Engineering topics

Benmore, Chris J.

Publications and source records attributed to Benmore, Chris J..

11 records

DOE OSTI2025

AUTOIGNITION DELAY TIMES FOR REFORMATE GAS MIXTURES FROM METHANE GAS ENGINES

Methane slip is a prominent issue in natural gas reciprocating engines that are used in transportation and marine applications. The incomplete combustion that results in methane slip can be resolved with the introduction of hydrogen within the combustion mixture to improve methane oxidation and further enable combustion within the engine crevices where methane has previously remained unreacted. Steam methane reforming (SMR) is a common method used to produce hydrogen and can be used to design an onboard device to reduce methane slip from reciprocating engines. The development of this reformer device requires the validation of high-fidelity chemical kinetic models at the low temperatures of the crevice volumes of these engines. In this work, auto-ignition data is obtained using a shock tube at lean (φ—0.714 or λ—1.4) and stoichiometric (φ, λ = 1) equivalence ratios spanning a temperature range of 1042–1234 K at the 80-bar operating pressure of the test engine. Blends of methane, hydrogen, and reformate products from the SMR reaction are shock-heated in synthetic air, with the ignition delay time measured using an OH* chemiluminescence detector at 310 nm and a CH* detector at 430 nm. The experimental results are compared to several state-of-the-art chemical kinetic mechanisms from the literature. In general, most of the mechanisms show very good agreement with experiments at higher temperatures, with simulation results showing little deviation from experiments at lower temperatures. A sensitivity analysis was conducted, and the results reveal that the reaction H2 + CH3O2 = H + CH3O2H has a very significant role in determining low-temperature ignition delay times (IDTs) of SMR mixtures. These findings provide valuable insights into the chemical kinetics governing methane reformate combustion and contribute to the optimization of onboard reformer designs aimed at mitigating methane slip in natural gas-fueled engines.

Fraze, Matthew↗

DOE OSTI2024

Detecting underscreening and generalized Kirkwood transitions in aqueous electrolytes

We establish the connection between the measured small angle x-ray scattering signal and the charge–charge correlations underlying Kirkwood transitions (KTs) in 1:1, 2:1, and 3:1 aqueous electrolytes. These measurements allow us to obtain underscreening lengths for bulk electrolytes independently verified by theory and simulations. Furthermore, we generalize the concept of KTs beyond those theoretically predicted for 1:1 electrolytes, which involves the inverse screening length, a 0 , and the inverse periodicity length, Q 0 . Above the KTs, we find a universal scaling of a 0 ∝ c – $\sqrt{ζ/3}$ and Q 0 ∝ c 1/3 for the studied electrolyte solutions, where ζ is the ionic strength factor.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2024

Evidence of short chains in liquid sulfur

High energy x-ray pair distribution function measurements show the average coordination number of the first shell in liquid sulfur is 1.86 ± 0.04 across the λ-transition, not precisely 2.0 as widely accepted. This indicates that upon melting, liquid sulfur does not comprise solely of S 8 rings but also possesses a significant number of short chains. Intensities of the pre-peak and first diffraction peak of the x-ray structure factor and third peak height of the pair distribution function all show deviations at the λ-transition temperature T λ , associated with the break-up of S 8 rings and the start of oligomer polymerization. A significant number of non-bonded or loosely bonded “interstitial atoms,” with an average coordination number of 0.20 ± 0.005, are also observed in the so-called “forbidden zone” between the first and second shells upon melting. The number of interstitial atoms is found to decrease to a minimum at the λ-transition, but the majority persist into the high temperature polymerized liquid. Furthermore, the existence of short chains and nearby interstitial atoms represent the two main factors required to initiate the S 8 -ring to chain transition, as proposed by recent molecular dynamics simulations.

Chemical bonding↗

DOE OSTI2024

Rigidity‐Driven Structural Isomers in the NaCl–Ga 2 S 3 System: Implications for Energy Storage

Alternative energy sources require the search for innovative materials with promising functionalities. Systems with unusual chemical properties represent an insufficiently explored domain, concealing unexpected features. Using diffraction and Raman spectroscopy over a wide temperature range, supported by first‐principles simulations, a rare phenomenon is unveiled: phase‐dependent chemical interactions between binary components in the NaCl–Ga 2 S 3 system. In this unique occurrence, previously intact binary crystalline species transform upon melting into mixed liquid structural isomers, forming bonds with new partners. The chemical combinatorics appears to be fully reversible for stable crystals and liquids. Despite this, rapidly frozen glasses out of thermodynamic equilibrium remain in a metastable isomeric state, offering remarkable properties, particularly a high room‐temperature Na + conductivity, comparable to the best sodium halide superionic conductors and therefore encouraging for sodium solid‐state batteries and energy applications. A rigidity paradigm is responsible for the observed phenomenon, as the extremely constrained Ga 2 S 3 crystal lattice does not survive viscous flow, breaking up at a short‐range level. The removal of rigidity constraints and dense packing leads to a significant increase in empty space, which is the origin of high sodium diffusivity. Broadly, the rigidity‐driven structural isomerism opens up an inspiring path to the discovery of atypical materials.

25 ENERGY STORAGE↗

DOE OSTI2024

The structure of CaO–MgO–Al 2 O 3 –SiO 2 melts and glasses doped with FeO X –NiO

Neutron and x-ray diffraction measurements have been performed on CaO–MgO–Al 2 O 3 –SiO 2 (CMAS) glasses doped with NiO–Fe X O at room temperature, along with x-ray measurements on aerodynamically levitated liquids at ≥2000 K. The disordered structures have been modeled using empirical potential structure refinement to investigate the relation between the aluminosilicate network and the modifying cations. The SiO 4 and AlO 4 tetrahedra are found to have wider Si–O and Al–O bond distance distributions in the glass, and the first Ca–O n coordination shell is highly distorted, redistributing different populations of long and short bonds between the liquid and the glass. The addition of Fe and Ni at low aluminosilicate content increases the number of free oxygens not bonded to AlO 4 or SiO 4 . Mg–O and Fe–O are both found to be predominantly fourfold and fivefold in the liquid and glassy states. Despite these low coordination numbers, their bond angle distributions indicate that they are predominantly in nontetrahedral-type geometries, with ferrous and ferric iron possessing similar coordination environments. The Ca–O and Mg–O average coordination numbers and enthalpies of solution are consistent with their higher reactivity within relatively acidic aluminosilicate melts.

36 MATERIALS SCIENCE↗

DOE OSTI2024

Microgravity effects on nonequilibrium melt processing of neodymium titanate: thermophysical properties, atomic structure, glass formation and crystallization

The relationships between materials processing and structure can vary between terrestrial and reduced gravity environments. As one case study, we compare the nonequilibrium melt processing of a rare-earth titanate, nominally 83TiO 2 -17Nd 2 O 3 , and the structure of its glassy and crystalline products. Density and thermal expansion for the liquid, supercooled liquid, and glass are measured over 300–1850 °C using the Electrostatic Levitation Furnace (ELF) in microgravity, and two replicate density measurements were reproducible to within 0.4%. Cooling rates in ELF are 40–110 °C s -1 lower than those in a terrestrial aerodynamic levitator due to the absence of forced convection. X-ray/neutron total scattering and Raman spectroscopy indicate that glasses processed on Earth and in microgravity exhibit similar atomic structures, with only subtle differences that are consistent with compositional variations of ~2 mol. % Nd 2 O 3 . The glass atomic network contains a mixture of corner- and edge-sharing Ti-O polyhedra, and the fraction of edge-sharing arrangements decreases with increasing Nd 2 O 3 content. X-ray tomography and electron microscopy of crystalline products reveal substantial differences in microstructure, grain size, and crystalline phases, which arise from differences in the melt processes.

36 MATERIALS SCIENCE↗

DOE OSTI2024

Atomic Structure and Dynamics of Unusual and Wide-Gap Phase-Change Chalcogenides: A GeTe 2 Case

Brain-inspired computing, reconfigurable optical metamaterials, photonic tensor cores, and many other advanced applications require next-generation phase-change materials (PCMs) with better energy efficiency and a wider thermal and spectral range for reliable operations. Germanium ditelluride (GeTe 2 ), with higher thermal stability and a larger bandgap compared to current benchmark PCMs, appears promising for THz metasurfaces and the controlled crystallization of atomically thin 2D materials. Using high-energy X-Ray diffraction supported by first-principles simulation, the atomic structure in semiconducting pulsed laser deposition films and metallic high-temperature liquids is investigated. The results suggest that the structural and chemical metastability of GeTe 2 , leading to disproportionation into GeTe and Te, is related to high internal pressure during a semiconductor–metal transition, presumably occurring in the supercooled melt. Similar phenomena are expected for canonical GeS 2 and GeSe 2 under high temperatures and pressures.

74 ATOMIC AND MOLECULAR PHYSICS↗

DOE OSTI2023

Probing lead acetate in solution using X-ray diffraction

Here, for the purpose of water purification involving toxic metal sensing and removal, high energy X-ray diffraction experiments have been performed on lead acetate Pb(Ac) 2 solutions, liquid and amorphous glutathione disulfide (GSSG), and their mixtures. The data have been interpreted using Empirical Potential Structure Refinement and pair distribution function analysis. At the highest concentration of 1 M Pb(Ac) 2 in water, the lead molecules are found to cluster and the second shell in the water structure becomes slightly more ordered as the water molecules become compressed. Liquid and amorphous GSSG are found to hydrogen bond primarily via OH-O interactions, while NH-O bonds are much more distorted. Aqueous solutions of Pb(Ac) 2 + GSSG show the closest Pb-O (carboxyl) and Pb-N (amine) bonds both at a distance of 2.5 ± 0.1 Å at a concentration of 1 M Pb(Ac) 2 in water. At 0.75 M Pb(Ac) 2 in water, strong Pb-S bonds are found at a distance of 2.8 ± 0.1 Å. The implications for lead removal using capacitive deionization are discussed.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2023

Probing Molecular Packing of Amorphous Pharmaceutical Solids Using X-ray Atomic Pair Distribution Function and Solid-State NMR

The structural investigation of amorphous pharmaceuticals is of paramount importance in comprehending their physicochemical stability. However, it has remained a relatively underexplored realm primarily due to the limited availability of high-resolution analytical tools. Here in this study, we utilized the combined power of X-ray pair distribution functions (PDFs) and solid-state nuclear magnetic resonance (ssNMR) techniques to probe the molecular packing of amorphous posaconazole and its amorphous solid dispersion at the molecular level. Leveraging synchrotron X-ray PDF data and employing the empirical potential structure refinement (EPSR) methodology, we unraveled the existence of a rigid conformation and discerned short-range intermolecular C–F contacts within amorphous posaconazole. Encouragingly, our ssNMR 19 F– 13 C distance measurements offered corroborative evidence supporting these findings. Furthermore, employing principal component analysis on the X-ray PDF and ssNMR data sets enabled us to gain invaluable insights into the chemical nature of the intermolecular interactions governing the drug–polymer interplay. These outcomes not only furnish crucial structural insights facilitating the comprehension of the underlying mechanisms governing the physicochemical stability but also underscore the efficacy of synergistically harnessing X-ray PDF and ssNMR techniques, complemented by robust modeling strategies, to achieve a high-resolution exploration of amorphous structures.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2023

Molecular interactions in short-chain perfluoroalkyl carboxylic acids and aqueous solutions

The presence of short-chain per- and polyfluoroalkyl substances in water poses a major health and environmental challenge. Here, we have performed high-energy small- and wide-angle X-ray scattering measurements on CF 3 [CF 2 ] n COOH (where n = 1, 2, 3 represents the chain length) and their aqueous solutions at 10% mole concentrations to characterize their molecular interactions at the atomic and nanometer length scales. The experimental wide-angle structure factors have been modelled using Empirical Potential Structural Refinement. The oxygen–oxygen partial X-ray pair distribution functions show that the coordination number between the hydroxyl oxygen on the acid and surrounding oxygen water molecules increases significantly with acid chain length, rising from 3.2 for n = 1 to 4.1 for n = 3. The small-angle scattering is dominated by a sharp, high-intensity peak at Q 1 ~ 0.2 Å -1 and a smaller peak at Q 2 = 1.2 Å -1 for n = 3, both of which decrease with decreasing chain length. The Q 2 peak is attributed to groups of adjacent non-bonded acid molecules, and Q 1 has contributions from both correlations between acid molecules and water–water interactions. In all cases, the models show nanoscale aggregation occurs in the form of denser channels of winding hydrogen-bonded chains, approximately 20 water molecules in length, surrounding clusters of acid molecules.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2023

The structure of molten calcium ferrite under various redox conditions

Laser-heated melts based on the 43CaO–57Fe 2 O 3-x eutectic, close to the calcium ferrite (CF) composition, were measured with high-energy X-ray diffraction using aerodynamic levitation over a range of redox states controlled by CO/CO 2 gas atmospheres. The iron–oxygen coordination number was found to rise from 4.4 ± 0.3 at 15% Fe 3+ to 5.3 ± 0.3 at 87% Fe 3+ . Empirical potential structure refinement modelling was used to obtain the ferric and ferrous partial pair distribution functions. It was found that the Fe 2+ iron–oxygen coordination number is consistently approximately 10% higher in CF than in pure iron oxide, while Fe 3+ is essentially identical in all but the most oxygen-rich environments (where it is higher in CF compared with FeO x ). The model also shows calcium octahedra to be the dominant species across all redox environments, although the population of CaO 7 increases with the availability of oxygen at the expense of CaO 4 and CaO 5 .

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗