Search NASA⌕ Search

Engineering topics

Beau Compton

Publications and source records attributed to Beau Compton.

5 records
All sourcesNASA NTRSDOE OSTI
NASA NTRSDate not supplied

An Experimental Study on Low Pressure Frost Formation for Lunar Polar Water Capture

In-situ resource utilization (ISRU) is a vital component of NASA’s mission to the Moon and beyond, as the extraction of resources from the environment can reduce payload weight and the frequency of resupply missions. Since the discovery of water in the regolith of the permanently shadowed regions (PSR) of the Moon, its extraction and transport has become an area of increasing interest for NASA. One proposed method is heating icy regolith to free the water before de-sublimating and transporting it as ice in a tanker. However, little is known regarding the dynamics of frost growth at low pressures, and an understanding of the heat transfer process is required to properly size the heat exchanger for the tanker. To investigate this phenomenon, a cold plate was placed in a vacuum chamber with water vapor directed at its surface. The chamber pressure (300 and 500 Pa) and cold plate temperature (–18 to –5 °C) were kept below the triple point and varied throughout the experiment to examine their impact on frost layer heat transfer. As water flowed into the chamber and deposited on the cold plate surface, the heat flux and temperature were measured along with the frost layer thickness and/or mass. Density calculated at the conclusion of each test suggests the frost layer is denser than that of frost grown at atmospheric pressure. The results demonstrate unexpected density and heat transfer characteristics and require development of a new model of frost growth for lunar conditions

Lunar polar↗
NASA NTRSDate not supplied

Experimental Results of a Rapidly Cycled Temperature Swing Adsorption Pump in a Terrestrial Environment

To improve the increasing CO 2 levels on Earth, technology for carbon capture and utilization must be efficient and cost effective. One major contributor of atmospheric CO 2 is post-combustion flue gas, which can contain up to 20% CO 2 . Scrubbing this CO 2 could reduce the environmental impact of this common industrial process. In off-Earth environments, capturing and utilizing CO 2 from space resources is useful for crewed spaceflight life support. Specifically, the Bosch process, which produces water and carbon powder by reacting CO 2 and hydrogen, is a possible in-situ resource utilization (ISRU) architecture for the Moon and Mars. The Rapid Cycle Temperature Swing Adsorption (RC-TSA) pump is an innovative technology designed to capture CO 2 efficiently. The RC-TSA leverages a stacked plate geometry to cycle multiple zeolite-coated beds. The thin layers allow for rapid heat transfer of the zeolite coating, which improves performance over previously tested pump designs. The design is favorable for scalability and manufacturability, which are forward work. Initial testing of the sorption pump using a simulated flue gas environment shows favorable breakthrough capacities and reduced cycle times. Results show promise for on- and off-Earth applications, such as a Martian surface and crewed spaceflight environments.

adsorption pump↗
NASA NTRSDate not supplied

Developments of Bosch Process Architectures for ISRU Terrestrial Applications

To effectively realize NASA’s goals of a sustainable presence on the Moon and be-yond, In-Situ Resource Utilization (ISRU) must be leveraged. To reduce launch mass for space missions, commodities such as oxygen and carbon can be produced in-situ. Oxygen can be used for life support and as a propellant, and carbon can be used for battery production, filtration, additive manufacturing, and steel casting. Carbon is a required reactant in the carbothermal reduction process, a leading candidate for oxygen production on the lunar surface. To pro-duce these consumables, the Carbon Utilization Technology for Lunar and Atmospheric Systems (CUTLAS) project is developing architectures that leverage the Bosch process. The Bosch process re-acts CO 2 and H 2 to produce carbon powder and water, which can then be electrolyzed, leaving O 2 and recycled H 2 . This process is also applicable to carbon dioxide emissions on Earth.

Carbon capture↗
NASA NTRSDate not supplied

Fundamental Research to Enable In-Situ Resource Utilization for NASA’s Artemis Program and Beyond Taking Place at The Glenn Research Center

In Situ Resource Utilization (ISRU) is regarded by many to be the key to future sustainability in space. The National Aeronautics & Space Administration’s (NASA) Space Technology Mission Directorate (STMD) recently published a list of ranked technology shortfalls. ISRU specific capabilities of ‘Extraction and separation of water from extraterrestrial surface material’, ‘Extraction and separation of oxygen from extraterrestrial surface material’, and ‘Produce propellants and mission consumables from extracted in-situ resources’ are within the top 80 shortfalls identified. A team of researchers and engineers at NASA’s Glenn Research Center (GRC) in Cleveland, Ohio, are performing fundamental research and technology maturation to ensure concepts and technologies are ready to support when the mission architecture is primed for ISRU to activate. Through analytical modeling and initial lab-scale testing, researchers are establishing concepts that mature to more sophisticated tests in relevant environments. Numerous studies are underway assessing fundamental behaviors of regolith during various steps of a conceptual ISRU production plant. This paper shares some of GRC’s recent advancements in ISRU research and technology development, in the hopes of providing valuable information to the ISRU community at large, spark ideas for future collaborative endeavors, as well as spur interest in utilizing some of the world-class expertise and facilities GRC has to offer.

ISRU↗