Engineering topics

Bayazitoglu, Yildiz

Publications and source records attributed to Bayazitoglu, Yildiz.

4 records

NASA NTRS2001

Space Shuttle Upgrade Liquid Oxygen Tank Thermal Stratification

In 1997, NASA initiated a study of a liquid oxygen and ethanol orbital maneuvering and reaction control system for space shuttle upgrades as well as other reusable launch vehicle applications. The pressure-fed system uses sub-cooled liquid oxygen at 2413.2 KPa (350 psia) stored passively using insulation. Thermal stratification builds up while the space shuttle is docked at the international space station. The venting from the space shuttle's liquid oxygen tank is not desired during this 96-hr time period. Once the shuttle undocks from the space station there could be a pressure collapse in the liquid oxygen tank caused by fluid mixing due to the thruster fU"ings . The thermal stratification and resulting pressure rise in the tank were examined by a computational fluid dynamic model. Since the heat transfer from the pressurant gas to the liquid will result in a decrease in tank pressure the final pressure after the 96 hours will be significantly less when the tank is pressurized with ambient temperature helium. Therefore, using helium at ambient temperature to pressurize the tank is preferred to pressurizing the tank with helium at the liquid oxygen temperature. The higher helium temperature will also result in less mass of helium to pressurize the tank.

Tunc, Gokturk↗

NASA NTRS2001

A Model for Hydrogen Thermal Conductivity and Viscosity Including the Critical Point

In order to conduct a thermal analysis of heat transfer to liquid hydrogen near the critical point, an accurate understanding of the thermal transport properties is required. A review of the available literature on hydrogen transport properties identified a lack of useful equations to predict the thermal conductivity and viscosity of liquid hydrogen. The tables published by the National Bureau of Standards were used to perform a series of curve fits to generate the needed correlation equations. These equations give the thermal conductivity and viscosity of hydrogen below 100 K. They agree with the published NBS tables, with less than a 1.5 percent error for temperatures below 100 K and pressures from the triple point to 1000 KPa. These equations also capture the divergence in the thermal conductivity at the critical point

Wagner, Howard A.↗

NASA NTRS1990

Surface tension and viscosity from damped free oscillations of viscous droplets

Damped oscillations of a viscous droplet in vacuum or in an inert gas of negligible density are considered. The dependence of the complex decay factor on the properties of the liquid is investigated for the first time, and numerical results are compared with earlier studies for special cases. A new method is developed to determine both surface tension and viscosity from a single experiment in which the damping rate and frequency of oscillations are measured. The procedure to determine surface tension and viscosity from oscillating levitated liquids is outlined, and results presented for various modes of shape oscillations.

Suryanarayana, P. V. R.↗

NASA NTRS1990

A high temperature thermal diffusivity determination procedure for solids and liquids

A new method for measuring the thermal diffusivity of materials at high temperatures is presented. The method is applicable to solids on Earth, and to liquids in the reduced gravity environment of space. It is especially suited to levitated liquid metals at elevated temperatures where thermal diffusivity data is not available. The method is applied in two parts, such that lumped analysis is valid in the first part, and Fourier's law of conduction is valid in the second. In both parts, the spherical specimen is assumed to have been heated to a desired temperature and cooled. An inverse conduction problem is then formulated and solved using Laplace transformation techniques. Using this solution, sample sizes, and experimentally obtained surface temperature history, the thermal diffusivity is determined by minimizing a function that satisifies the heat balance at the surface. Minimization is performed using a modified quasilinearization algorithm. Accuracy is very sensitive to error in the temperature data and increases with better curve fits to the temperature data. An error analysis is also performed, and the effect of errors in the various parameters on the evaluated thermal diffusivity is determined. An experimental study for solids on Earth is suggested, before development for implementation in space.

Bayazitoglu, Yildiz↗