Engineering topics

Bansal, Shubhra

Publications and source records attributed to Bansal, Shubhra.

4 records

DOE OSTI2023

Degradation behavior of CIGS solar Cells: A parametric analysis

A parametric study of the effect of bulk and interface properties on device characteristics as a function of heat and light stress under open-circuit and short-circuit conditions is developed for Cu(In,Ga)(S,Se) 2 solar cells using SCAPS-1D simulator. The variables and interdependencies modeled include: (1) conduction band offset (CBO) between buffer and absorber; (2) buffer ionized donor density; (3) CIGS shallow acceptor density; (4) CIGS deep acceptor density; (5) CIGS shallow donor density; (6) ionized acceptor concentration in the ordered vacancy compound (OVC) CIGS/buffer interface; and (7) back contact work-function. An increase in absorber shallow acceptor or a decrease in shallow donor density results in an increase in net carrier density and open-circuit voltage (V OC ). Further, a decrease in V OC is observed with an increase in the deep acceptors or neutral midgap defects in the CIGS due to higher charge carrier recombination. A change of CBO from spike to cliff condition is a dominant mechanism of decreasing VOC with an interface defect density of 10 12 cm -2 . The minimum depletion width is found to be specifically sensitive to CBO and interface defect density. An inflection in the capacitance–voltage curves (in reverse bias) is observed with simultaneous increase in bulk deep acceptor density and shallow donor density near the back contact.

14 SOLAR ENERGY↗

DOE OSTI2020

Metastability and Long-Term Degradation in CIGS Devices: Effect of Alkali Treatments, Back Contact and Emitter Layers

Thin-film solar cell technologies often suffer from metastable and long-term performance degradation, which may or may not be reversible. The presence of the transient or degradation issues pose challenges for energy-yield prediction in the field for these technologies. Cu(In,Ga)(S,Se) 2 solar cells are a promising thin-film technology, however, the underlying mechanisms of instability in these devices are not well understood. The most common mechanism of metastability in CIGS solar cells has been speculated to be the configuration changes of (VSe-VCu) divacancy complex. However, the role of metastability in light soaking behavior and the effect of alkali treatments and buffer layers is not understood. The goal of the current project is to understand the effect of alkali treatments and buffer materials on metastability and light soaking behavior and develop a device model to simulate experimental results. Input parameters are taken from literature or derived from first-principle calculations, and are fine-tuned through validation experiments.

14 SOLAR ENERGY↗

DOE OSTI2020

Behavior of Na and RbF-Treated CdS/Cu(In,Ga)Se 2 Solar Cells with Stress Testing under Heat, Light, and Junction Bias

In this work, the effects of Na and RbF alkali treatment on the metastability behavior of CdS/Cu(In,Ga)Se 2 solar cells are investigated with stress factors of heat, junction bias, and illumination. Four device types with and without Na or RbF treatments are subjected to heat- and light-soaking under open- and short-circuit (OC, SC) junction bias. Low-Na devices show a higher bandgap due to increased minimum Ga content, higher recombination current, and lower open-circuit voltage (V OC ). Devices with RbF post-deposition treatment (PDT) show an improvement in net doping density ≈10 16 cm –3 , V OC , and efficiency. Heat- and light-soaking under OC junction bias provokes an increase in net carrier concentration and V OC irrespective of the alkali treatments. After SC stress, a decrease in V OC and net carrier concentration is observed, which can be stabilized by RbF-PDT. An increase in Na and oxygen concentration in CIGS is observed for baseline and low-Na devices, respectively, after OC stress. The oxygen concentration in CdS decreases after heat- and light-soaking for devices without RbF-PDT, whereas it remains unchanged for devices with RbF-PDT. The atomic concentration profiles in CIGS significantly stabilize as a function of stress with the addition of RbF-PDT.

14 SOLAR ENERGY↗

DOE OSTI2020

Quantifying Large Lattice Relaxations in Photovoltaic Devices

Temporal variations of Cu(In,Ga)Se 2 photovoltaic device properties during light exposure at various temperatures and voltage biases for times up to 100 h are analyzed using the kinetic theory of large lattice relaxations. Open-circuit voltage and p-type doping increased with charge injection and decreased with temperature at low injection conditions. Furthermore, lattice relaxation can account for both trends and activation energies extracted from the data are approximately 0.9 and 1.2 eV for devices with lower and higher sodium content, respectively. In these devices, increased sodium content resulted in higher initial p-type doping with greater stability. First-principles calculations providing revised activation energies for the (V Se -V Cu ) complex suggest that this defect does not account for the metastability observed here.

14 SOLAR ENERGY↗