Search NASA⌕ Search

Engineering topics

Barengoltz, J.

Publications and source records attributed to Barengoltz, J..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2005

Hydrazine inactivates bacillus spores

Planetary Protection places requirements on the maximum number of viable bacterial spores that may be delivered by a spacecraft to another solar system body. Therefore, for such space missions, the spores that may be found in hydrazine are of concern. A proposed change in processing procedures that eliminated a 0.2 um filtration step propmpted this study to ensure microbial contamination issue existed, especially since no information was found in the literature to substantiate bacterial spore inactivation by hydrazine.

Bacillus↗
NASA NTRS2002

Microbiological cleanliness of the Mars Exploration Rover spacecraft

Planetary protection for Mars missions is described, and the approach being taken by the Mars Exploration Rover Project is discussed. Specific topics include alcohol wiping, dry heat microbial reduction, microbiological assays, and the Kennedy Space center's PHSF clean room.

planetary protection Mars Exploration Rover MER↗
NASA NTRS2000

Planetary protection technologies at the Jet Propulsion Laboratory

This paper presents a summary of the planetary protection technology development efforts currently being conducted at the Jet Propulsion Laboratory (JPL). This is a multidisciplinary effort involving JPL and NASA expertise in microbiology, material science, and analytical chemistry, in conjunction with outside, industrial academic collaborators.

planetary↗
NASA NTRS1996

Refinement of planetary protection policy for Mars missions

Under existing COSPAR policy adopted in 1984, missions to Mars (landers, probes, and some orbiters) are designated as Category IV missions. As such, the procedures for implementing planetary protection requirements could include trajectory biasing, cleanrooms, bioload reduction, sterilization of hardware, and bioshields. In 1992, a U.S. National Research Council study recommended that controls on forward contamination of Mars be tied to specific mission objectives. The report recommended that Mars landers with life detection instruments be subject to at least Viking-level sterilization procedures for bioload reduction, while spacecraft (including orbiters) without life detection instruments be subject to at least Viking-level pre-sterilization procedures for bioload reduction but need not be sterilized. In light of this, it is proposed that the current policy's Category IV and its planetary protection requirements be divided into two sub-categories as follows: Category IVa, for missions comprising landers and probes without life detection experiments, which will meet a specified bioburden limit for exposed surfaces, and Category IVb, for landers and probes with life detection experiments, which will require sterilization of landed systems. In addition, Category III orbiter mission specifications are expanded to be consistent with these recommendations.

NASA Discipline Exobiology↗
NASA NTRS1994

Revision to Planetary Protection Policy for Mars Missions

Under existing COSPAR policy adopted in 1984, missions to Mars (landers, probes, and some orbiters) are designated as Category IV missions. As such, the procedures for implementing planetary protection requirements could include trajectory biasing, cleanrooms, bioload reduction, sterilization of hardware, and bioshields, i. e. requirements could be similar to Viking. However, in 1992, a U. S. National Academy of Sciences study recommended that controls on forward contamination of Mars be tied to specific mission objectives. The report recommended that Mars landers with life detection instruments be subject to at least Viking-level sterilization procedures for bioload reduction, while spacecraft (including orbiters) without life detection instruments be subject to at least Viking-level pre sterilization procedures for bioload reduction but need not be sterilized. In light of this, it is proposed that the current policy's Category IV missions and their planetary protection requirements be divided into two subcategories as follows: Category IV A, for missions comprising landers and probes without life detection experiments and some orbiters, which will meet a specified bioburden limit for exposed surfaces; Category IV B, for landers and probes with life detection experiments, which will require complete system sterilization. For Category IV A missions, bioburden specifications will be proposed and implementing procedures discussed. A resolution will be proposed to modify the existing COSPAR policy to reflect these changes. Similar specifications, procedures, and resolution for Category IV B missions will be the subject of a later study.

DeVincenzi, D. L.↗
NASA NTRS1990

New screening methodology to select low outgassing materials for cold, spaceborne optical instruments

Standardized techniques for outgassing tests are developed and set forth for use in the screening of materials for aerospace instruments with cooled sensors, optics, and/or detectors. Materials for optical instruments are discussed in terms of molecular outgassing, and material-outgassing test results are presented which relate to several test conditions. The existing outgassing standard is found to be inadequate, and revised outgassing standards related to four application levels are given. The test protocols are designed for the development of materials for optical instruments that operate in environments with temperatures below 20 C. Consideration is also given to potential molecular contamination in the space environment and to outgas screening of instruments with a variety of sensor/optics/detector temperatures. The standards are designed for use with existing outgassing-test data as well as contamination analyses relating to the instrument being tested.

O'Donnell, T.↗
NASA NTRS1988

WF/PC internal molecular contamination during system thermal-vacuum test

During the recent system thermal vacuum test of the Wide-Field/Planetary Camera (WF/PC), instrumentation was added to the WF/PC to characterize the internal molecular contamination and verify the instrument throughput down to 1470 angstroms. Analysis of data elements revealed two contaminants affecting the far-ultraviolet (FUV) performance of the WF/PC. The one contaminant (heavy volatile) is correlated with the electronic and housing temperature, and the contamination is significantly reduced when the electronics are operated below plus 8 degrees to plus 10 degrees C. The other contaminant (light volatile) is controlled by the heat pipe temperature, and the contamination is significantly reduced when the Thermal Electric Cooler (TEC) hot-junction temperature is below minus 40 degrees to minus 50 degrees C. The utility of contamination sensors located behind instruments during system tests was demonstrated.

Taylor, Daniel M.↗
NASA NTRS1983

STS-3 Snowflake study

Videotape recordings were made of particles observed being released from the orbiter and image processing techniques were used to reduce the data in order to obtain sources and sizes. Results show that a significant number of 1 mm to 1 cm diameter particles were in the vicinity of STS-3. Their origin may be near the aft end of the orbiter; however, 19 of the 33 examined trajectories show that the origin was definitely forward of the aft end of the bay. There may be larger particles near the aft end of the orbiter. Most particles move generally rearward with respect to the orbiter (+X direction).

Barengoltz, J.↗
NASA NTRS1983

U.S. planetary protection program - Implementation highlights

The implementation of the United States planetary protection program, intended to prevent the contamination of the celestial bodies in the solar system during their exploration, in recent interplanetary projects is reviewed. The shift in planetary protection policy from that of absolute sterilization to a probabilistic approach is noted. Attention is then given to the use of microbiological assay, organic materials inventory, microbial burden reduction, contamination control, trajectory biasing and the analysis and identification of contaminating processes for purposed of planetary protection for the Pioneer 10 and 11, Viking and Voyager projects. The success of these measures, as demonstrated by the prevention of accidental planetary impact and the failure to detect terrestrial organisms by the Viking life detection experiments, is pointed out.

Barengoltz, J.↗
NASA NTRS1978

An estimate of particulates in the vicinity of a Shuttle orbiter due to meteoroid impact

An estimate of the magnitude of released particles in the vicinity of a a Shuttle (STS) Orbiter due to meteoroid impact has been completed. A calculation of the number of particles existing as surface contamination and released by such impacts has been performed. In addition, two estimates of the creation of new particles due to meteoroid cratering (backsplash) have been obtained. In each case, the total number of particles per day as a function of size without regard to velocity, as a function of velocity without regard to size, and as a joint distribution in size and velocity has been calculated.

Barengoltz, J.↗
NASA NTRS1975

Correlation of displacement effects produced by electrons, protons and neutrons in silicon

The correlation of displacement effects produced by electrons, protons, and neutrons in silicon is studied. Available data from the literature is employed. In particular the scope of the study is limited to the degradation of excess carrier lifetime and device electrical parameters directly related to it. The degree to which displacement effects may be correlated in order to predict semiconductor device response based on response data to another type of radiation is discussed. Useful ranges of the correlation factors (lifetime damage constant ratios) as a function of device majority carrier type, device resistivity, and injection level are presented. A significant dependence on injection level for the correlation factors is found.

Van Lint, V. A. J.↗
NASA NTRS1975

The Relocation of Particulate Contamination During Space Flight

A computer simulation program to model the redistribution of particulate contaminants on a spacecraft after launch is developed. The component models for particulate adhesion, meteoroid impact, and electrostatic forces are described and intermediate results are presented. The results of a sample calculation show that the recontamination process is important.

Barengoltz, J.↗
NASA NTRS1975

Spacecraft recontamination

A computer simulation program to model the redistribution of particulate contaminants on a spacecraft after launch was developed. The component models for particulate adhesion, meteoroid impact, and electrostatic forces are described and intermediate results are presented. The results of a sample calculation show that the recontamination process is important.

Barengoltz, J.↗
NASA NTRS1973

The electric field in the vicinity of a photo-emitting plate in a plasma

Knowledge of the electric field in the vicinity of a spacecraft provides necessary corrections to measurements of ambient fields and charged particle fluxes and a required parameter to understand the motion of dust particles and grains around the spacecraft. The complex problem of the entire electric field, needed for grain transport calculations, is treated for the one-dimensional case. By approximations to the analysis of a photo-emitting plate immersed in a dilute plasma, explicit expressions for the potential and the electric field were derived. The two classes of implicit solutions for the potential reported by them are shown to yield essentially identical results for the conditions in our solar system. The values were obtained following assumptions of a later paper by Guernsey and Fu, in which the emitted photoelectron distribution is taken as Maxwellian. These results are compared with a simple model due to Grand and Tunaley, wherein the effect of the dilute plasma is neglected entirely.

Barengoltz, J.↗