radial location and width, dominant poloidal mode number, ballooning structure, and the up-down asymmetry, with some remaining differences in the details. Such similarities and differences between the predictions of the different models and the experimental results are a valuable part of the verification/validation process and help to guide future development of the modeling efforts.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Measurements of hard x-ray emission from runaway electrons in DIII-D

The spatial distribution of runaway electron (RE) strikes to the wall during argon pellet-initiated rapid shutdown of diverted and limited plasma shapes in DIII-D is studied using a new array of hard x-ray (HXR) scintillators. Two plasma configurations were investigated: an elongated diverted H-mode and a low-elongation limited L-mode. HXR emission from MeV level REs generated during the argon pellet injection is observed during the thermal quench (TQ) in diverted discharges from REs lost into the divertor. In limiter discharges, this prompt TQ loss is reduced, suggesting improved TQ confinement of REs in this configuration. During the plateau phase when the plasma current is carried by REs, toroidally symmetric HXR emission from remaining confined REs is seen. Transient HXR bursts during this RE current plateau suggest the presence of a small level of wall losses due to the presence of an unidentified instability. Eventually, an abrupt final loss of the remaining RE current occurs. This final loss HXR emission shows a strong toroidal peaking and a consistent spatiotemporal evolution that suggests the development of a kink instability.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Contributions of Electron Cyclotron Waves to Performance in Advanced Regimes on DIII-D

High-power electron cyclotron (EC) waves are used to increase performance in several Advanced Tokamak (AT) regimes on DIII-D where there is a simultaneous need for high noninductive current and high beta. In the Quiescent High-confinement mode (QH-mode), a direct measurement of the electron cyclotron current drive (ECCD) profile is made using modulation techniques, and a trapped electron mode (TEM) dominated regime with core T{sub e}>T{sub i} is created. In the 'highq{sub min}' AT scenario, ECCD provides part of the off-axis noninductive current and helps to produce a tearing stable equilibrium. In the hybrid regime, strong central current drive from EC waves and other sources increases the noninductive current fraction to {approx_equal}100%. Surprisingly, the core safety factor remains above unity, meaning good alignment between the current drive profile and the desired plasma current profile is not necessary in this scenario.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Measurements and modeling of Alfven eigenmode induced fast ion transport and loss in DIII-D and ASDEX Upgrade

Neutral beam injection into reversed magnetic shear DIII-D and ASDEX Upgrade plasmas produces a variety of Alfvenic activity including toroidicity-induced Alfven eigenmodes and reversed shear Alfven eigenmodes (RSAEs). These modes are studied during the discharge current ramp phase when incomplete current penetration results in a high central safety factor and increased drive due to multiple higher order resonances. Scans of injected 80 keV neutral beam power on DIII-D showed a transition from classical to AE dominated fast ion transport and, as previously found, discharges with strong AE activity exhibit a deficit in neutron emission relative to classical predictions. By keeping beam power constant and delaying injection during the current ramp, AE activity was reduced or eliminated and a significant improvement in fast ion confinement observed. Similarly, experiments in ASDEX Upgrade using early 60 keV neutral beam injection drove multiple unstable RSAEs. Periods of strong RSAE activity are accompanied by a large (peak {delta}S{sub n}/S{sub n{approx_equal}}60%) neutron deficit. Losses of beam ions modulated at AE frequencies were observed using large bandwidth energy and pitch resolving fast ion loss scintillator detectors and clearly identify their role in the process. Modeling of DIII-D loss measurements using guiding center following codes to track particles in the presence of ideal magnetohydrodynamic (MHD) calculated AE structures (validated by comparison to experiment) is able to reproduce the dominant energy, pitch, and temporal evolution of these losses. While loss of both co and counter current fast ions occurs, simulations show that the dominant loss mechanism observed is the mode induced transition of counter-passing fast ions to lost trapped orbits. Modeling also reproduces a coherent signature of AE induced losses and it was found that these coherent losses scale proportionally with the amplitude; an additional incoherent contribution scales quadratically with the mode amplitude.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Pellet interaction with runaway electrons

We describe results from recent experiments studying interaction of solid polystyrene pellets with a runaway electron current channel generated after cryogenic argon pellet rapid shutdown of DIII-D. Fast camera imaging shows the pellet trajectory and continuum emission from the subsequent explosion, with geometric calibration providing detailed explosion analysis and runaway energy. Electron cyclotron emission also occurs, associated with knock-on electrons broken free from the pellet by RE which then accelerate and runaway, and also with a short lived hot plasma blown off the pellet surface. In addition, we compare heating and explosion times from observations and a model of pellet heating and breakdown by runaway interaction. (C) 2011 Elsevier B.V. All rights reserved

43 PARTICLE ACCELERATORS↗

Experiments in DIII-D toward achieving rapid shutdown with runaway electron suppression

Experiments have been performed in the DIII-D tokamak [J. L. Luxon, Nucl. Fusion 42, 614 (2002)] toward understanding runaway electron formation and amplification during rapid discharge shutdown, as well as toward achieving complete collisional suppression of these runaway electrons via massive delivery of impurities. Runaway acceleration and amplification appear to be well explained using the zero-dimensional (0D) current quench toroidal electric field. 0D or even one-dimensional modeling using a Dreicer seed term, however, appears to be too small to explain the initial runaway seed formation. Up to 15% of the line-average electron density required for complete runaway suppression has been achieved in the middle of the current quench using optimized massive gas injection with multiple small gas valves firing simultaneously. The novel rapid shutdown techniques of massive shattered pellet injection and shell pellet injection have been demonstrated for the first time. Experiments using external magnetic perturbations to deconfine runaways have shown promising preliminary results.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Probing plasma turbulence by modulating the electron temperature gradient

The local value of a/L{sub Te}, a turbulence drive term, was modulated with electron cyclotron heating in L-mode discharges on DIII-D [J. L. Luxon, Nucl. Fusion 42, 614 (2002)] and the density and electron temperature fluctuations in low, intermediate, and high-k regimes were measured and compared with nonlinear gyrokinetic turbulence simulations using the GYRO code [J. Candy and R. E. Waltz, J. Comput. Phys. 186, 545 (2003)]. The local drive term at rhoapprox0.6 was reduced by up to 50%, which produced comparable reductions in electron temperature fluctuations at low-k. At intermediate k, k{sub t}hetaapprox4 cm{sup -1} and k{sub t}hetarho{sub s}approx0.8, a very interesting and unexpected result was observed where density fluctuations increased by up to 10% when the local drive term was decreased by 50%. Initial comparisons of simulations from GYRO with the thermal diffusivity from power balance analysis and measured turbulence response are reported. Simulations for the case with the lowest drive term are challenging as they are near the marginal value of a/L{sub Te} for trapped electron mode activity.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Resonant Pedestal Pressure Reduction Induced by a Thermal Transport Enhancement due to Stochastic Magnetic Boundary Layers in High Temperature Plasmas

Good alignment of the magnetic field line pitch angle with the mode structure of an external resonant magnetic perturbation (RMP) field is shown to induce modulation of the pedestal electron pressure p{sub e} in high confinement high rotation plasmas at the DIII-D tokamak with a shape similar to ITER, the next step tokamak experiment. This is caused by an edge safety factor q{sub 95} resonant enhancement of the thermal transport, while in contrast, the RMP induced particle pump out does not show a significant resonance. The measured p{sub e} reduction correlates to an increase in the modeled stochastic layer width during pitch angle variations matching results from resistive low rotation plasmas at the TEXTOR tokamak. These findings suggest a field line pitch angle resonant formation of a stochastic magnetic edge layer as an explanation for the q{sub 95} resonant character of type-I edge localized mode suppression by RMPs.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Advanced techniques for neoclassical tearing mode control in DIII-D

Two techniques were developed at DIII-D [J. L. Luxon, Nucl. Fusion 42, 64 (2002)] to tackle ITER-specific aspects of neoclassical tearing mode (NTM) control, namely, (1) the relatively small size of the rotating islands, smaller than the electron cyclotron current drive (ECCD) deposition region, and (2) the increased tendency of the islands, compared to present devices, to lock to the wall or to the residual error field, in a position not necessarily accessible to ECCD. Modulated ECCD is known to suppress small islands more efficiently, when ''broad,'' than continuous ECCD. At DIII-D, a NTM of poloidal/toroidal mode numbers m/n=3/2 was completely stabilized by a new technique where oblique electron cyclotron emission acted at the same time as an indicator of good alignment between ECCD and the island, and as a waveform generator, for modulation in synch and in phase with the island O-point. In another experiment, after locking in an unfavorable position, a 2/1 island was steered by externally generated magnetic perturbations, brought in the view of the gyrotrons and partly stabilized by ECCD in the island O-point. Magnetic perturbations were also used to sustain and control the mode rotation, which has the potential for an easier ECCD modulation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Localized Turbulence Suppression and Increased Flow Shear near the q=2 Surface during Internal-Transport-Barrier Formation

Broadband turbulent fluctuations in the plasma density are transiently suppressed when low-order rational q surfaces first appear in negative central magnetic shear plasmas on the DIII-D tokamak, which can lead to the formation of internal transport barriers. Increased localized flow shear is simultaneously observed. It transiently exceeds the measured turbulence decorrelation rate, providing a mechanism to trigger the formation of the transport barrier. This increased flow shear and turbulence suppression propagates radially outward, following the q=2 surface.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗