Search NASA⌕ Search

Engineering topics

Baartman, R

Publications and source records attributed to Baartman, R.

Charge state breeding for the acceleration of radioactive ions at TRIUMF

A 14.5 GHz electron cyclotron resonance ion source (PHOENIX from Pantechnik) has been set up at the Isotope Separation and ACceleration (ISAC) facility at TRIUMF for the charge state breeding of radioactive ions. After extensive testing and optimization on a test bench it has been moved on-line and put into operation. During a first test in 2008 a beam of {sup 80}Rb{sup 14+} was successfully created from {sup 80}Rb{sup 1+} and accelerated by the ISAC postaccelerator. Further tests with different stable and radioactive isotopes from the ISAC on-line sources and from a test source with stable Cs have been carried out. Until now an efficiency of 1.4% for {sup 124}Cs{sup 20+} has been obtained.

43 PARTICLE ACCELERATORS↗

The ECRIS charge state breeding project at TRIUMF

The performance of charge state breeding with an electron cyclotron resonance (ECR) ion source intended to increase the charge state of online produced radioactive ions at the ISAC facility at TRIUMF has been investigated. A 14 GHz PHOENIX from PANTECHNIK has been setup on a test bench. Singly charged ions have been produced with several ion sources typical for the on-line operation and were injected into the charge breeder. The main purpose of the tests has been the optimization of the efficiency for the charge breeding into the desired charge state. Maximum efficiencies reached so far with the standard one step deceleration of the ions in front of the plasma are up to about 6% for noble gas ions and about 3.5% for alkalines. As ion optics simulations show, the acceptance can be increased by a two step deceleration. In order to meet the velocity acceptance of the accelerator at different A/q values a similar two gap acceleration system for the highly charged ions has been installed to allow the source to run at different voltages. For the further beam transport to the accelerator, cross sections for charge exchange of the highly charged ions with the residual gas have been determined.

43 PARTICLE ACCELERATORS↗

Off-line ion source terminal for ISAC at TRIUMF

The off-line ion source (OLIS) terminal consists of a microwave cusp ion source, either a surface ion source or a hybrid surface-arc discharge ion source and an electrostatic switch that allows selecting any one of the sources without mechanical intervention. These sources provide variety of beams to ISAC experiments, for commissioning the accelerators, for setting up the radioactive experiments, and for tuning the beam lines. The microwave ion source has been operational since 1995 and provides singly and doubly charged beams from various stable isotopes for many ISAC experiments at high and low energy areas. Originally its prime goal was to provide beams from gaseous elements, but later two ovens and a sputtering system were added in order to provide beams from liquids and from solids. The surface ion source installed in 2002 can provide low energy spread beams from alkali and semialkali elements. It also has three separate ovens and an ionizer. Therefore, it can provide three different temperature regions simultaneously to provide different beams to ISAC. It is mainly used for laser spectroscopy experiments and other experiments, which require a finite beam quality. A hybrid surface-arc discharge ion source was also developed and installed in order to meet specific demands from experiments. This source terminal is now automated for start up and for mass selection. It is capable of providing stable beams for months without maintenance and it is also capable of providing negative ion beams if required. To date, over 40 different isotopes including many rear isotopes were delivered to various experiments from the OLIS source terminal. Performances of the ion sources and some of the results are discussed.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗