Engineering topics

Bakr, Osman M.

Publications and source records attributed to Bakr, Osman M..

11 records

DOE OSTI2024

In situ energetics modulation enables high-efficiency and stable inverted perovskite solar cells

In contrast to conventional (n-i-p) perovskite solar cells (PSCs), inverted (p-i-n) PSCs offer enhanced stability and integrability with tandem solar cell architectures, which have garnered increasing interest. However, p-i-n cells suffer from energy level misalignment with transport layers, imbalanced transport of photo-generated electrons and holes, and significant defects with the perovskite films. Here we introduce tris(2,4,6-trimethyl-3-(pyridin-3-yl)phenyl)borane (3TPYMB), a nonionic n-type molecule that, through hydrogen bonding and Lewis acid-base reactions with perovskite surfaces or grain boundaries, enables in situ modulation of perovskite energetics, effectively mitigating the key challenges of p-i-n PSCs. The p-i-n PSCs incorporating 3TPYMB achieve a certified quasi-steady-state power conversion efficiency of 24.55 +- 0.33%, with a reverse scan efficiency of 25.58%. Finally, they also exhibit exceptional stability, with unencapsulated devices retaining 97.8% of their initial efficiency after 1,800 h of continuous operation at maximum power point under N 2 atmosphere, 1 sun illumination and 60 °C conditions.

14 SOLAR ENERGY↗

DOE OSTI2024

Correction to: Imaging Light–Induced Migration of Dislocations in Halide Perovskites with 3D Nanoscale Strain Mapping

Owing to an error in properly normalizing the reconstruction phase data into atomic displacements, the strain values that we used to calculate the root mean squared local strain, ε rms , and to calculate the fraction of the crystals more strain than 1%, f, quoted in the original paper, are roughly one order of magnitude too large. This error was only discovered recently whilst performing further analysis.

36 MATERIALS SCIENCE↗

DOE OSTI2023

Imaging Light‐Induced Migration of Dislocations in Halide Perovskites with 3D Nanoscale Strain Mapping

Abstract In recent years, halide perovskite materials have been used to make high‐performance solar cells and light‐emitting devices. However, material defects still limit device performance and stability. Here, synchrotron‐based Bragg coherent diffraction imaging is used to visualize nanoscale strain fields, such as those local to defects, in halide perovskite microcrystals. Significant strain heterogeneity within MAPbBr 3 (MA = CH 3 NH 3 + ) crystals is found in spite of their high optoelectronic quality, and both 〈100〉 and 〈110〉 edge dislocations are identified through analysis of their local strain fields. By imaging these defects and strain fields in situ under continuous illumination, dramatic light‐induced dislocation migration across hundreds of nanometers is uncovered. Further, by selectively studying crystals that are damaged by the X‐ray beam, large dislocation densities and increased nanoscale strains are correlated with material degradation and substantially altered optoelectronic properties assessed using photoluminescence microscopy measurements. These results demonstrate the dynamic nature of extended defects and strain in halide perovskites, which will have important consequences for device performance and operational stability.

36 MATERIALS SCIENCE↗

DOE OSTI2022

Photoactivated p-Doping of Organic Interlayer Enables Efficient Perovskite/Silicon Tandem Solar Cells

Solution-processed organic semiconductor layers on rough surfaces tend to vary widely in thickness, significantly hindering charge extraction in relevant optoelectronic devices. Herein, we report the photoactivated p-doping of hole-transporting material (HTM) to enhance hole extraction for (textured) perovskite/silicon tandem solar cells, making the device performance less sensitive to the variation of hole transport layer thickness. We used the ionic compound 4-isopropyl-4'-methyldiphenyliodonium tetrakis(penta-fluorophenyl-borate) (DPI-TPFB) as a p-type dopant in poly(triaryl amine) (PTAA), which we used as the HTM. We observed that light soaking DPI-TPFB-doped PTAA shows approximately 22 times higher conductivity compared with an undoped PTAA film, which translated into an improved fill factor (FF) for tandem solar cells. Our tandem solar cells achieved an ~80% FF and 27.8% efficiency and operated at their maximum power point for 200 h without loss of performance, in addition to retaining ~83% of initial performance over a month of operation in an outdoor environment.

CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSICS,S↗

DOE OSTI2022

Overcoming Degradation Pathways to Achieve Stable Blue Perovskite Light-Emitting Diodes

Mixed halide (Br/Cl) perovskite nanocrystals (NCs) that represent an advanced blue emitter commonly suffer from spectral instability and poor lifespan; notably, the lack of understanding of the failure mechanisms of these devices has restricted the future progress. Here, we determine that the degradation of CsPbBr x Cl 3– x NCs containing blue light-emitting diodes (LEDs) is due to the combination of two effects. Cl – drift among adjoining NCs under an electric field is found to induce a Cl-deficient material region in multiple NC layers, which dominates the unstable electroluminescence and causes fast degradation in the corresponding devices. In comparison, the monolayer NC devices that feature restricted anion drift pathways exhibit better operational stability; however, excess hole injection is demonstrated to induce irreversible chlorine loss in NCs. Such a process that largely arises from electrochemical oxidation of Cl – initiates a mild device failure in operation of tens of minutes. Through revealing these mechanisms, we modulate the devices’ construction and operational conditions to achieve a longer lifespan.

14 SOLAR ENERGY↗

DOE OSTI2021

Single-Particle Spectroscopy as a Versatile Tool to Explore Lower-Dimensional Structures of Inorganic Perovskites

The remarkable defect tolerant nature of inorganic cesium halide perovskites leading to near unity photoluminescence (PL) quantum yield (QY) and narrow emission linewidth across the entire visible spectrum, have provided a tantalizing platform for a development of a plethora of light-emitting applications. Recently, lower dimensional (2D, 1D, and 0D) perovskites have attracted further attention due to the enhanced thermal, photo and chemical stability as compared to their three-dimensional (3D) analogues. Combination of the external size quantization and internal octahedral organization provides a unique opportunity to study and harness “multidimensional” electronic properties engineered both on atomic scale and the nanoscale. However, crucial research to understand the elementary charge carrier dynamics in lower dimensional perovskites lags far behind the enormous effort to incorporate them into optoelectronic devices. In this Perspective, we provide a review of recent developments that focus on studies of the dynamics of excitonic complexes in Cs-based perovskite nanocrystals using single-particle time-resolved PL spectroscopy and photon correlation measurements. Single photon statistical studies not only offer the unprecedented level of detail to directly assess various recombination pathways but also provide insights into specifics of carrier’s localization. Further, we discuss the underlying physicochemical processes that govern PL emission and draw attention to a number of attributes within this class of the materials, especially lower-dimensional perovskites that may indicate the common origin of the PL emission, as well as provide a route map for the vast unexplored territories where single particle spectroscopy can be a powerful tool to unravel crucial information.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021