Search NASA⌕ Search

Engineering topics

Behm, K.

Publications and source records attributed to Behm, K..

Demonstration of femtosecond broadband X-rays from laser wakefield acceleration as a source for pump-probe X-ray absorption studies

Here, we present X-ray absorption measurements near the K-edge of laser heated aluminum in a pump-probe configuration using X-rays generated in a laser wakefield accelerator. A 30 fs duration laser pulse from the Hercules laser system was split into two beamlines, with one used to heat a 4 $μ$m thickness Al foil and the second to drive a laser wakefield accelerator. The laser-heated plasma was probed at various pump- probe delays using the femtosecond duration X-rays generated by betatron oscillations of the electrons in the wakefield. We observe an apparent blue-shift of the K-edge occurring on a sub-picosecond timescale in the transmission spectra.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Multi-electron beam generation using co-propagating, parallel laser beams

High intensity short pulse laser plasma interaction experiments were performed to investigate laser wakefield acceleration (LWFA) in the 'bubble' regime. Using a specially designed phase plate, two high intensity laser focal spots were generated adjacent to each other with a transverse spacing of 70 μm and were focused onto a low density plasma target. We found that this configuration generated two simultaneous relativistic electron beams from LWFA (with low divergence) and that these beams often interact strongly with each other for longer propagation distances in the plasma thus reducing beam quality. In addition, it was observed that the existence of an adjacent laser driven wakefield significantly reduced the self-trapping threshold for injection of electrons. Numerical modeling of these interactions demonstrated similar phenomena and also showed that electron beam properties can be affected through precise control of the phase and polarization of the incident laser beam.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Measurements of high-energy radiation generation from laser-wakefield accelerated electron beams

Using high-energy (∼0.5 GeV) electron beams generated by laser wakefield acceleration (LWFA), bremsstrahlung radiation was created by interacting these beams with various solid targets. Secondary processes generate high-energy electrons, positrons, and neutrons, which can be measured shot-to-shot using magnetic spectrometers, short half-life activation, and Compton scattering. Presented here are proof-of-principle results from a high-resolution, high-energy gamma-ray spectrometer capable of single-shot operation, and high repetition rate activation diagnostics. We describe the techniques used in these measurements and their potential applications in diagnosing LWFA electron beams and measuring high-energy radiation from laser-plasma interactions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Improvements to laser wakefield accelerated electron beam stability, divergence, and energy spread using three-dimensional printed two-stage gas cell targets

High intensity, short pulse lasers can be used to accelerate electrons to ultra-relativistic energies via laser wakefield acceleration (LWFA) [T. Tajima and J. M. Dawson, Phys. Rev. Lett. 43, 267 (1979)]. Recently, it was shown that separating the injection and acceleration processes into two distinct stages could prove beneficial in obtaining stable, high energy electron beams [Gonsalves et al., Nat. Phys. 7, 862 (2011); Liu et al., Phys. Rev. Lett. 107, 035001 (2011); Pollock et al., Phys. Rev. Lett. 107, 045001 (2011)]. Here, we use a stereolithography based 3D printer to produce two-stage gas targets for LWFA experiments on the HERCULES laser system at the University of Michigan. We demonstrate substantial improvements to the divergence, pointing stability, and energy spread of a laser wakefield accelerated electron beam compared with a single-stage gas cell or gas jet target.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗