Search NASA⌕ Search

Engineering topics

Batdorf, S B

Publications and source records attributed to Batdorf, S B.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1948

A general small-deflection theory for flat sandwich plates

A small-deflection theory is developed for the elastic behavior of orthotropic flat plates in which deflections due to shear are taken into account. In this theory, which covers all types of flat sandwich construction, a plate is characterized by seven physical constants (five stiffnesses and two Poisson ratios) of which six are independent. Both the energy expression and the differential equations are developed. Boundary conditions corresponding to simply supported, clamped, and elastically restrained edges are considered.

Libove, Charles↗
NASA NTRS1947

A simplified method of elastic-stability analysis for thin cylindrical shells I : Donnell's equation

The equation for the equilibrium of cylindrical shells introduced by Donnell in NACA Technical Report no. 479 to find the critical stresses of cylinders in torsion is applied to find critical stresses for cylinders with simply supported edges under other loading conditions. It is shown that by this method solutions may be obtained very easily and the results in each case may be expressed in terms of two nondimensional parameters, one dependent on the critical stress and the other essentially determined by the geometry of the cylinder. The influence of boundary conditions related to edge displacements in the shell median surface is discussed. The accuracy of the solutions found is established by comparing them with previous theoretical solutions and with test results. The solutions to a number of problems concerned with the buckling of cylinders with simply supported edges on the basis of a unified viewpoint are presented in a convenient form for practical use. (author)

Batdorf, S B↗
NASA NTRS1947

Critical stress of thin-walled cylinders in axial compression

Empirical design curves are presented for the critical stress of thin-walled cylinders loaded in axial compression. These curves are plotted in terms of nondimensional parameters of small-deflection theory and are compared with theoretical curves derived for the buckling of cylinders with simply supported and clamped edges. An empirical equation is given for the buckling of cylinders having a length-radius ratio greater than about 0.75. The test data obtained from various sources follow the general trend of the theoretical curve for cylinders with clamped edges, agreeing closely with the theory in the case of short cylinders, but falling considerably below the theoretical results for long cylinders. The discrepancy in the case of long cylinders increases with increasing values of the ratio of radius to wall thickness. Plotting curves for different values of this ratio reduces the scatter in the test data and a certain degree of correlation with theory is achieved. Advantage is taken of this correlation to obtain estimated design curves for cylinders with simply supported edges, for which little experimental information is available. (author)

Batdorf, S B↗
NASA NTRS1947

A Simplified Method of Elastic-Stability Analysis for Thin Cylindrical Shells

This paper develops a new method for determining the buckling stresses of cylindrical shells under various loading conditions. In part I, the equation for the equilibrium of cylindrical shells introduced by Donnell in NACA report no. 479 to find the critical stresses of cylinders in torsion is applied to find critical stresses for cylinders with simply supported edges under other loading conditions. In part II, a modified form of Donnell's equation for the equilibrium of thin cylindrical shells is derived which is equivalent to Donnell's equation but has certain advantages in physical interpretation and in ease of solution, particularly in the case of shells having clamped edges. The question of implicit boundary conditions is also considered.

Batdorf, S B↗
NASA NTRS1947

Critical stress of thin-walled cylinders in axial compression

Empirical design curves are presented for the critical stress of thin-wall cylinders loaded in axial compression. These curves are plotted in terms of the nondimensional parameters of small-deflection theory and are compared with theoretical curves derived for the buckling of cylinders with simply supported and clamped edges. An empirical equation is given for the buckling of cylinders having a length-radius ratio greater than about 0.75.

Batdorf, S B↗