Engineering topics
Awal, M. A.
Publications and source records attributed to Awal, M. A..
Medium Voltage Solid State Transformer for Extreme Fast Charging Applications
A modular and scalable solid state transformer (SST) with direct medium voltage (MV) AC connectivity is proposed to enable DC extreme fast charging (XFC) of electric vehicles. Single-phase-modules (SPMs), each consisting of an active-front-end (AFE) stage and an isolated DC-DC stage, are connected in input-series-output-parallel (ISOP) configuration. The modular hardware is co-designed with decentralized control of the DC-DC stages where voltage and power balancing are achieved by each SPM using only its local sensor feedback; a centralized controller (CC) regulates the low voltage (LV) DC bus through the AFE stages without any sensor feedback form the SPMs. The controller architecture contrasts sharply with the prior art for MV AC to LV DC SSTs where high-speed bidirectional communication among SPMs and a CC are required for module-level voltage and power balancing, which severely limits the scalability and practical realization of higher voltage and higher power units. Detailed small-signal analysis and controller design guidelines are developed. Furthermore, a soft start-up strategy is presented. The proposed converter and control structure are validated through simulation and experimental results.
Decentralized Interleaving of Cascaded H-Bridge Multi-Level Converters
This document proposes a simple method to decentralize the interleaving for cascaded H bridge (CHB) converters. In the proposed approach, a single signal sent from the Central controller (CC) to Local Controllers (LC) contains information about the desired pulse width and is synchronized with respect to other LC. While centralized controllers need individual signals for each of the CHB modules, the proposed method requires a single signal per phase which decreases the number of PWM channels needed. A detailed explanation of the proposed method is presented. Experimental results are presented that show the interleaving of two CHB modules for an example DC to AC application.
An efficient plasmonic photovoltaic structure using silicon strip-loaded geometry
We show that a silicon thin-film photovoltaic structure with silicon strips on the top and grooves on the silver back contact layer can absorb incident solar energy over a broad spectral range. The silicon strips on the top scatter the incident light and significantly help couple to the photonic modes in the smaller wavelength range. The grooves on the silver back contact layer both scatter the incident light and help couple to the photonic modes and resonant surface plasmon polaritons. We find an increase of ∼46% in total integrated solar absorption in the proposed strip-loaded structure compared to that in a planar thin film structure of same dimensions. The proposed structure offers simpler fabrication compared to similar plasmonic-inspired designs.