Engineering topics

Barnouin, O.

Publications and source records attributed to Barnouin, O..

3 records

DOE OSTI2024

Physical properties of asteroid Dimorphos as derived from the DART impact

On 26 September 2022, NASA’s Double Asteroid Redirection Test (DART) mission successfully impacted Dimorphos, the natural satellite of the binary near-Earth asteroid (65803) Didymos. Numerical simulations of the impact provide a means to find the surface material properties and structures of the target that are consistent with the observed momentum deflection efficiency, ejecta cone geometry and ejected mass. Our simulation that best matches the observations indicates that Dimorphos is weak, with a cohesive strength of less than a few pascals, like asteroids (162173) Ryugu and (101955) Bennu. We find that the bulk density of Dimorphos ρ B is lower than ~2,400 kg m – 3 and that it has a low volume fraction of boulders (≲40 vol%) on the surface and in the shallow subsurface, which are consistent with data measured by the DART experiment. These findings suggest that Dimorphos is a rubble pile that might have formed through rotational mass shedding and reaccumulation from Didymos. Our simulations indicate that the DART impact caused global deformation and resurfacing of Dimorphos. ESA’s upcoming Hera mission may find a reshaped asteroid rather than a well-defined crater.

79 ASTRONOMY AND ASTROPHYSICS↗

NASA NTRS2011

Impact Melt in Small Lunar Highlands Craters

Impact-melt deposits are a typical characteristic of complex impact craters, occurring as thick pools on the crater floor, ponds on wall terraces, veneers on the walls, and flows outside and inside the rim. Studies of the distribution of impact melt suggested that such deposits are rare to absent in and around small (km to sub-km), simple impact craters. noted that the smallest lunar crater observed with impact melt was approximately 750 m in diameter. Similarly, theoretical models suggest that the amount of melt formed is a tiny fraction (<1%) of the total crater volume and thus significant deposits would not be expected for small lunar craters. LRO LROC images show that impact-melt deposits can be recognized associated with many simple craters to diameters down to approximately 200 m. The melt forms pools on the crater floor, veneer on the crater walls or ejecta outside the crater. Such melt deposits are relatively rare, and can be recognized only in some fresh craters. These observations indicate that identifiable quantities of impact melt can be produced in small impacts and the presence of such deposits shows that the material can be aggregated into recognizable deposits. Further, the present of such melt indicates that small craters could be reliably radiometrically dated helping to constrain the recent impact flux.

Plescia, J. B.↗

NASA NTRS1990

An approach to space power

Fusion offers the potential for a very high specific power, providing a large specific impulse that can be traded-off with thrust for mission optimization. Thus fusion is a leading candidate for missions beyond the moon. A new approach is discussed for space fusion power, namely Inertial Electrostatic Confinement (IEC). This method offers a high power density in a relatively small, simple device. It appears capable of burning aneutronic fuels which are most desirable for space applications and is well suited for direct conversion. An experimental device to test the concept is described.

Miley, G. H.↗