Vision System for the Mars Sample Return Capture Containment and Return System (CCRS)
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Bashar Rizk.
Explore the source record for details and available documents.
Optical navigation (OpNav) is a critical subsystem of the OSIRIS-REx asteroid sample return mission, which operated in the vicinity of near-Earth asteroid (101955) Bennu from August 2018 through April 2021. A substantial amount of mission resources across multiple subsystems and institutions is required to ensure that the OpNav data are successfully acquired. The KinetX OpNav team, part of the Flight Dynamics System (FDS), is responsible for performing required analysis to develop the OpNav operations plans; requesting, reviewing and verifying the plans; and ultimately using the image data for critical navigation operations. The FDS team, responsible for the mission navigation, is operated by KinetX Aerospace with management and operations support from NASA’s Goddard Space Flight Center. The Science Processing and Operations Center (SPOC), located at the University of Arizona’s Lunar and Planetary Laboratory, is responsible for generating the planning products for all science and most OpNav data. These plans are integrated into the spacecraft sequences, tested, and commanded by the Mission Support Area (MSA) at Lockheed Martin Space. To ensure mission-critical navigation image data are successfully acquired, the plan is developed through a waterfall of planning cycles over the course of 3 months prior to onboard plan execution. During the initial strategic planning for a mission phase, detailed analysis is performed by the OpNav team to conceptualize the concept of operations (ConOps) for image data collection. This phase OpNav Narrative is included along with other strategic planning documents for the key ground segment stakeholders to review and provide feedback. The detailed OpNav plans get defined in the tactical planning cycle, which spans 8 to 3 weeks before the week-long integrated sequence is executed on-board the spacecraft. During the tactical cycle, the initial OpNav Request is submitted along with the science requests, kicking off development of the science and OpNav plans. Once the initial plan is drafted, interfaces are exercised so that the plan can be reviewed and iterated, if necessary. A rigorous schedule is followed by the planning teams during the implementation cycle, spanning the last 18 days before uplink, to ensure all the necessary integration, testing, and reviewing can occur on time. The development of the OpNav planning ConOps, including responsibilities, interfaces, timelines, and procedures, took extensive collaboration across mission elements and institutions. The process was robust throughout the 137 weeks of continuous Optical Navigation Operations at Bennu, which concluded on April 9th, 2021.
The Origins, Spectral Interpretation, Resource Identification, and Security–Regolith Explorer (OSIRIS-REx) spacecraft launched on September 8, 2016, beginning a seven-year journey to return at least 60 g of asteroid material from (101955) Bennu to Earth. During the outbound cruise, Doppler tracking of the spacecraft observed a small but measurable acceleration when the sample return capsule (SRC) was first placed in sunlight. Subsequent analysis determined that outgassing from the SRC is the most likely cause for the acceleration. This outgassing received combined engineering and scientific attention because it has potential implications both for spacecraft navigation performance and for contamination of the collected samples. Thermal modeling, laboratory studies of SRC materials, and monitoring of the acceleration are all consistent with H2O as the main component of the outgassing. Dedicated, in-flight campaigns continued to expose the SRC to sunlight until the acceleration dropped to the acceleration noise floor. Any residual amounts of H2O outgassing are not considered to be a hazard with regards to mission operations or pristine sample acquisition. The sample stow procedure has been updated to ensure that no direct line of site exists between any residual outgassing and the samples during future operations. Similar outgassing of the Stardust SRC probably also occurred. No adverse contamination of Stardust samples was observed that could be associated with this process. Future missions that use similar reentry vehicles should consider procedures to test for and, if necessary, mediate such outgassing after launch.
The Origins, Spectral Interpretation, Resource Identification, and Security–Regolith Explorer (OSIRIS-REx) spacecraft launched on September 8, 2016, beginning a seven-year journey to return at least 60 g of asteroid material from (101955) Bennu to Earth. During the outboundcruise, Doppler tracking of the spacecraft observed a small but measurable acceleration when the sample return capsule (SRC) was first placed in sunlight. Subsequent analysis determined that outgassing from the SRC is the most likely cause for the acceleration. This outgassing received combined engineering and scientific attention because it has potential implications both for spacecraft navigation performance and for contamination of the collected samples. Thermal modeling, laboratory studies of SRC materials, and monitoring of the acceleration are all consistent with H2O as the main component of the outgassing. Dedicated, in-flight campaigns continued to expose the SRC to sunlight until the acceleration dropped to the acceleration noise floor. Any residual amounts of H2O outgassing are not considered to be a hazard with regards to mission operations or pristine sample acquisition. The sample stow procedure has been updated to ensure that no direct line of site exists between any residual outgassing and the samples during future operations. Similar outgassing of the Stardust SRC probably also occurred. No adverse contamination of Stardust samples was observed that could be associated with this process. Future missions that use similar reentry vehicles should consider procedures to test for and, if necessary, mediate such outgassing after launch.
Explore the source record for details and available documents.