Search NASA⌕ Search

Engineering topics

Bauer, C

Publications and source records attributed to Bauer, C.

New measurement of the {sup 68}Zn(4{sub 1}{sup +}) g factor combined with a reanalysis of previous data

We have remeasured and have redetermined the g factor for the 4{sub 1}{sup +} state in {sup 68}Zn following inconsistencies between earlier measurements and a recent result. We have reanalyzed several former measurements by applying an alternative analysis procedure, which allows for determining the precession effect separately for each gamma detector implying less uncertainties in the background subtraction for the relevant spectra. In addition, all measured g-factor and B(E2) data for the first 2{sup +} and 4{sup +} states in all stable even-A Zn isotopes and the radioactive {sup 62}Zn, are compared with new large-scale shell model calculations based on the most advanced effective interaction in the fpg-shell model space.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Production of the charmonium states {chi}{sub c1} and {chi}{sub c2} in proton nucleus interactions at {radical}(s)=41.6 GeV

A measurement of the ratio R{sub {chi}{sub c}}=({chi}{sub c}{yields}J/{psi}+{gamma})/J/{psi} in pC, pTi, and pW interactions at 920 GeV/c ({radical}(s)=41.6 GeV) in the Feynman-x range -0.35<x{sub F}{sup J/{psi}}<0.15 is presented. Both {mu}{sup +}{mu}{sup -} and e{sup +}e{sup -} J/{psi} decay channels are observed with an overall statistics of about 15 000 {chi}{sub c} events, which is by far the largest available sample in pA collisions. The result is R{sub {chi}{sub c}}=0.188{+-}0.013{sub st}(+0.024/-0.022){sub sys} averaged over the different materials, when no J/{psi} and {chi}{sub c} polarizations are considered. The {chi}{sub c1} to {chi}{sub c2} production ratio R{sub 12}=R{sub {chi}{sub c}}{sub 1}/R{sub {chi}{sub c}}{sub 2} is measured to be 1.02{+-}0.40, leading to a cross section ratio ({sigma}({chi}{sub c1})/{sigma}({chi}{sub c2}))=0.57{+-}0.23. The dependence of R{sub {chi}{sub c}} on the Feynman-x of the J/{psi}, x{sub F}{sup J/{psi}}, and its transverse momentum, p{sub T}{sup J/{psi}}, is studied, as well as its dependence on the atomic number, A, of the target. For the first time, an extensive study of possible biases on R{sub {chi}{sub c}} and R{sub 12} due to the dependence of acceptance on the polarization states of J/{psi} and {chi}{sub c} is performed. By varying the polarization parameter, {lambda}{sub obs}, of all produced J/{psi}'s by two sigma around the value measured by HERA-B, and considering the maximum variation due to the possible {chi}{sub c1} and {chi}{sub c2} polarizations, it is shown that R{sub {chi}{sub c}} could change by a factor between 1.02 and 1.21 and R{sub 12} by a factor between 0.89 and 1.16.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

A Trigger And Readout Scheme For Future Cherenkov Telescope Arrays

The next generation of ground-based gamma-ray observatories, such as e.g. CTA will consists of about 50-100 Telescopes, and cameras with in total {approx}100000 to {approx}200000 channels. The telescopes of the core array will cover and effective area of {approx}1 km{sup 2} and will be possibly accompanied by a large 'halo' of smaller telescopes spread over about 10 km{sup 2}. In order to make maximum use of the stereoscopic approach, a very flexible inter-telescope trigger scheme is needed which will allow to couple telescopes that located up to {approx}1 km apart. At the same time, the development of a cost effective readout scheme for the camera signals exhibits a major technological challenge. Here we present ideas on a new asynchronous inter-telescope trigger scheme, and a very cost-effective, high-bandwidth frontend to backend data transfer system, both based on standard Ethernet components and an Ethernet front-end interface based on mass production standard FPGAs.

79 ASTRONOMY AND ASTROPHYSICS↗

Repository Drift Backfilling Demonstrator

The 'Backfilling Demonstrator' is one of the technological demonstrators developed by ANDRA in the framework of the feasibility studies for a geological repository for high-level long-lived (HL-LL waste) within a clay formation. The demonstrator concerns the standard and supporting backfills as defined in Andra's 2005 design. The standard backfill is intended to fill up almost all drifts of the underground repository in order to limit any deformation of the rock after the degradation of the drift lining. The supporting backfill only concerns a small portion of the volume to be backfilled in order to counter the swelling pressure of the swelling clay contained in the sealing structures. The first objective of the demonstrator was to show the possibility of manufacturing a satisfactory backfill, in spite of the exiguity of the underground structures, and of reusing as much as possible the argillite muck. For the purpose of this experiment, the argillite muck was collected on Andra's work-site for the implementation of an underground research laboratory. Still ongoing, the second objective is to follow up the long-term evolution of the backfill. Approximately 200 m{sup 3} of compacted backfill material have been gathered in a large concrete tube simulating a repository drift. The standard backfill was manufactured exclusively with argillite. The supporting backfill was made by forming a mixture of argillite and sand. Operations were carried out mostly at Richwiller, close to Mulhouse, France. The objectives of the demonstrator were met: an application method was tested and proven satisfactory. The resulting dry densities are relatively high, although the moduli of deformation do not always reach the set goal. The selected objective for the demonstrator was a dry density corresponding to a relatively high compaction level (95% of the standard Proctor optimum [SPO]), for both pure argillite and the argillite-sand mixture. The plate-percussion compaction technique was used and proved satisfactory. The measured dry densities are higher than the 95%-SPO objective. The implementation rates remain very low due to the experimental conditions involved. The metal supply mode would need to be revised before any industrial application is contemplated. The Demonstrator Program started in August 2004 and is followed up today over the long term. With that objective in mind, sensors and a water-saturation system have been installed. (author)

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗