B Venkatachari | Search NASA

NASA NTRS2021

Transition Analysis for the CRM-NLF Wind Tunnel Configuration

This paper presents the results of an ongoing study into the linear stability characteristics of the boundary layer flow over the common research model with natural laminar flow (CRMNLF) aircraft configuration. The flow conditions match selected test conditions from a recent wind tunnel experiment in the National Transonic Facility at the NASA Langley Research Center. Previous work involving parallel stability computations of a boundary layer flow based on the conical flow approximation has shown that the measured onset of laminar-turbulent transition during the experiments can be correlated with the linear amplification of Tollmien- Schlichting (TS) and stationary crossflow (CF) instabilities in the swept wing boundary layer. Here, we examine the effects of the simplifying approximations in both basic state computation and the stability analysis, with the goal of quantifying the resulting changes in the N-factor correlations. Specifically, the basic states are computed by using full Navier-Stokes equations and the stability analysis is performed by using a nonorthogonal coordinate system that allows a clear distinction between planar TS and CF instabilities. Furthermore, the effects of curvature and nonparallel mean flow have been included in the stability computations based on the parabolized stability equations (PSE). The fully turbulent Reynolds-Averaged-Navier-Stokes (RANS) mean flow solutions show good agreement with the measured wall pressure distribution. Viscous-inviscid interactive effects are observed to be important because the shock fronts along the suction surface are influenced by the imposed transition front. The stability results confirm the previous findings related to TS amplification within the inboard region of the wing and the dominance of stationary CF modes in the outboard region. However, given the close proximity of the measured transition front and the dual shock system within the outer part of the wing, the onset of transition may well be shock limited within the outboard region. In general, the transition criterion based on the dual N-factor method with N TS = N CF = 6 is reasonably successful at correlating with the measured transition fronts at Re MAC = 15 million and AoA = 1.5, 2 degrees; however, the low values of the correlating N-factors at Re MAC = 17.5 million support the hypothesis that the measured transition at the higher Reynolds number may have been strongly influenced by the merging of turbulent wedges that originate from surface imperfections near the leading edge.

Boundary layer transition↗

NASA NTRSDate not supplied

Near-Body Mesh Adaption for Transitional Flows Using OVERFLOW

Accurate modeling of boundary-layer transition is an important aspect of developing greener air transport technologies. In that regard, transition models based on auxiliary transport equations offer a robust approach that is easily integrated into the Reynolds-averaged Navier-Stokes (RANS) solvers. Recent workshops under NATO and AIAA have identified the verification of transport-equations-based transition modeling as a critical aspect of reducing the scatter between the predictions of different CFD codes. Follow-on work has highlighted the need for highly dense grids to achieve an asymptotic convergence of transition related flow metrics. The present work examines the role of automatic near-body mesh adaptation capability in the NASA OVERFLOW CFD solver to enable verification studies in an efficient manner, and for establishing best practices for designing grids for the RANS-based transition models. A sensor function relevant to the Langtry-Menter \gamma-Re_{\theta t}\ transition model has been identified and used for error-based mesh adaptation for canonical configurations comprising a flat plate, and the S809 and NLR-7301 airfoils. The efficacy of the mesh adaptation approach is assessed for flow conditions involving multiple transition scenarios such as natural transition, separation-induced transition, and shock-induced transition. The results from this exploratory study indicate that the meshes adapted using the proposed sensor provide solutions that approach the references solutions obtained with uniformly refined hand-crafted meshes, in terms of the chosen metrics, and yield modest yet significant savings in grid count. We also highlight areas for improvement in the grid adaptation methodology within OVERFLOW.

CFD↗