Airoscope command system
A PCM telemetry command system is presented having a capacity of 256 unique commands, an end-to-end actuation time of less than 250 milliseconds, and an address plus complementary command code to provide security against the acceptance of anything but intended commands. The system consists of a ground-based encoder and a balloon-borne decoder, both built using low-current drain, high reliability CMOS logic elements. Commands are normally issued by a simple switch closure to +5VDC on the appropriate input line, however as a backup mode, the 8-bit command may be entered manually on 8 toggle switches and executed via a SEND button. In any case, the command is then serialized into a PCM bit stream and sent via a P-Band radio link to the DECODER aloft. All 256 outputs from the DECODER are buffered through drivers and thus may be used to drive CMOS, TTL, or DTL logic.