Search NASA⌕ Search

Engineering topics

Balakrishnan, A.

Publications and source records attributed to Balakrishnan, A..

16 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

Radiation heat transfer in the wake of a hypersonic vehicle

Radiation heat transfer (RHT) from the wake of a hypersonic vehicle to its afterbody is evaluated from Gnoffo and Greene's (1987) calculated wake flowfield and the radiative properties of ionized high-temperature air with the calculated nonequilibrium composition. The 4.2-m aeroassisted flight experiment at an altitude of 75 km and velocity of 8900 m/s causes a 0.1-m-thick layer initially at T = 10,000 K and P = 1 kN/sq m to separate from the shoulder of the forebody heat shield and spread aft to form a wake at approximately T = 5000 K and P = 20 N/sq m. Gas in the separated flow region at approximately T = 3000 K and P = 10 N/sq m, recirculates about the afterbody. It is shown that the radiating layer, recirculating gases, and wake are optically thin for purposes of making engineering RHT calculations. Directional, spectral, and spatial variations of the radiation incident upon the afterbody are presented.

Babikian, D. S.↗
NASA NTRS1988

A computational study of heat transfer for laminar hypervelocity flows

Computational Fluid Dynamics (CFD) codes are routinely used to predict the flowfield and the heating environment around complex reentry configurations. At hypervelocities, where the velocity is greater than 3 km/sec, the AFWAL version of the blunt body code predicts the correct surface pressure distributions but underpredicts laminar wall heat fluxes. This study was performed to determine the reasons for the underprediction. The computer code chosen solves thin-layer Navier-Stokes equations in a time-asymptotic manner and assumes a constant isentropic exponent. Flowfields around a spherical configuration at various entry velocities are computed. The computed pressure distributions agree well with the tabulated, inviscid results of Lyubimov and Rusanov for entry velocities ranging from 0.6 to 5.92 km/sec. At hypervelocities, the calculated stagnation point heat transfer rates were lower by roughly fifty percent when compared to engineering correlations available in the literature. Good comparisons between heat transfer rates are obtained at hypervelocity entry conditions provided the CFD code is modified to include equilibrium air properties.

Balakrishnan, A.↗
NASA NTRS1987

Application of a flux-split algorithm to chemically relaxing, hypervelocity blunt-body flows

Viscous, nonequilibrium, hypervelocity flow fields over two axisymmetric configurations are numerically simulated using a factored, implicit, flux-split algorithm. The governing gas-dynamic and species-continuity equations for laminar flow are presented. The gas-dynamics/nonequilibrium-chemistry coupling procedure is developed as part of the solution procedure and is described in detail. Numerical solutions are presented for hypervelocity flows over a hemisphere and over an axisymmetric aeroassisted orbital transfer vehicle using three different chemistry models. The gas models considered are those for an ideal gas, for a frozen gas, and for chemically relaxing air consisting of five species. The calculated results are compared with existing numerical solutions in the literature along the stagnation line of the hemisphere. The effects of free-stream Reynolds number on the nonequilibrium flow field are discussed.

Balakrishnan, A.↗
NASA NTRS1986

Simulating AOTV heating environment in an arc jet

The application of arc-jet facilities to the simulation of the combined radiative and convective heating environments calculated for AOTV return missions is presented. The AOTV mission requirement and design configuration determine the magnitude of the radiative and convective heating rates. This paper considers methods for obtaining radiation from the high temperature plasma in arc-jet flows. A computer code that predicts arc-heater performance was used to determine the effect of gas mixtures on arc-heater performance, with the intent of increasing the gas temperature and resultant radiative emission. Numerical radiation solutions were compared with direct measurements of the radiative intensity from the gas cap. Convective heating measurements were made as well. The arc-jet was operated at AOTV enthalpy and pressure levels for these measurements to assess the simulation capabilities for AOTV material development/testing. A parametric study is presented that defines the capability of the Interaction Heating Facility arc jet at Ames to simulate both the radiative and the convective heating for current AOTV configurations.

Balboni, J.↗
NASA NTRS1986

Radiative Viscous Shock Layer Analysis of Fire, Apollo, and PAET Flight Data

Equilibrium, radiating viscous shock layer solutions are obtained for a number of trajectory points of the Fire II, Apollo 4, and PAET experimental flight vehicles. Convective heating rates calculated by a benchmark code agree well with two engineering correlations, except at high altitudes corresponding to low densities. Calculated radiation intensities are compared with the flight radiometer data and with inviscid flow results. Differences as great as 70% are observed between measured data and the viscous calculations. Because of boundary-layer absorption, viscous effects reduce the intensity to the wall by as much as 30% compared with inviscid intensities. Preliminary chemical and thermal nonequilibrium flow calculations along a stagnation streamline for a PAET trajectory predict an enhancement to the radiation owing to the chemical relaxation. Stagnation point solutions are also presented for future aeroassisted orbital transfer vehicle geometries with nose radii of 0.3-15 m.

Balakrishnan, A.↗
NASA NTRS1985

Radiative viscous-shock-layer analysis of Fire, Apollo, and PAET flight data

Equilibrium, radiating viscous-shock-layer solutions are obtained for a number of trajectory points of the Fire II, Apollo 4, and PAET experimental flight vehicles. Convective heating rates calculated by a benchmark code agree well, except at high altitudes corresponding to low densities, with two engineering correlations. Calculated radiation intensities are compared with the flight radiometer data and with inviscid flow results. Differences as great as 70 percent are observed between measured data and the viscous calculations. Viscous effects reduce the intensity toward the wall, because of boundary-layer absorption, by as much as 30 percent, compared with inviscid intensities. Preliminary chemical and thermal nonequilibrium flow calculations along a stagnation streamline for a PAET trajectory predict enhancement of radiation owing to chemical relaxation. Stagnation point solutions are also presented for future air-assisted orbital transfer vehicle geometries with nose radii ranging from 0.3 to 15 m.

Balakrishnan, A.↗
NASA NTRS1985

Radiometer experiment for the aeroassist flight experiment

A forthcoming NASA flight experiment is described that provides an opportunity to obtain a large base of radiometric data for high-altitude, high-velocity thermochemically nonequilibrated-flow conditions. As a preliminary to the design of a radiometer for this experiment, an approximate method for predicting both equilibrium and nonequilibrium radiative surface fluxes is described. Spectral results for one trajectory state, a velocity of 10 km/sec at an altitude of 85 km, are presented. These results are then used to develop some of the instrument parameters that will be needed for designing of the three genre of radiometers that are proposed for this experiment.

Davy, W. C.↗
NASA NTRS1985

Aerothermodynamic environment for a Titan probe with deployable decelerator

It is pointed out that further exploration of Titan, Saturn's largest moon, is of current interest to the scientific community, particularly from the standpoint of the organic chemical evolution of its atmosphere. For a suitable study of this Saturnian satellite, a mission involving a Titan atmospheric entry probe is to be conducted. The probe is to employ a deployable decelerator with the aim to allow scientific measurements in the haze layer. The present investigation is concerned with an assessment of the aerothermodynamic environment for the considered probe during its hypervelocity, low-Reynolds-number entry. Attention is given to the employed computational method, the Titan probe configuration, the Titan probe trajectory, the viscous-layer regime of the aerothermodynamic environment, and the incipient merged-layer regime.

Green, M. J.↗
NASA NTRS1985

Experimental and analytical derivation of arc-heater scaling laws for simulating high-enthalpy environments for Aeroassisted Orbital Transfer Vehicle application

The computer code ARCFLO II was used as a guide to increase the performance of the Interaction Heating Facility at Ames Research Center. A closed-form scaling law relation was derived that provides an understanding of the factors that affect enthalpy in the constricted-arc heater. From a study of this scaling law, it is concluded that at constant pressure, enthalpy is proportional to current density raised to the 0.60 power for current densities from 80 to 150 A/sq cm. At constant current density, enthalpy is inversely proportional to pressure to the nth power, where n varies from 0.14 to 0.43, depending on the current density. Radiative heat losses are responsible for the falloff in performance at combinations of high current density and high pressure. An analytical, closed form scaling law based on a constant-temperature arc-core model agrees qualitatively with the scaling law deduced from ARCFLO II.

Winovich, W.↗
NASA NTRS1985

Ablation of Galileo Probe heat-shield models in a ballistic range

Several 1/24-scale models of the Galileo Probe made of carbon-phenolic materials were flown in a ballistic range to test their ablation characteristics. Mostly radiative or all-convective heating environments were produced by using argon or air as the test gas, respectively, to simulate the Jovian entry heating environments. The experimental results were compared with the theoretical predictions made using the computer codes of radiating shock layer environment (RASLE) and charring materials ablation (CMA). The experimental data obtained in argon agreed approximately with the theoretical predictions. The data for air agreed approximately with the theory when turbulence and surface roughness effects were accounted for. The data imply that the Galileo Probe heat shield was adequately designed.

Park, C.↗
NASA NTRS1984

Flowfield computation of an aerobrake orbital transfer vehicle

Viscous real gas and ideal gas supersonic flowfields over the forebody of a aeroassisted orbital transfer vehicle are determined using a unsteady factored implicit algorithm. Air in chemical equilibrium is considered and its local thermodynamic properties are computed by an equilibrium composition method. Numerical solutions are obtained for both real and ideal gases at a Mach number of 30 and at angles of attack up to 20 degrees. Shock stand-off distances and surface pressure distributions are presented for the gas models with and without viscous effects. For the freestream conditions considered, viscous effects dominate the flow.

Balakrishnan, A.↗
NASA NTRS1983

Viscous real gas flowfields about three dimensional configurations

Laminar, real gas hypersonic flowfields over a three dimensional configuration are computed using an unsteady, factored implicit scheme. Local chemical and thermodynamic properties are evaluated by an equilibrium composition method. Transport properties are obtained from individual species properties and application of a mixture rule. Numerical solutions are presented for an ideal gas and equilibrium air for free-stream Mach numbers of 13 and 15 and at various angles of attack. The effect of real gas is to decrease the shock-layer thickness resulting from decreased shock-layer temperatures and corresponding increased density. The combined effects of viscosity and real gas are to increase the subsonic layer near the wall.

Balakrishnan, A.↗
NASA NTRS1983

Real gas flow fields about three dimensional configurations

Real gas, inviscid supersonic flow fields over a three-dimensional configuration are determined using a factored implicit algorithm. Air in chemical equilibrium is considered and its local thermodynamic properties are computed by an equilibrium composition method. Numerical solutions are presented for both real and ideal gases at three different Mach numbers and at two different altitudes. Selected results are illustrated by contour plots and are also tabulated for future reference. Results obtained compare well with existing tabulated numerical solutions and hence validate the solution technique.

Balakrishnan, A.↗
NASA NTRS1981

Galileo probe forebody thermal protection - Benchmark heating environment calculations

Solutions are presented for the aerothermal heating environment for the forebody heatshield of candidate Galileo probe. Entry into both the nominal and cool-heavy model atmospheres were considered. Solutions were obtained for the candidate heavy probe with a weight of 310 kg and a lighter probe with a weight of 290 kg. In the flowfield analysis, a finite difference procedure was employed to obtain benchmark predictions of pressure, radiative and convective heating rates, and the steady-state wall blowing rates. Calculated heating rates for entry into the cool-heavy model atmosphere were about 60 percent higher than those predicted for the entry into the nominal atmosphere. The total mass lost for entry into the cool-heavy model atmosphere was about 146 kg and the mass lost for entry into the nominal model atmosphere was about 101 kg.

Balakrishnan, A.↗
NASA NTRS1979

Galileo probe thermal protection: Entry heating environments and spallation experiments design

A valid procedure was developed for predicting wall heating and ablation rates about the probe forebody. Entropy layer effects on convective heating rate were analyzed and the computed results are given. A feasibility study to perform an experiment, the selection of a candidate test facility, and the definition of a test matrix are described. The material selection, fabrication, and evaluation of the metal containing carbon-carbon composites for use on the Galileo probe are summarized. The effect of various Jovian atmospheric models on entry heating environment is considered as well as the effect of the nonspherical shape of the planet on entry trajectory.

Balakrishnan, A.↗