Engineering topics

Battaglia, D. J.

Publications and source records attributed to Battaglia, D. J..

5 records

DOE OSTI2023

Energy transport analysis of NSTX plasmas with the TGLF turbulent and NEO neoclassical transport models

This work presents a study of plasma transport at low aspect ratio on the National Spherical Torus Experiment tokamak, where the turbulent and neoclassical energy fluxes calculated by the quasilinear Trapped Gyro Landau Fluid (TGLF) model and the multi species drift-kinetic Neoclassical solver (NEO) are validated against experimental data. The turbulent energy transport of two plasma discharges, one in the L-mode confinement regime and another in the H-mode regime, is dominated by electrostatic drift-wave instabilities, while the ion heat transport has a significant neoclassical contribution. The data analysis workflow is described in detail to understand how the variations of mapping and fitting of experimental data affect the power balance solution and subsequent flux-matching plasma profile predictions with the TGYRO solver. On average, the predicted plasma profiles are consistent with experimental data. However, the solutions are sensitive to various input parameters, including boundary conditions, and the electron-ion coupling. Linear gyrokinetic stability analysis demonstrates close agreement of the real frequencies of unstable modes between TGLF and CGYRO gyrokinetic simulations, but higher growth rates are predicted by TGLF, especially for the H-mode case. Estimates of the low-k modes' contributions to the total flux are consistent with linear stability analysis and the E × B suppression of turbulence in TGLF simulations with the SAT1 saturation model, while the SAT2 saturation model over-predicts the low-k modes' contribution in the H-mode case. Moreover, the results with SAT1 model are consistent with power balance analysis, which indicates only neoclassical ion energy fluxes inside ρ < 0.4 in the L-mode case and $\rho \unicode{x2A7D} 0.7$ in the H-mode case. The presence of multi-scale turbulence and ion-scale driven zonal flow mixing effects are also observed in TGLF scans of the electron turbulent heat flux over a range of temperature gradients and the electron-ion temperature ratio, which could explain the strong model sensitivity to variations of input parameters.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2023

Cross-machine comparison of runaway electron generation during tokamak start-up for extrapolation to ITER

A cross-machine comparison of global parameters that determine the runaway electron (RE) generation and loss process during tokamak start-up was carried out with the aim to extrapolate these to ITER. The study found that all considered discharges, also those that do not show signs of RE, are non-thermal at the start, i.e. have a streaming parameter larger than 0.1. During the current ramp-up the electric field, E, remains above the critical value, E c , that allows RE in the plasma. The distinction to be made is not if RE can form but, if sufficient RE can form fast enough such that they are detected or start to dominate the dynamics of the tokamak discharge. The dynamics of the value of E, density and temperature during tokamak are key to the formation of RE. It was found that larger devices operate with E closer to E c , due to their higher temperatures, hence the RE generation is relatively slower. The slower time scales for the formation of RE, estimated to be of the order of 100s of ms in ITER simplifies the development of avoidance schemes. The RE confinement time is also an important determinant of the entire process and is found to increase with the device size. The study also revealed that drift orbit losses, a mechanism often attributed as the main RE loss mechanism during the early tokamak discharge, are actually more difficult to achieve. RE losses might be more likely attributed to RE diffusion due to magnetic turbulence.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Studies of EC pre-ionization in DIII-D to support development of ITER plasma initiation

New experiments have been conducted at DIII-D to improve the physics understanding of plasma initiation assisted by electron cyclotron (EC) wave injection, allowing better extrapolation to ITER. This has been achieved by applying an EC pulse prior to start of the inductive plasma initiation (i.e. the generation of a loop voltage). A pre-plasma was formed during the EC pulse that was characterized in terms of the maximum density and temperature. Parametric scans were performed to study the influence of the EC injected power, EC injection angle, and pre-fill gas pressure on the pre-plasma creation process. These experiments showed that pre-ionized plasma of good quality can have a significant effect on the subsequent V loop induced plasma initiation process, i.e. a high density pre-plasma, increases the plasma current rise and speed at which ionization is achieved when the V loop is applied. Here, a good quality pre-plasma is one that achieved a significant degree of ionization, mainly obtained by providing sufficient ECH power in DIII-D of the order of 1 MW. It was found that a minimum EC power of 0.5 MW was required in DIII-D to create ionization, and this would scale to a minimum power of roughly 6.5 MW for ITER.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

NSTX-U theory, modeling and analysis results

Here, the mission of the low aspect ratio spherical tokamak NSTX-U is to advance the physics basis and technical solutions required for optimizing the configuration of next-step steady-state tokamak fusion devices. NSTX-U will ultimately operate at up to 2 MA of plasma current and 1 T toroidal field on axis for 5 s, and has available up to 15 MW of neutral beam injection power at different tangency radii and 6 MW of high harmonic fast wave heating. With these capabilities NSTX-U will develop the physics understanding and control tools to ramp-up and sustain high performance fully non-inductive plasmas with large bootstrap fraction and enhanced confinement enabled via the low aspect ratio, high beta configuration. With its unique capabilities, NSTX-U research also supports ITER and other critical fusion development needs. Super-Alfvénic ions in beam-heated NSTX-U plasmas access energetic particle (EP) parameter space that is relevant for both α-heated conventional and low aspect ratio burning plasmas. NSTX-U can also generate very large target heat fluxes to test conventional and innovative plasma exhaust and plasma facing component solutions. This paper summarizes recent analysis, theory and modelling progress to advance the tokamak physics basis in the areas of macrostability and 3D fields, EP stability and fast ion transport, thermal transport and pedestal structure, boundary and plasma material interaction, RF heating, scenario optimization and real-time control.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Impact of edge harmonic oscillations on the divertor heat flux in NSTX

Previously, ELM-free and inter-ELM divertor peak heat flux reduction induced by an edge harmonic oscillation (EHO) was observed in NSTX (K.F. Gan et al., 2017 Nucl. Fusion 57 126053). This paper introduces new analysis of the EHO impact on the divertor heat flux. It was found that enhanced edge turbulence significantly altered the divertor heat flux footprint in NSTX H-modes, relative to ELM-free discharges. When the background edge fluctuation level was low, the EHO significantly increased the heat flux width and decreased the divertor peak heat flux. When the background edge fluctuation level was high, the EHO actually increased the divertor peak heat flux. As a result, it was also found that the heat flux width increased with increasing frequency of the EHO.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗