Engineering topics

Bassett, Will P.

Publications and source records attributed to Bassett, Will P..

3 records

DOE OSTI2025

Phase-field modeling of aging-induced microstructure evolution in pentaerythritol tetranitrate thin films and ramifications for shock initiation

Aging of energetic materials may change performance and affect their safety and reliability, but the relationship between microstructure changes induced by aging and consequent performance changes has not been fully established. This work presents results of phase-field method simulations used to model microstructure evolution of vapor-deposited pentaerythritol tetranitrate (PETN) thin films. Simulated aging is shown to induce grain coarsening and substantial changes of the configuration of porosity in the film: Specifically, we show that porosity tends to concentrate in large pores to a greater degree in aged films, a state that is arrived at by closure or consolidation of small pores. To evaluate the performance of the as-deposited and aged films, we perform two-dimensional hydrocode flyer-film impact simulations that incorporate the phase-field output microstructures directly, permitting us to connect features therein to changes in reactivity, a key metric of energy output for shock initiation. The results demonstrate that declining sensitivity obtained for the simulated aged films can be correlated with the loss of fine-structured pores relatively early in the aging process, while long-term microstructure evolution that gradually alters the shape of large, branching pores is less impactful. Finally, we discuss commonalities and discrepancies between our simulation results and high-throughput initiation experiments on shock initiation of aged PETN thin films.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Combustion of metal powder with dinitrogen tetroxide

In this work, we present analysis of a novel reactive material system that employs dinitrogen tetroxide (N 2 O 4 ) as a liquid oxidizer with metal powder fuels. The oxidizer was added to micron scale aluminum and zirconium powders by a remote injection system. When ignited with a high voltage spark, the mixtures were observed to possess reactivity comparable to nanocomposite reactive materials, with open-tube flame expansion velocities from 500 to 1400 m/s depending on fuel/oxidizer ratio and tube diameter. Temperatures were observed to range from 3000 to 3500 K as measured with gray body fits to 16-channel time-resolved pyrometer and time-integrated spectrometer data. These values were significantly below calculated adiabatic flame temperatures, which we attribute to local deviations from stoichiometry and kinetic/energetic limitations similar to those observed in studies of particles burning in high pressures gaseous oxidizers. Al/N 2 O 4 reactivity was found to be most likely limited by the vaporization of the metal from the particle surface and Zr/N 2 O 4 was limited by slower burning and complex interactions involving the solubility of nitrogen and oxygen in the molten Zr. We also discuss the potential for these materials to be used to create an “on/off” reactive material, since N2O4 can be added remotely and driven to evaporate via vacuum or purge of inert gases to return it to a safe condition.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Shock Initiation Microscopy with High Time and Space Resolution

In this paper, we describe studies of shock initiation and shock-to-detonation transitions in energetic materials using a tabletop shock compression microscope with nanosecond time resolution and micrometer spatial resolution. Planar input shocks with durations of 4–20 ns are produced using 0–4.5 km/s laser-launched flyer plates. Emphasis is on measurements of temperature, velocities, pressure, and microstructure using photon Doppler velocimetry (PDV), optical pyrometry and high-speed videography. Techniques are discussed for fabricating disposable shock target arrays of tiny plastic-bonded explosives (PBX), liquid and powder explosives, and single-crystal explosives for high-throughput studies. Optical temperature measurements of shocked triaminotrinitrobenzene (TATB) are discussed. Since TATB is yellow, we developed methods to correct for the blue absorption to obtain more accurate temperatures. Hot spots in shocked polymer-encased HMX (octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine) crystals are observed in real-time, showing a hot spot produced in a collapsing void that ignites a deflagration. Despite the small dimensions of our explosive charges (typically 1 mm diameter and 250 μm length), we produced reproducible detonation states in solid and liquid explosives using short-duration shocks near the von Neumann spike (VNS) pressure. We show the VNS pressure is associated with a transition to high-efficiency gas production from the explosives. In studies of NM, prior to detonation, we see reaction originating at hot spots which coalesce to form a superdetonation.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗