Engineering topics

Bailey, S.

Publications and source records attributed to Bailey, S..

59 records · Page 4

NASA NTRS1994

Status of Diffused Junction p(+)n InP Solar Cells for Space Applications

Recently, we have succeeded in fabricating diffused junction p(+)n(Cd,S) InP solar cells with measured AMO, 25 C open circuit voltage (V(sub OC)) of 887.6 mV, which, to the best of our knowledge, is higher than previously reported V(sub OC) values for any InP homojunction solar cells. The experiment-based projected achievable efficiency of these cells using LEC grown substrates is 21.3%. The maximum AMO, 25 C efficiency recorded to date on bare cells is, however, only 13.2%. This is because of large external and internal losses due to non-optimized front grid design, antireflection (AR) coating and emitter thickness. This paper summarizes recent advances in the technology of fabrication of p(+)n InP diffused structures and solar cells, resulted from a study undertaken in an effort to increase the cell efficiency. The topics discussed in this paper include advances in: 1) the formation of thin p(+) InP:Cd emitter layers, 2) electroplated front contacts, 3) surface passivation and 4) the design of a new native oxide/AI203/MgF2 three layer AR coating using a chemically-grown P-rich passivating oxide as a first layer. Based on the high radiation resistance and the excellent post-irradiation annealing and recovery demonstrated in the early tests done to date, as well as the projected high efficiency and low-cost high-volume fabricability, these cells show a very good potential for space photovoltaic applications.

Faur, Mircea↗

NASA NTRS1994

Airborne ROWS data report for the high resolution experiment, June 1993

Airborne radar ocean wave spectrometer (ROWS) data collected during the Office of Naval Research's High Resolution Remote Sensing Experiment of June 1993 are presented. This data summary covers six flights made using NASA's T-39 aircraft over a region of the North Atlantic off the coast of North Carolina and includes multiple crossings of the gulf stream. The Ku-band ROWS was operated in a configuration which continuously switched between an altimeter and a spectrometer channel. Data derived from the two channels include altimeter radar cross section, altimeter-derived sea surface mean square slope and wind speed, and directional and nondirectional longwave spectra. Discussion is provided for several events of particular interest.

Vandemark, D.↗

NASA NTRS1993

ROWS wave spectral data collected in SAXON-FPN, November 1990

High-resolution directional wave spectra obtained with the NASA Ku-band radar ocean wave spectrometer (ROWS) on the Naval Research Laboratory P-3 aircraft during SAXON-FPN (SAR and X-Band Ocean Nonlinearities Experiment-Forschungsplattform Nordsee) experiments in the North Sea in November 1990 are presented. This experiment was the first in which the ROWS was operated with its new pc-based high-speed digital data acquisition system.

Jackson, F.↗

NASA NTRS1992

Common lunar lander

This report focuses on the reference lander design developed at the Johnson Space Center, describing a small lunar soft lander with the capability to soft land about 64 kilograms of payload at any lunar latitude and longitude. The Artemis lander is a sun-pointing, three-axis vehicle that contributes to the translunar injection burn and performs the lunar orbit insertion, deorbit, descent and landing maneuvers with a single liquid bipropellant lander stage. Attention is given to mission profile and performance, the guidance, navigation and control subsystem, the propulsion subsystem, and the flight data subsystem.

Bailey, S.↗

NASA NTRS1985

Liquid metal cooled reactors for space power applications

The technology basis for evaluation of liquid metal cooled space reactors is summarized. Requirements for space nuclear power which are relevant to selection of the reactor subsystem are then reviewed. The attributes of liquid metal cooled reactors are considered in relation to these requirements in the areas of liquid metal properties, neutron spectrum characteristics, and fuel form. Key features of typical reactor designs are illustrated. It is concluded that liquid metal cooled fast spectrum reactors provide a high confidence, flexible option for meeting requirements for SP-100 and beyond.

Bailey, S.↗