Engineering topics

Bar-Sever, A.

Publications and source records attributed to Bar-Sever, A..

4 records

NASA NTRS1989

Separation control on an airfoil by periodic forcing

The introduction of transverse velocity fluctuations into a separated shear layer on an airfoil at high angles of attack is presently demonstrated to be an effective separation-control technique. Airfoil aerodynamic characteristics, including poststall lift and drag as well as maximum lift coefficient and stall angle, all exhibited improvements controlled forcing at 20 deg angle of attack led to an increased spreading of the mean velocity profile, together with increased turbulence activity; separation moved from the leading edge to about 80 percent of chord.

Bar-Sever, A.↗

NASA NTRS1988

Flow control in a wing/fuselage-type juncture

The laminar flow around a juncture formed by an unswept wing and a flat plate has been studied using a combination of smoke flow visualization, and velocity and pressure measurements. The effectiveness of swept leading-edge fillets in controlling the juncture flow field has been evaluated. Flow separation upstream of the wing leading edge is confined to a small region near the plate. This separation results in periodic shedding of horseshoe type vortices. The pressure gradient measured upstream of the leading edge in this laminar juncture is steeper than that of the turbulent flow case. The use of fillets eliminates the leading-edge flow separation and reduces the size of juncture wake, as observed from flow visualization. For one of the filleted cases, there is a significant increase in the extent of laminar flow in the juncture region, and a sizable reduction in the juncture drag.

Kubendran, L. R.↗

NASA NTRS1987

Effect of acoustic excitation on the flow over a low-Re airfoil

Wind-tunnel measurements of lift, drag, and wake velocity spectra were carried out under (tonal) acoustic excitation for a smooth airfoil in the chord-Reynolds-number Re(c) range of 40,000-140,000. The data were supported by smoke-wire flow-visualization pictures. Small-amplitude excitation in a wide, low-frequency range is found to eliminate laminar separation that otherwise degrades the airfoil performance at low Re(c) near the design angle of attack. Excitation at high frequencies eliminates a prestall, periodic shedding of large-scale vortices. Significant improvement in lift is also achieved during poststall, but with large-amplitude excitation. Wind-tunnel resonances strongly influence the results, especially in cases requiring large amplitudes.

Zaman, K. B. M. Q.↗

NASA NTRS1986

Transition and separation control on a low-Reynolds number airfoil

The major problem associated with the aerodynamic performance of airfoils at low Reynolds numbers is the presence of extensive laminar boundary-layer separation resulting in a large increase in presssure drag and a decrease in lift. The rapid deterioration in airfoil characteristics can be largely eliminated by artificially controlling the flow through the introduction of suitable disturbances in the boundary layer such that transition occurs ahead of the anticipated laminar separation. This paper presents the results of wind-tunnel tests conducted on a 10-cm model of LRN (1)-1007 airfoil with passive (roughness trips) and active (acoustic excitation) controls to trigger transition and suppress separation. Significant improvements in the aerodynamic characteristics of the airfoil were observed. Results of this study for a chord Reynolds number range of 40,000 to 250,000 are presented in this paper.

Mangalam, S. M.↗