Search NASA⌕ Search

Engineering topics

Babin, S A

Publications and source records attributed to Babin, S A.

Calculation and experimental verification of a collimator with a Kerr lens for fibre laser mode locking

We present the calculation and experimental verification of the operation of a collimator coupling a light beam into an optical fibre with an As{sub 2}S{sub 3} nonlinear plate. It is shown that a Kerr lens formed in the plate with an increase in the peak pulse power leads to an increase in the output coupling ratio by about 15%, which can be used for the passive mode locking of a fibre laser. (lasers)

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Ultralong fibre-optic distributed Raman temperature sensor

We have demonstrated an ultralong (up to 85 km in length) all-fibre Raman temperature sensor which utilises SMF-28 standard single-mode telecom fibre and a 1.63-μm probe signal source. The probe signal from the laser diode is amplified by a Raman fibre amplifier. The temperature along a 85-km-long fibre line has been measured with an accuracy of 8 °C and spatial resolution of 800 m or better. (laser applications and other topics in quantum electronics)

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Long-period fibre grating writing with a slit-apertured femtosecond laser beam (λ = 1026 nm)

We report on long-period grating (LPG) writing in a standard telecom fibre, SMF-28e+, via refractive index modification by femtosecond pulses. A method is proposed for grating writing with a slit-apertured beam, which enables one to produce LPGs with reduced background losses and a resonance peak markedly stronger than that in the case of grating writing with a Gaussian beam. The method can be used to fabricate LPGs for use as spectral filters of fibre lasers and sensing elements of sensor systems. (fibre and integrated-optical structures)

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Tunable random fiber laser

An optical fiber is treated as a natural one-dimensional random system where lasing is possible due to a combination of Rayleigh scattering by refractive index inhomogeneities and distributed amplification through the Raman effect. We present such a random fiber laser that is tunable over a broad wavelength range with uniquely flat output power and high efficiency, which outperforms traditional lasers of the same category. Outstanding characteristics defined by deep underlying physics and the simplicity of the scheme make the demonstrated laser a very attractive light source both for fundamental science and practical applications.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Raman fiber lasers with a random distributed feedback based on Rayleigh scattering

We demonstrate lasing based on a random distributed feedback due to the Raman amplified Rayleigh backscattering in different types of cavities with and without conventional point-action reflectors. Quasistationary generation of a narrowband spectrum is achieved despite the random nature of the feedback. The generated spectrum is localized at the reflection or gain spectral maxima in schemes with and without point reflectors, respectively. The length limit for a conventional cavity and the minimal pump power required for the lasing based purely on a random distributed feedback are determined.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Low frequency noise distributed-feedback ytterbium fibre laser

We report a single-frequency 1-W fibre laser source emitting at 1093 nm, composed of a distributed-feedback ytterbium fibre laser and fibre-optic amplifier. The laser frequency was stabilised by side-locking to a transmission peak of a Fabry - Perot interferometer, and the residual frequency noise spectrum of the laser was measured. Our results indicate that the laser linewidth can be narrowed down below 1 kHz. (lasers)

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗