Engineering topics
Publications and source records attributed to Becker, Kathleen.
Surface photovoltage spectroscopy measures the contribution of solution-processed hole transport layers to the photovoltage of GaP solar cells.
The photocatalytic overall water splitting reaction provides a pathway to hydrogen fuel from sunlight. Photocatalysts must achieve the reaction without the application of an external bias, which requires an effective charge separation mechanism. Photolabeling studies and electrostatic simulations for the well-known CoOOH/Al:SrTiO 3 /Rh/Cr 2 O 3 photocatalyst suggest that charge separation is driven by work function differences at the (100) and (110) facets of SrTiO 3 , which are electron and hole selective, respectively. Here we use hydrogen annealed SrTiO 3–x single crystals to obtain the first quantitative assessment of the charge separation ability of the (100), or (110), or (111) facets during oxygen evolution. Under UV illumination (60 mW cm –2 ), the crystals exhibit variable water oxidation photocurrents (0.34, 0.82, 1.36 mA cm –2 at 1.23 V versus RHE) and photovoltage values of 1.40, 1.52 and 1.52 V for (100), (110), and (111) SrTiO 3–x , respectively. A surface photovoltage increase in that same order (0.31 V < 0.57 V < 0.67 V) is confirmed independently with vibrating Kelvin probe surface photovoltage spectroscopy (VKP-SPV) under 375 nm (1.91 mW cm –2 ) illumination. Mott Schottky measurements in aqueous K 3/4 [Fe(CN) 6 ] reveal facet-dependent flatband positions of –0.58, –0.71, and –0.74 V RHE for the (100), (110), and (111) crystals respectively. This confirms that the photoelectrochemical water oxidation performance of SrTiO 3–x crystals is controlled by the work function of each facet, which determines the electron transfer barrier height of the respective solid–liquid junctions. After correcting for differences in electron donor concentrations, barriers are found to increase in the order (100) < (111) < (110) and differ by as much as 0.16 eV, similar to an earlier prediction. Altogehter, these results explain the charge separation mechanism in SrTiO 3 photocatalysts and highlight the need for faceted semiconductor crystals as light absorbers in particle-based photocatalysts.
Not Available
Achieving NASAs aggressive fuel burn and emission reduction for N-plus-3 aircraft will require hybrid electric propulsion system in which electric motors driven by either power generated from turbine or energy storage system will power the fan for propulsion. Motors designed for hybrid electric aircraft are expected to operate at medium to high voltages over long durations in a high altitude service environment. Such conditions have driven research toward the development of wire insulation with improved mechanical strength, thermal stability and increased breakdown voltage. The silicone class of materials has been considered for electric wire insulation due to its inherent thermal stability, dielectric strength and mechanical integrity. This paper evaluates the dependence of these properties on the cure conditions of a polydimethyl-siloxane (PDMS) elastomer; where both cure temperature and base-to-catalyst ratio were varied. The PDMS elastomer was evaluated as a bulk material and an impregnation matrix within a lightweight glass veil support. The E-glass support was selected for mechanical stiffness and dielectric strength. This work has shown a correlation between cure conditions and material physical properties. Tensile strength increased with cure temperature whereas breakdown voltage tended to be independent of process variations. The results will be used to direct material formulation based on specific insulation requirements.